Question about Cars & Trucks

Open Question

Signal lights on JD 4650 only work for a few seconds and then kick out the breaker, the rear flood lights also go out when this happens. Replaced the breaker, took off the star washers on the power st

Did find on the back of the switch that the purple wire is burnt a little. Do not know if a wire is bad or if the switch is bad. Can not find a wire diagram that shows what color wire is for what.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
localwonder
  • 6784 Answers

SOURCE: rear window wiper wiring diagram

this website is great for retrieving wiring diagrams.

Posted on Feb 11, 2009

Ad
  • 290 Answers

SOURCE: needing wiring diagram for 1991 dodge dynasty le

here is what I found:
http://www.the12volt.com/installbay/stereodetail/715.html

Posted on Mar 26, 2009

  • 14036 Answers

SOURCE: 2002 Buick Rendezvous - Rear Wiper, Back Up & Rear Plate Lights

look for rear wiper fuse and relay.because both circuits is tie together . look in glove compartment for the manual .it will show where all fuses and relays located.

Posted on Apr 07, 2009

  • 1 Answer

SOURCE: 2000 Chevy Astro van rear ac

astro van 2000 rear a/c switch

large orange power 13.8 volts pin G
small orange pin A
blue pin B
not used pin C
not used pin D
gray pin H
yellow pin F
black pin E

Posted on May 03, 2009

SOURCE: No brake lights or turn signals

Try changing your wires. from lights to blinker

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes fuse for signals to blow when activated and the signal lights light up when breaking on a E 150 Ford van?


Hi J.D.
The signal lights and the brake lights usually use the same filament in the bulb. If there is a bad ground on the rear lights, the current can go back through the signal light circuit and cause weirdness to happen.
If the fuse blows you net suspicious of a dead short which allows more current than intended.
I would recommend using a continuity meter and a voltmeter and doing a function check of the different parts of the circuits involved.
Hope this helps.
One last idea...... Has any maintenance been done on the wiring or lights recently? Something had to happen between when it worked, and when it didn't. That's what we're trying to find.
Cheerfuls

Nov 25, 2015 | Ford Cars & Trucks

1 Answer

Jeep tj problems


That is a sign of a bad bulb, flashing fast. Check that rear bulb.

Dec 31, 2013 | Cars & Trucks

1 Answer

The right rear tail light and side marker lights stopped working ... bulbs and fuse replaced but still not working ... what do I check next?


I had the same exact issue to happen just last week as well. Passenger side front sidemarker/ and right rear tail both out, as well as my dashboard lights. Replaced fuses and bulbs but nothing. Stange thing is Signal light still works,,and its the same bulb. Any answers would be appreciated. 1989 MBZ 300e

Sep 08, 2010 | 1994 Mercedes-Benz E-Class

1 Answer

Rear turn signal and hazard light don't flash (left side only)


The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

Mar 26, 2010 | 2000 Ford Focus

1 Answer

The drivers side rear brake light/turn signal only not working


you replaced the bulb with the wrong one i.e. a two filament bulb with a one filament bulb

Oct 05, 2009 | 2006 Ford F-250 Super Duty

1 Answer

2002 ram 1500 single cab ext light issues


sounds like a faulty underhood fuseblock..have seen lighting issues with these components

Jul 16, 2009 | 2004 Dodge Ram

1 Answer

The turn signals do not work on 2000 nissan exterra.Fuse was blown. Replaced and blew again after a few seconds.


1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Jun 11, 2009 | 2000 Nissan Xterra

1 Answer

Dash and shifter lights in 1996 jeep cherokee wont light


Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.

Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country

01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers

This should get you going. And you can always Ask Me.

Apr 27, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Jeep Liberty Left Rear Turn Signal Not Working


sounds like the bulb you have is the wrong resistance the new noen bulbs will do this

Nov 16, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...