Question about 2000 Chevrolet Silverado

1 Answer

2000 chevy pick up died while driving and won't restart?

2000 chevy 3\4 ton 4wd standard cab 5.7 liter, auto-trans has spark at plugs, and 60psi fuel pressure at fuel rail,i have replaced the distrubtor pick up module,and plugs, but won't fire up. battery has been replaced and it cranks over just fine?

Posted by on

  • 1 more comment 
  • bwobbe Jan 04, 2009

    would I still be getting spark to the plugs if the crankshaft sensor is bad?

  • bwobbe Jan 06, 2009

    where is the crank sensor located on a 2000 chevy 5.7 liter, and is it hard to replace?

  • bwobbe Jan 07, 2009

    OK I FOUND THE CRANK ANGLE SENSOR AND REPLACED IT,

    STILL WON'T START, SO I REPLACED THE IGNITIION MODULE AND STILL NOTHING, I CHECKED TWO MORE PLUGS AND THERE WET WITH FUEL, AND I STILL HAVE SPARK. ANY IDEA'S BEFORE IT GET'S TOWED TO A GM SHOP?



×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Check the crank angle sensor

Posted on Jan 03, 2009

  • 1 more comment 
  • grayho2 Jan 06, 2009

    YES, THE PLUGS ARE ON A DIFFERENT CIRCUIT. THE COMPUTER CONTROLS THE SPARK TO THE PLUGS, NOT THE SENSOR. THIS SENSOR SENDS OUT A 0.5ma SIGNAL TO THE COMPUTER SAYING "IM TRYING TO START." IF THE SENSOR RECEIVES THE STARTING VOLTAGE BUT NOT SEND IT BACK, THE TRUCK WON'T START.

  • grayho2 Jan 06, 2009

    YES, THE PLUGS ARE ON A DIFFERENT CIRCUIT. THE COMPUTER CONTROLS THE SPARK TO THE PLUGS, NOT THE SENSOR. THIS SENSOR SENDS OUT A 0.5ma SIGNAL TO THE COMPUTER SAYING "IM TRYING TO START." IF THE SENSOR RECEIVES THE STARTING VOLTAGE BUT NOT SEND IT BACK, THE TRUCK WON'T START.

  • grayho2 Jan 07, 2009

    sounds like you know what you are doing. take it to the next level. ohm out the coil packs to see if they are good. also you can use a noid light, (which is used to see if the fuel injector harness has power,) to see if each coil pack has power when the key switch is turned on. you can use a scan tool to actuate the coil also. if it doesn't have individual coil packs, then check the coil harness and the harness for the distrubutor. and last but not least, check all fuses and relays.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many liters of 80/90 weight gear oil does my 1990 chevy c1500 take in the transmission?


Fill at side fill hole until fluid begins to run back out. Let it run until it stops, install plug and wipe up excess. If fully drained, usually holds less than 3 liters.

Sep 02, 2015 | 1994 Chevrolet C1500

1 Answer

89 chevy 3/4 ton. 2wd. 454. AT. truck runs good


check your timing, check that your ignition pick up coil is good. also check your fuel pressure. and check for any vacuum leaks. double check your coolant temp sensor to the ecm it tells the ecm what temp it is and the ecm adjusts the fuel amount accordingly.

Oct 14, 2013 | 1989 Chevrolet C1500

1 Answer

Firing order for and diagram for a 5.9 4wd 2000 dakota


I was surprised to find Dodge still using a distributor on this engine.
The firing order is 1-8-4-3-6-5-7-2 and the cylinders on the driver side are 1-3-5-7.

f17236a.gif

Sep 05, 2012 | 2000 Dodge Dakota Quad Cab

1 Answer

1988 chevy suburban 1/2 ton auto trans; 4 wd; dies after putting into drive


Could be a dirty throttle body or faulty idle air control valve.
Is the check engine light on ?

Jul 09, 2012 | Chevrolet Suburban Cars & Trucks

2 Answers

I have 2000 a chevy 3/4 ton s 2500 that hesitates. any answers???


I have a chevy ls 3/4 ton pick up 2500. It hesitates bucks and kicks also when I am driving!! Any answers???

Mar 20, 2011 | 2000 Chevrolet 2500

3 Answers

Change order for 5.7 liter chevy tahoe spark plugs


You can replace them in any order, but the Firing Order is 1,8,4,3,6,5,7,2

Aug 30, 2010 | Chevrolet Tahoe Cars & Trucks

1 Answer

2000 chevy montecarlo 3.4L, Engine cranks but dont start.


hook up vac gauge and test cranking vacumm should be at least 3 to 5 inches while cranking if not suspect plugged cat converter or timming jumped also check compresson that will tell you whatz up .

Jan 31, 2010 | 2000 Chevrolet Monte Carlo

1 Answer

Sporattic engine stalling- 98' Chevy Van 5.7 liter automatic.


vacuum leak at throttlebody,check dist.cap wires, bad spark plugs also check vacuum hoses

Oct 07, 2009 | 1998 Chevrolet C/K 3500

2 Answers

The truck died while driving and has no fuel or spark


Could be the fuel sending unit in gas tank

Sep 03, 2009 | 1992 Chevrolet C1500

Not finding what you are looking for?
2000 Chevrolet Silverado Logo

1,380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...