Question about Cars & Trucks

1 Answer

2005 chrysler town and country Automatic temperature control unit does not heat

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 75,197 Answers

Air Temperature Control Blend Door Failure No Heat

In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a very expensive repair.

Posted on Oct 30, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: door locks

Daughter had same problem on '05 T&C. Neighborhood mechanic searched Internet and found 80-90 others with same problem right around 40,000 miles. Free solution was to pull yellow 20A IOD fuse in right front corner of fuse box under hood, wait 10 seconds, then reinsert fuse. Should solve problem as long as you don't lock doors with FOB. You can unlock doors with FOB, but apparently locking with FOB causes the problem.

Permanent solution is to have dealer reprogram computer for around $50 which is what my daughter chose to do because of inconvenience of not being able to lock doors with FOB when getting baby/carseat out of vehicle.

Posted on Dec 07, 2008

chryslertech
  • 115 Answers

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Posted on Mar 08, 2009

emissionwiz
  • 75197 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

  • 117 Answers

SOURCE: 2005 crank position sensor location

The crank shaft sensor on that model should be on the driver side towards the back of the tranny its not hard to get to.

Posted on Jun 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Automatic temperature control does not heat


Low coolant? You have a coolant leak,The coolant should not go low ,Inspect the waterpump,and hose,and have the system pressure tested.

Oct 30, 2012 | 2005 Chrysler Town & Country

1 Answer

Front blower stays on high, if I pull front blower relay it sounds like another blower starts blowing. If i turn switch to off the same blower starts as it did when i pulled relay


Open and remove the catch that holds the glove box. Behind the glove box you'll see the air duct system. Directly in front of you notice the part with screws holding it in place on the duct and wires plugged in. This is a control for the heating and A/C system. Depending on your type of system controls, (manual, you adjust temperature or automatic, you set digital temperature) you can replace this unit. Unplug the unit, remove screws and remove control unit. Take part to NAPA Auto Parts for a replacement part. They had the manual part about $25.00. Mine has the automatic controls and I had to go to dealer for replacement, mine cost about $65.00. This is easy to do and fixed my "out of control heating and A/C system".

Mar 02, 2010 | 2002 Chrysler Town & Country

1 Answer

Blower control will not turn off high town & country 2002


My 2002 T&C van did the same thing. Here is how I fixed it:

Open and remove the catch that holds the glove box. Behind the glove box you'll see the air duct system. Directly in front of you notice the part with screws holding it in place on the duct and wires plugged in. This is a control for the heating and A/C system. Depending on your type of system controls, (manual, you adjust temperature or automatic, you set digital temperature) you can replace this unit. Unplug the unit, remove screws and remove control unit. Take part to NAPA Auto Parts for a replacement part. They had the manual part about $25.00. Mine has the automatic controls and I had to go to dealer for replacement, mine cost about $65.00. This is easy to do and fixed my "out of control heating and A/C system".

Mar 01, 2010 | 2002 Chrysler Town & Country

1 Answer

2003 Town & Country - no heat or gauge movement


If the coolant level (antifreeze) level is low there may not be enough fluid in the system for the temperature sensor to register a proper reading ( think of it as holding an oral thermometer just outside of your mouth).

Insufficient fluid passing through the heater core (small fan that blows through a small heated radiator) may not be enough to produce heat.

However: At increased speeds the engine may be heating what little fluid there is to a point to supply heat to the heater core, and register on the temperature sensor.

Feb 28, 2010 | 2005 Chrysler Town & Country

1 Answer

Fan motor runs only on high. How to fix?


My 2002 T&C van did the same thing. I had to pull the fuse (in the engine compartment to even turn off the blower. Here is how I fixed the problem. It is easy to do:

Open and remove the catch that holds the glove box. Behind the glove box you'll see the air duct system. Directly in front of you notice the part with screws holding it in place on the duct and wires plugged in. This is a control for the heating and A/C system. Depending on your type of system controls, (manual, you adjust temperature or automatic, you set digital temperature) you can replace this unit. Unplug the unit, remove screws and remove control unit. Take part to NAPA Auto Parts for a replacement part. They had the manual part about $25.00. Mine has the automatic controls and I had to go to dealer for replacement, mine cost about $65.00. This is easy to do and fixed my "out of control heating and A/C system".

Feb 22, 2010 | 2002 Chrysler Town & Country

1 Answer

Why does my 2005 Town & Country radiator fan


The fan is computer controlled and will not come on untill it reaches 212Deg . It should come on though if you turn on the air conditioning, if not you could have a bad fan relay or relay plug.

Feb 22, 2010 | 2005 Chrysler Town & Country

1 Answer

The climate control is not working right. Temperature (heat) is sporadic...runs hot for a minute then goes cold.


The Town and Country temperature control is electronic and it sounds like the control board or panel has failed. It is sending mixed signals to the temperature control unit. Have it checked by a mechanic that you trust because this is potentially an expensive fix and could be worse if they are not 100% sure on how to diagnose these problems. Hope this helps, good luck!

Nov 26, 2009 | 2005 Chrysler Town & Country

1 Answer

2005 Town & Chrysler heat is not working properly


check the hoses going to the heater core. if there is an extreme temperature difference you may have a heater core plugging up

Jan 26, 2009 | 1996 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...