Question about Chevrolet Cars & Trucks
Go to tirerack.com & put ur make & model in. Then look up ur wheel sizes. It'll give you all that. I use it to buy my rims 4my Beretta
Posted on Oct 30, 2012
Standard tire size P205 / 70R15 OPTIONAL P235 / 70R15 OR P P235 / 75R 15
Posted on Oct 31, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
From what I found online, the 2wd version of the truck uses the size wheel you have (15x7). The offset for that vehicle is -6. For the 4wd version, the OEM wheel size is 16x8 and the offset is +50.
Posted on Oct 19, 2008
SOURCE: 2000 Chevy Blazer
i am working on a s 10 of the same yaer and problem i will post my results after tomorrow when i have finished the job i bout this truck cause of the forum i own one that is a great one and this one is for experimental purpose i will let u know so far you cant lift the motor with a jack or a hoist so we r going another route in the mornin
Posted on Dec 27, 2008
SOURCE: 2000 Blazer stuck in 4WD
The first thing I would look at is the shift rod on the transfer case. If I remember correctly, it is on the drivers side and is a rod aboutsix inches long and has two ends that basically pop into rubber gromets. If that rod is bent in any way, or has come loose of the gromets, it will not shift into or out of the four wheel drive. If yours has electronic four wheel drive, the electric acutator could be out or going out. you should be able to remove the rod and simply move the switch by hand on the transfer case. It will get you out of 4 wheel drive until you have the ime to diagnose the electronics at least. It has happened to both my 1994 and 1999 S-10 blazers.
Posted on Apr 21, 2009
I am sorry to tell you this, but you will have to take the Truck to a Rear End repair shop to do this. If you are very mechanically inclined and have all the specific tools like a slide hammer, bearing puller, bearing installation tool, etc. If you have tools like this, then I would get yourself the car manual. To replace the bearings you will have to remove the axles.
Posted on Oct 06, 2009
Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
Posted on Oct 07, 2009
Tips for a great answer:
Mar 14, 2015 | 2000 Chevrolet Blazer
Feb 02, 2013 | 1998 Chevrolet Blazer
Feb 12, 2011 | 2000 Chevrolet Blazer
Jun 02, 2010 | 2001 Chevrolet Blazer
Jan 05, 2010 | 2000 Chevrolet Blazer
Oct 07, 2009 | 2000 Chevrolet Blazer
180 people viewed this question
Usually answered in minutes!