Question about Nissan Cars & Trucks

Open Question

How to take a glovebox out of 1995 nissan pickup

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
old marine
  • 2016 Answers

SOURCE: troubleshooting air conditioner thermostat 1995 nissan pickup hardbody

The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!

Posted on Jul 25, 2008

Ad
  • 2 Answers

SOURCE: 1995 NISSAN PICKUP WHEN STOPPING GOES DEAD. IDLE

Have you tried cleaning the throttle body?

Posted on Apr 28, 2009

  • 1 Answer

SOURCE: How do you remove the door panel of a 1995 Nissan XE Pickup

Not sure about the 95, but to remove it on my 94 i just pulled on once corner till the fastener poped out, then worked slowly around removing each fastener. Be careful as the the door pannel is quite flimsy but if the 95 is the same as the 94 it should be fairly easy to remove.

Posted on May 21, 2009

czaa
  • 4536 Answers

SOURCE: 1995 nissan pickup 4 cylinder timing chain - 256k miles

did u recently buy it used-mite of been already done--how r the other components enginewise-its an old car n theyll be more things--but if u luv it then get a haynes repair manual at the zone

Posted on Dec 30, 2009

  • 110 Answers

SOURCE: how do you bleed cooling system for 1995 nissan pickup truck

  1. Open radiator cap and air relief plug.
  2. Fill radiator with coolant to specified level.
  3. Close air relief plug.
  4. Run engine and bring to operating temperature.
  5. Race engine two or three times under no-load.
  6. Stop engine and let cool, then add coolant as necessary.

Posted on May 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to drain fuel tank on 1995 Nissan pickup


you need to drop and remove tank away from vechicle where you can drain it completely.

Mar 28, 2013 | 1995 Nissan Pickup

1 Answer

Noise behind glovebox


Remove the glovebox liner end check it out, There might be a mouse in the house,

Nov 11, 2012 | Nissan Cars & Trucks

1 Answer

Water in oil 1995 Nissan pickup


It sounds like you have either an intake gasket leak or a head gasket going bad. Did you check compression on all cylinders or just 1?

May 14, 2012 | 1995 Nissan Pickup

2 Answers

1995 Nissan pickup turns over but will not start.Removed the coil wire from the dist. cap and held it close to ground with no spark while cranking the engine.


then that reduces the possibilities to: bad coil ignition module malfunction distributor failure distributor cap and rotor

Jun 24, 2011 | 1995 Nissan Pickup

1 Answer

1995 nissan pickup throttle position sensor


ok on a 2.4l on the black/green and white wires use ohm meter and there is no specific spec for that engine just make sure the the resistance changes and there is no dead spots. for the 3.0l black and white wires specs are 1.0-9.0k ohms im guessing the specs are the same either engine. close to full open


Jul 13, 2010 | 1995 Nissan Pickup

1 Answer

How do you bleed cooling system for 1995 nissan pickup truck


  1. Open radiator cap and air relief plug.
  2. Fill radiator with coolant to specified level.
  3. Close air relief plug.
  4. Run engine and bring to operating temperature.
  5. Race engine two or three times under no-load.
  6. Stop engine and let cool, then add coolant as necessary.

May 10, 2010 | 1995 Nissan Pickup

1 Answer

1995 NISSAN PICKUP WHEN STOPPING GOES DEAD. IDLE


Have you tried cleaning the throttle body?

Apr 28, 2009 | 1991 Nissan Maxima

1 Answer

Troubleshooting air conditioner thermostat 1995 nissan pickup hardbody


The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!

Jun 25, 2008 | 1995 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...