Question about 2004 Chevrolet Malibu

Open Question

Chevy malibu lights keep going out

Front marker and blinking lights keep going out. They don't burn out, but base gets charred. It seems they are getting to hot and either get loose or warp. Tried replacing with LED so they burn cooler but they burned out in 2 months. Checked alternator output voltage and it is fine.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: How to replace headlight on a 2003 Chevy Tracker

There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.


Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

Posted on Oct 02, 2008

Ad
  • 373 Answers

SOURCE: 2003 chevy cavalier burning out ignition modules

what about replacing the plug wires and cap and rotor

Posted on Feb 07, 2009

inhisname
  • 76 Answers

SOURCE: Turn signals on '95 Chevy Lumina won't blink, relay & fuse are ok

hello......this sounds like a flasher for sure! it is cheap and easy too replace.....FLASHER is located under driver's side dash.......round shape, with 2-3 wires connected at 90 degree angle to flasher, good luck

Posted on Jun 04, 2009

  • 2 Answers

SOURCE: 2003 MALIBU AIR CONDITIONER

Love mine too. I had the same prob with the a/c...found a fix online where you take the switch panel out, take it apart, clean the contacts with alcohol and then write on them with a #2 pencil (coat them with the lead) and then reassemble and it worked like a charm for me. Mine started to do it again this year, but it at the end of summer and I didn't get around to doing it again, but will before I need the a/c again. And time again for front brakes and rotors for me! 85k and going strong!

Posted on Dec 12, 2009

redds55
  • 2620 Answers

SOURCE: 2003 Chevy S10 Brake lights

OK try this, push and hold brake then push on the hazard switch if brake lights come on then replace the turn signal switch.

Posted on May 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Chevy Malibu, I'm not sure what I


fuel issue? check all fuses first then check your fuel pump filter. disconnect the power cable from battery for 30 min then plug back up and try that should fix it based off the info you just gave

Oct 24, 2012 | Cars & Trucks

1 Answer

2003 Jeep liberty right front turn signal


why skip RR lamp? what does IT DO? be like 1st 1st look.
dim, out, fast?

the rapid is talking to you
it means current is wrong,
shorted, or open lines. to the right.
its the wiring
if the bulbs are like 1157 brass base bulbs
why not replace them first , they can short inside,
asking online for guessing is silly, why listen to 10 examples for this.
but is cut wires.
shorted wires.
keep i mind the blinker asks funny for both opens and shorts
its a feature, that.
low current or too much.

the acid test is connect 2 TEST bulbs in parallel to the multi-function switch output right side,
blinks ok now, bingo bad lamps or bad wiring, from there to the right side.

if the hazard fails you never said????
if rigth front is dim or dead the bulb is blown or shorted
if new bulb there , then the wires are shorted.
to it.
the only help on line worth squat is how to test and use your meter.
you can, check for voltage
you can check continuity on that line (its just 1 wire)
and check for shorts on that wire to ground (lamps pulled right side to do that, lamps read 0 ohms cold)
look for collision damage RF? behind lamp sockets?
be first.
in my book.
looking is always first. sure.


I have your SM book open now, chapter 8w-50
the haz/blink module has just 2 pins, left and right out.
pin 3 on the module runs front and rear blinks, (a fact to know)
RF is BR/RD, brown -red stripe?
all comments USA on USA forum. USA car.
ok?

the right side lamp (sidemaker) only blinks turns if parks ARE oFF

Id try 2 new blinker lamps front and 1 rear.
that be first. or test the lamp on a battery , and no not get burned fingers hot wring a shorted lamp.

wish i knew
what rear did
and what both did on HAZ
out, dim or to fast.

Mar 23, 2017 | 2003 Jeep Liberty

1 Answer

03 chevy venture rt.front parking light&turn light don't work replace bulb&socket


The rapid flashing occurs because of the light problem. If the 20A PARK LP fuse in the underhood fuse block is OK, the front marker lamps and the park lights should turn on when you set the headlamp switch to PARK. If the 10A T/SIG fuse in the instrument panel fuse block is OK, and the ignition switch is on, moving the turn signal multi-function switch to signal a right or left turn should cause the turn signals to flash. If this doesn't happen, check for a missing ground connection to the socket you replaced and check to be sure the replacement lamp was not forced into the socket backwards (it happens).

Sep 17, 2012 | 2003 Chevrolet Venture Passanger

1 Answer

My 2005 chevy malibu classic keeps stalling/shutting down


you might have a short circuit in your car, or a loose cable somewhere, I don't think the car is overheating, I think that the temperature sensor (commonly screwed to the engine by a water return hose) is not working well, probably the bimetalic material is all wear out, you might consider change it.

Jul 26, 2012 | 2005 Chevrolet Malibu

2 Answers

Subaru outback wagon tail light not working off


There are several components of your 1997 Subaru Outback that can cause your tail lights to stop functioning correctly. To help pinpoint the cause of the problem, it would be very helpful to also check your front marker lights. If the marker lights are working, then we know that the problem is not the headlamp switch or the tail and illumination relay (located in the fuse and relay box).

The components to check are:

> Fuse #23 (20 Amp) in the Main Fuse Box.
> Fuse #5 (10 Amp) in the Fuse and Relay Box
> Tail And Illumination Relay
> Headlamp Switch

May 06, 2012 | 1997 Subaru Outback

3 Answers

1999 chevy malibu taillights dont come on...any ideas?


First check tail light fuse and the parking light relay

Jan 25, 2012 | 1999 Chevrolet Malibu

8 Answers

2005 Chevy Aveo LS Dashboard lights won't come on


The problems stated above seem to be caused by SP101 (specifically contact #1) being burned and contact 3 (dash lights), and contacts 2, 4, & 5 not receiving power. SP101 is located inside the fuse box under the hood. It is a white, 20 pin connector that splices wires internally. Either replace the connector and the purple/white wire, or solder/splice the wires together and solder or crimp. I don't know if the dealer sells the splice, I'm looking into that because I need it. I don't know why this splice malfunctions and the left side (identical) doesn't. Unfortunately, this is common in the Aveo and the dealer mechanics seem to be totally clueless!

Oct 07, 2008 | 2005 Chevrolet Aveo

1 Answer

Front parking/side marker lights


Replace bulb, it has 2 filaments, one is probably burned out.

Sep 10, 2008 | 1996 Jeep Cherokee Sport

Not finding what you are looking for?
2004 Chevrolet Malibu Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...