Question about 1991 Honda Accord

1 Answer

How to repair manual window crank case on Honda Accord DX 1996. The cables inside were tangled and had come out of place, so I re-wound the cables, but am having rouble with the spring.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,596 Answers

Dont fight with one that is NOW DEFORMED Go to the Esed yard or better Dealer and Purchase a NEW REGULATOR & Install it. and NEVER have to Mess with it again!!!!

Please Rate me even if it cost you to fix it LoL It Will be right

Posted on Jan 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of timing marks on a 1996 Honda Accord V6

Compare the manuals at the auto store to see which one shows it best for you.

Nov 22, 2013 | 1996 Honda Accord

1 Answer

1996 Honda Accord rear crank up window is stuck open.

mike hi open the door agar pull the window winder towords urself not with force just gently the surroundin panal is just clipped together with plastic clips so put ur hand at the edge and pull gently and u will find it will come off easally then use a vice crips to close the window fully and then put wd40 on all the movin parts ok

Dec 24, 2011 | 1996 Honda Accord

1 Answer

My grandson has a 1997 honda accord, 4cyl, replaced auto tranny, now will operate only in first gear when placed in D4. reverse works ok. will not shift out of 1st gear. can u help. thanks

check the instillation of the transmission shift cable, it needs to be adjusted so that the pawl on the trans case has a full range of motion-put the shifter in neutral, and manually put the pawl in the neutral position (disconnect the cable0-then connect the cable again and bolt it into position.

Jan 24, 2011 | 1996 Honda Accord

1 Answer

Windows are difficult to crank up in a Honda 1996 accord

The back of the speaker is bigger than the original and its sticking out too much into the door panel and its pushing on the glass and that make its difficult for motor to push glass,speaker is your problem. good luck and thanks for using fix ya

Apr 05, 2010 | 1996 Honda Accord

1 Answer

Speedometer works erratically 1996 Honda accord LX

this is not a cable driven speedo - so the problem lies in the gearing inside the gauge cluster itself.
You will need to have it repaired or replaced.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Jan 02, 2010 | 1996 Honda Accord

1 Answer

I have a 1991 Honda Accord I believe it is the DX model. It is the model with the crank windows 4 speed automatic. I was wandering what to do because my driverside crank window is stuck. It won't go up or...

No.... You're panel has to be removed, which really isn't too big of a deal. The problem will be completely obvious, more and likely your regulator and or those damn little plastic clips.

Oct 10, 2009 | 1991 Honda Accord

2 Answers

Location of expansion valve

Expansion valve is located passenger dash area , inside the evaporator housing. This is not a repair that can be easily done by a home "do it yourselfer".It requires evacuating the the air condition system of freon is the biggest obsticle doing at home. Rec. taking to a certified a/c repair shop for this repair.

Jun 21, 2009 | 1996 Honda Accord

1 Answer

How do I remove the door panel on a 2000 honda accord?

If you have power windows or locks first remove the negative battery cable. If not you need to locate and remove the screws that hold the door handles in place (they may be hidden by snap in, or snap on clips).
If you have a manual window crank, you will need a small piece of wire with a hook on the end of it to remove the window crank (slide it behind the crank "base", hook the hook to the retaining clip and pull the retaining clip out).
If you have power windows, when you remove the handles unplug the wires to the window switches and door locks.
Next use a small prybar to remove the interior panel retaining clips (they're plastic clips that snap into the door). Get as close to the retaining clips as possible or directly under them to prevent them from tearing out of the door panel, and pry them out of the door.
Once the retaining clips are removed from the door, pull the panel upward to remove it from the door.

Installation is reverse.

I hope this information helps you, and I wish you luck on your repair.

May 03, 2009 | 1996 Honda Accord

2 Answers

Honda Accord LX 1996 Drivers Window Will Not Go Up

If you take the door panel off, you can unplug the window motor connector and apply power to the motor and run it up if the motor still works. Sometimes they do because it's a switch problem. At the very least, you can confirm the problem this way.

Mar 19, 2009 | 1996 Honda Accord

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

595 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides