Question about Cars & Trucks

Open Question

Where is crankshaft sensor located on 2001 6.0 chevy engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 218 Answers

SOURCE: the location of the cps on a 2001 ml430

IT IS IN THE REAR OF THE ENGINE WHERE IT MOUNTS TO THE TRANSMISSION.THE SENSOR READS THE NOTCHES ON THE FLYWHEEL.ABOUT A 1/2 HOUR JOB.

Posted on May 07, 2009

  • 135 Answers

SOURCE: Need to replace both crankshaft position sensors 2001 Cadillac

4.6 the twocrankshaft position sensors are located on the front of the block just above and to the left of the oil filter. not hard to replace.

Posted on May 19, 2009

ZJLimited
  • 17970 Answers

SOURCE: crankshaft position sensor location

1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block.

87c675c.jpg

Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship

Crankshaft Position (CKP) Sensor
A magnetic crankshaft sensor (Hall Effect switch) is used which is remotely mounted on the opposite side of the engine from the DIS/IC module. The sensor protrudes in to the engine block, within about 0.050 in. (1.27mm) of the crankshaft reluctor.

I really hope help you wuth this (rated this help). have a nice day, good luck.

Posted on Sep 25, 2009

Testimonial: "Awesome. Thanks."

roniecon
  • 6826 Answers

SOURCE: were is the crankshaft position sensor located on 2001 chevy mali

It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.

Posted on Mar 22, 2010

emissionwiz
  • 75817 Answers

SOURCE: crankshaft sensor location on 2001 oldsmobile

. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.

Posted on Jun 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the crank shaft position sensor on a 2001 chevy Tracker V6 Lt 2.5L


Get underneath the vehicle and look at where the engine joins the transmission case.

The crankshaft position sensor will be located on the bottom or side .. usually towards the bottom..

It will be held in place with either a screw or small bolt. Undo the screw/bolt and withdraw the sensor. It's a straightforward job.

Photo below is a generic image of crankshaft sensor:


26063149-yytlcu2b3evmxr44xdn3gosb-1-0.jpeg You'll see the electrical lead/connector. Just disconnect the connector and remove the retaning screw/bolt

Jan 21, 2016 | Cars & Trucks

1 Answer

Location of a crankshaft sensor for a 2001 chev malibu


http://www.chevymalibuforum.com/forums/showthread.php?t=11860

Oct 04, 2014 | 2001 Chevrolet Malibu

1 Answer

Where is the crank sensor located on a 2001 chevy suburban?


Hi Amy:
The CKP (Crankshaft Position) sensor is located on the bellhousing on 8.1L engines.

On 4.8L, 5.3L, 6.0L and 6.2L engines, it is located on the side of the engine block.

11_28_2011_6_21_01_pm.gif

Image Zooming Link: CKP Sensor - Key 8

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 28, 2011 | 2001 Chevrolet Suburban

2 Answers

Were is the crankshaft position sensor located on 2001 chevy mali


It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.

Mar 22, 2010 | Chevrolet Malibu Cars & Trucks

2 Answers

Where is the crankshaft sensor located on a 2001 chevy blazer 4.3L v6. The check engine code was crankshaft sensor and cyl #2 misfire.


If you have a distrubutor it is located in the side.Books says you have to turn the crank with a breaker bar to align the slots.Well hope this helps,and good lock.

Mar 14, 2010 | 2000 Chevrolet Blazer

2 Answers

Where is the crank sensor located on a chevy malibu 2001


It should be down near the crankshaft pulley. Remove the the right front wheel and the splash shield, it should be there next to the pulley.

Dec 20, 2009 | 2001 Chevrolet Malibu

1 Answer

My 2001 pontiac firebird check engine light is on ,it was diagnosed that the crankshaft sensor is defective. where is the sensor located ?


The crankshaft sonsor is located between the timing cover and the harmoinc balancer on the passenger side of the engine.

Oct 05, 2009 | 2001 Pontiac Firebird

1 Answer

Crankshaft position sensor location


1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block.

87c675c.jpg

Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship

Crankshaft Position (CKP) Sensor
A magnetic crankshaft sensor (Hall Effect switch) is used which is remotely mounted on the opposite side of the engine from the DIS/IC module. The sensor protrudes in to the engine block, within about 0.050 in. (1.27mm) of the crankshaft reluctor.

I really hope help you wuth this (rated this help). have a nice day, good luck.

Sep 25, 2009 | 1990 Chevrolet Cavalier

1 Answer

Crank Sesor Location?


Ck Front of engine around the crankshaft pully.

Sep 16, 2009 | 2001 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...