Question about 1991 Toyota Tercel

1 Answer

Ldles up and down in prak - 1991 Toyota Tercel

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Toyota Master
  • 2,620 Answers

Faulty idle air control valve.After replacing any sensor you need to reset the computer.You can do this by disconnecting the ground cable on the battery for 30 seconds then re-install.

Posted on Oct 30, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would make my tach jump up and down real fast while its idleing its a 93 dodge dakota 3.9


You have already changed the components that would be my key suspects. Sounds like your best bet is a shop with an analyzer. Some small shops can do that for you for a lot less than the big dealers.

Good luck.

May 05, 2014 | 1993 Dodge Dakota

1 Answer

Why won't the truck shift into prak


It may be your neutral safety switch on the automatic transmission is not working or out of adjustment.

Apr 06, 2013 | 2002 Ford Explorer

1 Answer

1998 ford contourcar starts until i let key off from crank position,ldles briefly, then dies like it runs out of fuel.bled off fuel line and there is plenty of fuel and pressure,


sound like your ign switch may need adjusting or replaced/ as for you pumping the gas. that does nothing for it do to the fact that its fuel injected.

Nov 27, 2011 | 1998 Ford Contour

1 Answer

I need a wire that gos from in side the car to the transmission from prak to drive dont know the name of that wire


Did you try to call ford customer service - or perhaps your local ford dealer?
It may be worth the trip if it's not to far - they can pull up schematic diagrams and print for you as well..
Best regards
Ck

Mar 08, 2011 | 1998 Ford Taurus

1 Answer

My 1994 mazda 626 starts and ldles but stalls when driving


ENGINE STALL WHILE DRIVING COULD BE STOPPED UP FUEL FILTER OR FAULTY FUEL PUMP.IDLE SPEED TOO LOW.OR IGNITION COIL HAS A LOOSE ELECTRICAL CONNECTION.FAULTY IGNITION MODULE.BAD PLUGS AND WIRES. I WOULD DO A LITTLE TUNE UP.CHANGE FUEL FILTER AND AIR FILTER.IF SPARK PLUGS AND WIRES HAS OVER 30000 MILES ON THEM I WOULD CHANGE THEM.ALSO FUEL FILTER IF OVER 30000 MILES.CHANGE IT CLEAN FUEL INJECTORS. TO TROUBLE SHOOT CAR I WILL DO A LITTLE TUNE UP FIRST TO MAKE EVERYTHING TOP NOTCH ON THE ENGINE BEFORE I GO TO NEXT LEVEL.BUYING NEW PARTS DONT NEED.GET VECHICLE SCANNED WITH A SCANNER. THAT WILL ALSO PIN POINT PROBLEM QUICKLY.BUT DO THE LITTLE TUNE UP FIRST IF EVERYTHING PAST 30000 MILES MARK.SCAN VECHICLE FOR FAULTY IDLE SPEED CODES OR FAULTY IGNITION MODULE CODE THEY WILL COST MORE MONEY TO FIX.PARTS HIGH.

Dec 24, 2010 | 1994 Mazda 626

1 Answer

Dies after i let off the gas


CHECK MASS AIR FLOW SENSOR.......

May 14, 2010 | 1992 Nissan 240SX Fastback

1 Answer

Car starts until i let key off from crank position,ldles briefly, then dies like it runs out of fuel.bled off fuel line and there is plenty of fuel and pressure,


It idles briefly since it gets gas from your cold start valve. This means your cold start valve is good.
It dies since after that cold start valve will close as it designed that way so fuel from injectors will take over. But apparently fuel is not coming from injectors. And injectors is controlled by injector module. Injectors are normally closed until injector module tells them to open.
Check out your fuel injectors and Injector Module.
You can buy NOID from any auto part store to test your injectors. If there is no light on then there is a problem with Injector Module. If there is light on the injectors then bad injectors.
Here how NOID looks
http://www.sjdiscounttools.com/ta36330.html

Sep 25, 2009 | 1992 Oldsmobile 88

1 Answer

Car will not start with key.


should be in the gear shifter panel..in prak the shioft rests againest the switch ..so the switch is mounted up by the p for park

Aug 30, 2009 | 1994 Buick Regal Gran Sport

1 Answer

2003 toyota matrix xrs will not rev beyond 7000 rpm and ldles rough


Rough idle = tune up

There is a rev limiter on the Matrix set at 6500-7000 rpm

Jul 18, 2008 | 2005 Toyota Matrix

Not finding what you are looking for?
1991 Toyota Tercel Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...