Question about 1995 Dodge Dakota

1 Answer

95 dodge dakota only some heat at idle getting more when moving

When truck is idling it blows very little heat when motor rpms. are higher it blows more heat

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check your thermostat it may be sticking or you may need to replace your rad cap

Posted on Jan 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 dodge diesel was idLing at 1000 rpms set idle at 780 now engine won't start unless you step on fuel slightly


Automatic transmissions need to have a higher idle speed on the motor because of the load put on them by the transmission. You may have set it too low. 780 might be the idle speed with the transmission in D and the brake set.

Sep 24, 2015 | Dodge Cars & Trucks

1 Answer

I have a 2008 dodge dakota and it has a very rough idle. It runs great at higher rpm and really rough at idle what could it be and how would I diagnose the problem?


Search google for IAC - Idle Air Control motor. Specify Dakota and your engine size ( ex. Dakota 4.7 IAC ). The Dakota shares some engines with Jeep so you can search for Jeep also. Also search for TPS - Throttle Position Switch. These two control the idle. I believe your problem is the IAC has sludge on its piston, preventing it from sliding back and forth and opening up the idle chamber. You can remove the IAC and clean it with carbuerator cleaner, and also clean the cylinder it slides into with a small brush. You can also buy a replacement fairly cheap at auto parts stores, replace it and clean the cylinder it slides into.

Sep 30, 2014 | Cars & Trucks

1 Answer

I have a 05 Dakota 4.7 v8 6 speed. I get a gascap code and when driving the rpms stay up between shifts and when slowing down they stay up until stopped, then they will drop to 800 rpms at idle. Are these...


They are seperate issues, The gas cap code usaly means the vehical was fueled while running, Or cap is defective, The idle concern could be a vacume leak, Or a faulty idle air controll motor

Jun 12, 2010 | 2005 Dodge Dakota

1 Answer

Galant 95 backfires and shuts down at higher rpms


check ur plug wires they might be mismatched ...joe

Aug 29, 2009 | 1995 Mitsubishi Galant

1 Answer

The engine knocks at higher rpm, only at high rpms


First no matter what check the oil level and then if it's a high rev tapping you need to allow the oil to flow through the engine block to try to coat and settle your valves.

But if it's really " knocking " sounds like your lifters and rocker arms are allowing your piston rods to clatter and that needs to be looked into fast.

Jul 27, 2009 | 1992 Dodge Dakota

2 Answers

I have a 1994 Dodge Dakota, no power at low rpms


yes it does if it is reading lets say lower than normal that would explain easy start up and stalling later.the coolant temp sensor has two wires .so if your car warms up and your coolant is about 200 degrees your coolant sensor might say 80 degrees .access to a scanner to check temp would be great.

Mar 19, 2009 | 1994 Dodge Dakota Club Cab

1 Answer

95 ford windstar jumpy when it is turned on or idleing.


You may have a Broken Motor Mount. If you have someone Rev it up a little while you look at the Motor, If the Mount is Broken the Motor will Move in one Direction or the Other. It should not move at all when Revved up. Please Rate My Response! Thanks!

Feb 02, 2009 | 1995 Ford Windstar

1 Answer

95 Dakota has problems idling in the cold.


If its a throttle body, try cleaning the Idle Air Controller (IAC). This is for a carborated engine but its not much different for a throttle body http://dodgeforum.com/forum/dodge-ram-van/68174-diy-how-to-clean-the-iac.html .They get gummed up and wont thet the truck idle properly. The other thing that could be a problem is the MAP sensor. I would start by checking the IAC, its cheap (cost you a bottle of throttle body cleaner) and easy. I read somewhere you can pull the harness off the MAP and if that fixes the problem, then the sensor is bad, but who knows if that is really the problem. When you clean the IAC clean the whole throttle body just to be sure that isnt the problem. Hope that helps.

Jan 12, 2009 | 1995 Dodge Dakota

3 Answers

No Heat in 99 Taurus


Just finished fixing my daughters 1999 taurus heat. It would blow warm only when running down the road. At idle it blew cold. I started with replacing thermostat, and water pump because they are the easier fix. Still did not help. Then I replaced the heater core. A daunting job but not that hard to move the dash slighly out of the way to replace. There is a good write up at tarusclub.com. After that, heat was better but at idle, it would still blow cool sometimes. Researched and found answer. Park car on the steepest hill you can find with front of car up. Start car and take off reservoir cap. Let car warm up and keep rpms about 1500. After a while the fluid will come running out of the car and all over the place but it will bring air bubbles with it. Reduce rpm, add more fluid and repeat about 3 times. It will make a mess but after that, the heater works perfectly. We get heat long before the temp gage indicates any and it never blows cold unless you lower the temp.

Nov 21, 2008 | 1999 Ford Taurus

4 Answers

1998 dodge dakota v8 magnum


Sounds like you have idle air contol problem,sounds like you need your intake cleaned .Go to your local parts store and see if they have 3 step intake cleaning kit. 3M makes a kit and so does valvoline. It should contain a can of Throttle body cleaner a bottle of intake cleaner and a bottle of fuel injector cleaner that you will have to add to your fuel tank. Or you can go to your local valvoline express lube and they can perform this service for around $50.

Sep 20, 2008 | 2006 Dodge Dakota

Not finding what you are looking for?
1995 Dodge Dakota Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...