Question about 2001 Mercedes-Benz E-Class

Open Question

2001 e320 brake lights don't work, have replaced bulbs

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: 1995 e320 mbz

ihave a diesel e320 won't start

Posted on Mar 12, 2009

  • 14036 Answers

SOURCE: Reverse lights flash on/off when car is put into reverse.

REVERSE LIGHT PROBLEM COULD BE LOOSE WIRES OR FAULTY TRANSMISSION RANGE SENSOR.THE REAR CENTER BRAKE LIGHT COULD HAVE FAULTY BULB SOCKET OR GROUND WIRE AND THE CONTROL MODULE THAT CONTROLS IT CIRCUIT.

Posted on Feb 14, 2010

emissionwiz
  • 75117 Answers

SOURCE: I have a 2001 E320,

Hello
You can't just swap around parts, you must perform actual electrical testing of the brake light circuit to do this use a Digital volt ohm meter (DVOM) to check and see if you have 12 volts at the socket when the brake is pressed, if you do show 12 volts then you need to check the ground wire connection, use an ohm meter and check the ground wire to the socket, should read less than 3 ohms from the ground to the chassis sheet metal, clean and repair as needed to restore ground if a problem is found. Brake lights can be on different fuses, one for left and one for right, check the owners manual for location of the brake light fuses, test them with an OHM meter, they can look ok and be open.

Posted on Sep 02, 2011

  • 5252 Answers

SOURCE: why won't my MB ml350 brake lights work even after i install new bulbs?

Did you check the fuse? Either the fuse may be out, or the brake light swith on the brake pedal may be out or need adjusting. You should have 12 volts at the brake switch.

Posted on Nov 18, 2011

dttech
  • 4803 Answers

SOURCE: brake lights on mb ml350 don't work even after installing new bulbs

Rick,
The brake lamps on your Mercedes are computer-controlled. I would recommend scanning your computer network for possible fault codes.

Posted on Dec 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace brake lights bulbs. When step on the brake, my window light comes on but the other lights does not come on. The park lights and signal light works, except the brakes lights don't work....


I think your break light bulb is damage and not able to work properly so you need to change it so you can give your vehicle to mechanic to repair break light bulb.

http://www.dutchgrown.com/

Jun 14, 2013 | Cars & Trucks

1 Answer

Brake lights don't work?


check the bulbs and fuses and brake light switch

Jun 06, 2013 | 1999 Jeep Wrangler

1 Answer

Brake lights and tail lights don't work


cheek you brake light switch it's under the dash.. if it goes out it kills brake and tail

Feb 07, 2013 | 1995 GMC Sierra C1500

1 Answer

2001 Dodge Ram 3500: brake lights don't come on, switch has been replaced and installed to instructions, turn, four ways, parking lights and cruise control interrupt all work. Is there a brake rel


have you checked wire harness @ rear of truck ? and along frame rail, ? and condition of the rear taillight assymblies, ? corrosion could be in these areas. check all ground wires also, not sure about relay ! don' t think so ! why would brakes need one ?

Feb 02, 2013 | Dodge Ram 250 Cars & Trucks

2 Answers

When I turn my lights on my tail lights work but when I hit my brakes the don't light up I have a 2001 vw beetle????


the brake lights don't light up or the taillights don't light up? the brake lights are brighter than the tailights so the tailights won't show up whenbrakes are applied. if no lights work when brakes are applied then check for a bad ground at the light assembly.

Jun 14, 2012 | 2001 Volkswagen Beetle

1 Answer

How do you replace the headlight bulb on a mercedes e320


Check your owners manual if you have it, if you don't check your local library they may have a copy. The answer should be there under general maintanance.

Feb 25, 2012 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

Brake lights don't work. Bulbs, fuses and brake light switch all okay. Center brake light works and the running lighs work.


Filaments on actual bulbs might be burned out, pull the socket out from the back of the tailights and do a visual check on the bulbs, replace if needed...

Aug 23, 2011 | 1996 Mercury Mystique

Not finding what you are looking for?
2001 Mercedes-Benz E-Class Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...