Question about 1998 Mercury Sable

Open Question

I am locked out of my 1998 mercury sable. The keys will not unlock any of the doors or the trunk

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

scramblepad
  • 66 Answers

SOURCE: Anti-theft system stuck triggered

Doing roadside assistance I have ran into this problem several times and if you look in your owners manual it will tell you how to reset it. Some of the cars you have to wait up to 10 min. with the key in the ignition and try again. The light will go out. READ carefully our owners manual.
Hope this helped....Kevin

Posted on Jan 31, 2009

  • 82 Answers

SOURCE: Car will not unlock.

To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Posted on May 04, 2009

simpsonite20
  • 100 Answers

SOURCE: 2003 Mercury Sable, Driver's side remote keyless entry keypad not functioning

Doubt its a fuse. Most likely the key pad has failed and needs to be replaced. On the bright side this is a good problem to have and you have a very reliable car.

Posted on May 11, 2009

emissionwiz
  • 75077 Answers

SOURCE: codes for keyless entry on a 2001 merc sable

the numbers are on the keyless module in the trunk, it is a paper tag

Posted on Jun 05, 2009

  • 1 Answer

SOURCE: 2000 Mercury Cougar Power door locks do not work on either door

Power door locks are on the same fuse as the alarm system. The fuse is located in the passenger compartment fuse panel under the steering wheel. There is a pull down lever that will release the fuse box. The fuse for the alarm system/locking system is #25. Yellow color and a 20 ampere rating.

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where exactly is the reset button on 1999 mercury sable for the fuel pump


unless you were in an accident,this is your problem,your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your buick dealer to get a new one,they are programmed for each car only,you cannot bypass it.

May 08, 2015 | Mercury Cars & Trucks

1 Answer

What is the master unlock keypad code for a 1998 mercury sable?


I had to take mine to the dealership. The owners manual should tell you where you could find it on the car. I believe there is a place in the trunk and under the hood or dash. Its usually stamped. I could never find it so I took it to the dealership. They might charge a small fee but they waived it for me. Hope this helps

Feb 28, 2012 | 1998 Mercury Sable

1 Answer

How do I locate factory door lock keypad code


you can most likely find the key pad code on the inside of your truck door.It is probably on one of the trunk hinges.

Feb 13, 2012 | 1997 Mercury Sable

1 Answer

2002 mercury sable se. Battery is dead and keys won't open doors or trunk


use the ignition key to open the drivers door instead

Dec 26, 2010 | 1997 Mercury Sable

1 Answer

Fuel pump relay location on 98 mercury sable


its under the hood on driver side what the problem not starting check the trunk area for the fuel cut off switch poss bad or tripped did u get hit or someone bump ur car

Mar 28, 2010 | 1998 Mercury Sable

1 Answer

93 mercury sable battery died now alarm won't allow me to start car!


use the key to lock and then unlock the driver door, this should allow car to start,it shuts alarm off. if its aftermarket alarm system then locate the push button under the dash, its a little push button usaually red, turn key on and quickly push and release this button 4 to 5 times.

Mar 04, 2010 | 1997 Mercury Sable

1 Answer

Codes for keyless entry on a 2001 merc sable


the numbers are on the keyless module in the trunk, it is a paper tag

Jun 01, 2009 | 2001 Mercury Sable

1 Answer

Car will not unlock.


To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Apr 02, 2009 | 1998 Mercury Grand Marquis

1 Answer

1998 Acura 3.5RL lovk button on key fob does not lock the car.


check to make sure all your door are closed, if so check your door switches, one might be bad not allowing your doors to lock

Oct 11, 2008 | 1998 Acura RL

1 Answer

Program remote keyless entry


1) Turn key from OFF to ON eight times within 10 seconds ending in the ON position.

2) After doors lock then unlock, press any button on the
remote being programmed.

3) The doors should lock/unlock to confirm programming.

4) Turn key to OFF and door locks should cycle one last time.

Jul 31, 2008 | 1996 Mercury Sable

Not finding what you are looking for?
1998 Mercury Sable Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

fordexpert

Level 3 Expert

5470 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...