Question about 1996 Cadillac Seville CA Value

1 Answer

Pull-down does'nt work but the motor does

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Switch on top of pull down mechanism ( looks like 1 1/2 x 1 1/2 black flap of plastic ) is the switch that makes the truck latch operate. replace that switch and it will work again. did this on my 96 sts solved the problem

Posted on Apr 16, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger power window on Dodge Ram 1500 won't go up.


I would be guessing,(we do that a lot)
that the driver door sw is a master & thus
neither works

When you do voltage drops-- have the alternator
running, so you have a more stable voltage

Nov 20, 2012 | Cars & Trucks

1 Answer

The heat in my 96 mazda protege dosn't work


With the ignition and fan switches turned on check for power at fan motor.If you have power at the motor then wiggle and maybe pull on the blower motor resistor and if fan comes on just fix the connection.But when you check for power at the blower motor and don't have power then check the fan relay if it does'nt click when you turn it on then its faulty.

Oct 29, 2012 | 1996 Mazda Protege

1 Answer

Power window circuit on '93 Bravada


check for battery voltages then if it is 12 v above pull out the the power window motor and test directly to the battery f the motor is working f it is working check for power supply maybe fuse blown or the main switch is malfunctioning!

Jun 30, 2012 | 1993 Oldsmobile Bravada

1 Answer

My fan won't blow out heat or air where to purchase one-


First try this turn ignition and fan switches on then pull and wiggle on the wire connector going to the blower motor resistor.These pigtails get very hot and usally melt causing it to loose its connection.The blower motor resistor is usally mounted on the heat duct on passenger side with 2 screws.You should be able pick one up at your local autoparts store but,if you can'nt then you can get one from www.rockauto.com.

Jan 29, 2012 | 2001 Chevrolet Malibu

1 Answer

Where is the fuse for the heater blower motor. Is there another one besides under the hood?


If your fan is'nt working its more than likely the blower motor resistor has a bad connection.Turn the ignition and fan switches on then pull on and wiggle the connector going to the blower motor resistor it should start working.Its located on the passenger side of the heat duct and has 2 screws that mount it to the heat duct.These resistors get very hot and melt the pigtail causing it to loose their connection.

Jan 27, 2012 | Chevrolet Camaro Cars & Trucks

1 Answer

I have a 1990 911 Porsche Carerra 2 convertible. I can't seem to get the top to go back up. Not sure why. The car has the key in the accessory position with my foot on brake and parking brake enabled.


You can always close the top by pulling it up by hand. It pulls hard but you can pull it up and it might require two peaple, and then latch it down. Fuses fail to connect in the fuse panel and the switchs fail as do the motor in the pump that makes the top move. Your right also that if the car doesn't sense that the e= brake isn't on or the is'nt moving it'll not work the top either. Many fuses have to be good for all the systems that interlock the top to work the most common fuse to blow is the cigar lighter fuse as peaple plug in things that short out oftern.

Jun 24, 2011 | 1991 Porsche 911

1 Answer

I have a 2009 dodge avenger that the front passenger window goes down but it doesnt go back up. I checked power at the motor & had power going both up & down. I thought it was the motor but I...


It may be a bad Power Window Switch, if the Power Window Motor goes up and down when you ran power leads to it but doesn't work with the switch, than the switch is bad. Replace the power window switch and it should work fine.

May 04, 2011 | Dodge Avenger Cars & Trucks

1 Answer

Cannot put top up on 1987 allante the latch is locked in and icannot open the latch on the pull down motor


There's a switch ( kinda same shape, color & operation method as your power seat switches) behind driver's seat near the 2 Boot/Top 'release' pull tabs,, it's mounted on the "roof" of the open compartment area behind the seats. Slide your hand along there til you feel it. It recycles the pull-down motor up & down & should release the top. Also try in the trunck, there's 2 hard plastic strings with loops at end,, pull & see if it releases it.

Oct 22, 2010 | 1987 Cadillac Allante

Not finding what you are looking for?
1996 Cadillac Seville CA Value Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...