Question about Cars & Trucks

1 Answer

DOES THE JUNCTIION BLOCK ON 2008 HYUNDAI SANTA FE need to be replaced

No power from resitor to relay causing blower not to work. i was told that the junction block needs to be replaced

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 444 Answers

Get a new blower relay. That is located in the fuse block in the engine compart ment.

Posted on Oct 30, 2012

  • 3 more comments 
  • Andy Williford
    Andy Williford Oct 30, 2012

    the relay is on the circuit board and cannot be reached thus whole junction box must be replaced

  • Rocky Degelman Oct 31, 2012

    If it is true that the relay is on the circut board ,Then yes the whole juntion box has to be replaced, To save money get a used one from a auto wrecker,

  • Andy Williford
    Andy Williford Oct 31, 2012

    Thanks Rocky, I am in conversation with LKQ Salvage. Very Large used parts company.

  • Andy Williford
    Andy Williford Oct 31, 2012

    Rocky, is it hard to install?

  • Rocky Degelman Oct 31, 2012

    Aparently if it is the resistor ,It is located right on the blower motor from pictures of it on the internet, You have to remove the glove compartment liner, The relay should be in the fuse block in the engine compartment ,

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 566 Answers

SOURCE: 2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Posted on Oct 28, 2008

  • 5 Answers

SOURCE: Blower Motor

It's in the engine compartment on the passengers' side on the firewall.

Posted on Nov 29, 2008

  • 1 Answer

SOURCE: blower motor not working 1994 jeep cherokee

Sounds like your blower motor rheostat needs to be replaced. I'm about to replace mine for the second time. Fan just quits working altogether when the rheostat goes.

Posted on Dec 06, 2008

  • 1 Answer

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

Posted on Apr 06, 2009

  • 57 Answers

SOURCE: need instructions on removing hyundai santa fe 01 fan belt ac

its your serpentine belt (thats what its called) and you will need a 3/8 ratchet and then find the belt tensioner. The tensioner has a spot where you need to put the ratchet into and pull or push depending on whatever way and that will releive the pressure off the belt so you can take it off.

Posted on Apr 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blower switch only works on low speed on a 2004 hyundai santa fe


This condition can be caused by failure of the high blower relay, A/C control module, or associated components.

Jan 21, 2017 | Hyundai Santa Fe Cars & Trucks

Tip

What you need to know about Hyundai


I am a mechanic ..most people ask questions about these foreign hyundai motors ..below is an example of engines that basically if you ask about a Hyundai Xg 350 ,xg300 ..well allow me to hammer 90% of your questions in case you want to grab another motor ..these motors listed will work on 90% of all hyundai products ...Look at the starter sizes ,,all the same for the selected models ..then look at the motor sizes ..This will help you in solving some problems most do not give the specific questioning
100% NEW REPLACEMENT STARTER
FOR
STARTER

12 VOLT / CW ROTATION / 8 TOOTH DRIVE

REPLACES:
MANDO M62957
VALEO TM000A14401
BOSCH REMAN SR4118X
BOSCH NEWMAN SR4118N
HYUNDAI 36100-37210

FITS ON:

HYUNDAI
2001 SANTA FE 2.7L ENGINE
2002 SANTA FE 2.7L ENGINE
2003 SANTA FE 2.7L ENGINE
2004 SANTA FE 2.7L ENGINE
2005 SANTA FE 2.7L ENGINE
2006 SANTA FE 2.7L ENGINE

2003 SANTA FE 3.5L ENGINE
2004 SANTA FE 3.5L ENGINE
2005 SANTA FE 3.5L ENGINE
2006 SANTA FE 3.5L ENGINE

2002 SONATA 2.7L ENGINE
2003 SONATA 2.7L ENGINE
2004 SONATA 2.7L ENGINE
2005 SONATA 2.7L ENGINE

1999 SONATA 2.5L ENGINE
2000 SONATA 2.5L ENGINE
2001 SONATA 2.5L ENGINE

2003-2008 TIBURON 2.7L ENGINE

2005-2008 TUCSON 2.7L ENGINE

2001 XG300 3.0L ENGINE

2002 XG350 3.5L ENGINE
2003 XG350 3.5L ENGINE
2004 XG350 3.5L ENGINE
2005 XG350 3.5L ENGINE

KIA
2004 AMANTI 3.5L ENGINE
2005 AMANTI 3.5L ENGINE
2006 AMANTI 3.5L ENGINE

2001 MAGENTIS 2.5L ENGINE

2002-2006 MAGENTIS 2.7L ENGINE

2001 OPTIMA 2.5L ENGINE

2002 OPTIMA 2.7L ENGINE
2003 OPTIMA 2.7L ENGINE
2004 OPTIMA 2.7L ENGINE
2005 OPTIMA 2.7L ENGINE
2006 OPTIMA 2.7L ENGINE

2002-2005 SEDONA 3.5L ENGINE

2005 SPORTAGE 2.7L ENGINE
2006 SPORTAGE 2.7L ENGINE
2007 SPORTAGE 2.7L ENGINE
2008 SPORTAGE 2.7L ENGINE

on Oct 24, 2013 | Hyundai Cars & Trucks

1 Answer

Where is the blower resistor on a 2001 Hyundai Santa fe


if the blower resistor pack is separate it will be in the blower housing where the air flow can cool it
otherwise it will be in a control module which will need replacing

Jun 19, 2015 | 2001 Hyundai Santa Fe

1 Answer

Blower Motor only works on high and resistor changed


sounds like it's the switch; but it is important to see whether the fan spins freely or else the switch or resistor block will fail again. the most common reason for these failures is that the motor drags and pulls too many amps, thus overheating the connectors and wires.

Mar 21, 2013 | 2006 Hyundai Santa Fe

1 Answer

Ac doesnt work in 2002 hyundai santa fe the fan isnt blowing


have you checked the fuse,and relay if they are ok then remove the plug. with the fan turned on use a test light and see if you have power to any of the terminal end in the wire plug end . if you have power then the blower motor is bad

Jul 11, 2010 | 2002 Hyundai Santa Fe

2 Answers

Blower fan won't shut off its or climate control fan keeps running 2003 hyundai santa fe


Probably a stuck fan control relay.
Find the relay and remove it - if this stops the fan. replace the relay with a new one.

Aug 01, 2009 | 2002 Hyundai Santa Fe

1 Answer

2001 Hyundai Santa Fe 4 cylinder..air conditioner does not work, went to recharge refridgerant and it has pressure..low pressure valve is cold and air condtioner compresser kicks in when turned on but no...


check to see if you have power at the AC AND HEAT blower motor.if yes your blower motor is defective.if you have no power to blower motor look at fuse- blower relay-resistor or bad control switch.

Jun 23, 2009 | 2001 Hyundai Santa Fe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...