Question about Toyota Cars & Trucks

Open Question

How to remove /replace fuel injectors on 1994 toyota pickup

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


SOURCE: 1994 Toyota Truck 22R Engine

Saw your post on another thread. I have the same truck. The fuel filter is located on the rail just below the passenger door. Its an easy one to remove,...couple bolts, but access to it is a pain.

Posted on Aug 11, 2008

  • 599 Answers

SOURCE: Remove and replace 1994 Toyota pickup starter

disconnect battery ..remove skid plate..remove battery/ignition wire from starter (2 nuts)..remove starter bolts(2 )

Posted on Nov 07, 2008

  • 4070 Answers

SOURCE: 1994 toyota pickup with 22re

HI! The other thing that controls the fuel is the PCM (powertrain control module). The PCM is like the car's brain that when it fails everything else's fail. The PCM has connectivity on all electrical current that runs inside the car including the engine and transmission. Hope this helps and thank you for using FixYa!

Posted on Aug 25, 2010

  • 4070 Answers

SOURCE: Do i need to pull the dash board out of my 1994

Hi and welcome to FixYa!
Yes you defnitely need to take out the instrument cluster to replace the bulb.

Hope this helps and thank you for using FixYa! Have a good one!

Posted on Jan 22, 2011

  • 1 Answer

SOURCE: 1994 toyota 22re 4x4 pickup fuel injector wiring diagram

I have a 94 toyota 4x4 with the 22re. When driving down the road with the lights on and the windshield wipers on, if i turn the high beams on the truck jerks. Also if ive got the windshield wipers on the voltage gauge moves left to right. When ive got the lights on and i press the brake it bogs while im sitting still just idling. Wat could be causing these problems?

Posted on Apr 27, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why when I push on gas pedal of 1994 Toyota pickup does it not rev up until I push it way down. Then it takes off like a big bird?

Check the throttle body cable, there should only be approx. 1/4" play in it, you may have a vacuum leak as well, check all hoses and make sure they are all tight. It could be fuel injector related (dirty/ clogged) the same applies to your throttle body.

Jan 31, 2015 | 1994 Toyota Pickup

1 Answer

1994 yoyota pickup will not start when cold

Its possible the check valve in the pump is allowing the fuel pressure to drain back into the tank when the engine is off.
Have you checked fuel pressure with a gauge before and after the first attempt ?

Feb 07, 2013 | 1994 Toyota Pickup

1 Answer

Sputtering 94 toyo 4 cylinder 2wd 22re pickup: have now replaced all plugs/wires/cap/rotor. after testing plugs they all are getting spark. did compression test and all four averaged 170 each. tried high...

remove the air cleaner tube, and clean the throttle body and plate , get the fuel pump pressure checked to make sure its supplying a constant pressure with no drop offs,

Sep 14, 2011 | 1994 Toyota Pickup

2 Answers

I have a 1994 toyota pickup 1/2 ton, and i have to press the gas pedal when i'm on stop light, because if not the engine goes off


Mar 01, 2011 | 1994 Toyota Pickup

1 Answer

94 toyota camery 4 cyl wont start Ichecked the fuel injectors there ok checked fuel pump works fine replace distributor cap and the ignitor but I dont get a spark at the sparkplugs.henrys

check all efi and ign fuses first...then check pickup coil and ignition coil in distributor w/ ohm meter...since you already replace the ignitor, then mostly likely it's the pickup coil or ignition the whole

Aug 22, 2010 | 1994 Toyota Camry

3 Answers

1994 Toyota pick up Truck will crank and fire, but has difficulty starting. Once it starts, it dies at idle at stop signs/lights.

i would check your idle air control valve. And you might want to take a look at your fuel injectors/ fuel filter. To check the IAC motor remove the unit, with the wires connected turn the key to the "on" position without starting the engine, the IAC should move in or out. If the IAC motor does nothing it has probably failed, replace it with a new unit and recheck system. Note: while the IAC motor is removed clean (use aerosol carburetor cleaner) the passages the IAC uses to control idle air speed.

Jul 06, 2009 | 1994 Toyota Pickup

1 Answer

1991 toyota 3L V6 Overfueling, raw fuel pouring out exhaust pipes

The valve cover gasket change is related only to the extent of needeing to remove something else . There is the fuel pressure regulator and the MAF SENSOR talks to the ECU telling the computer how much fuel is needed for proper mixture of thre air passing into the intake. It is the first sensor in the intake duct coming out of the sir filter. Make sure all the injectors are secure in wiring connection and look around for any other that had to be removed. All plugs mean it isn't just one injector. Unplug and replug the MAF. cHECK THE THROTTLE POSITIO SENSOT. iT RIGHT THERE where the fuel likage is attached.

Jun 02, 2009 | 1994 Toyota Pickup

2 Answers

Remove and replace 1994 Toyota pickup starter

disconnect battery ..remove skid plate..remove battery/ignition wire from starter (2 nuts)..remove starter bolts(2 )

Nov 07, 2008 | 1994 Toyota Pickup

4 Answers

1994 toyota 22re 4x4 pickup fuel injector wiring diagram

the color of the plastic plug does not matter... You will have two injector plugs with white/red and yellow wires - those two go to cyl#'s 1 and 3.
the other two plugs will have white and blur wires.. those two plugs go to injectors # 2 and 4.

Oct 09, 2008 | 1994 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides