Question about Cars & Trucks

1 Answer

2000 monte carlo with chugging issue when coming to stop or steady speed . had code for ttc solinoid replaced it and seemed fine for week now po742 code same symptoms

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Check wires running from the connection .

Posted on Oct 30, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: loss of power...2003 chevy monte carlo

catalitic converter if car is under 80,000 miles or 8 yrs dealer must replace free i had same problem

Posted on Jan 10, 2009

  • 1 Answer

SOURCE: Chevy impala diagnostic code PO742

i have the same problem, what can i do to fix it?

Posted on Jan 18, 2009

emissionwiz
  • 76848 Answers

SOURCE: 1996 monte carlo fault codes po300, 441, 705,

THESE ARE FROM THE GM CODE DIFINITION MANUAL, U NEED TO TAKE THIS TO THE DELAER, U HAVE SOME SERIOUS PROBLEMS TO GIVE THIS MANY CODES.

P0300 - Engine Random Misfire Detected
P0441 - Evaporative Emission Control System Incorrect Purge Flow
P0705 - Trans Range Switch Circuit
P1106 - Manifold Absolute Pressure (MAP) Sensor Circuit Intermittent High Voltage
P1133 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 1 Sensor 1
P1441 - Evaporative Emission (EVAP) System Flow During Non-Purge
P1662 - Cruise Lamp Control Circuit
P1672 - Low Engine Oil Level Lamp Control Circuit
P1870 - Transmission Component Slipping

Posted on Mar 24, 2009

  • 135 Answers

SOURCE: 2000 monte carlo how to replace water pump.last bolt

there should be holes in power steering pump pulley that when positioned correctly the bole should go through one of those holes, if not then you have to remove the pump

Posted on Apr 29, 2009

  • 1 Answer

SOURCE: need 2000 monte carlo owners manual to download free

http://www.montemill.com/Technical/Manuals/2000montecarlo.pdf

Posted on May 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abs light will not go off on my dashboard in my 00 chevy monte carlo


If the ABS light comes on and stays on the ABS system self check has detected a fault. Scanning the ABS system for trouble codes will help identify what the problem could be. Most often it is a bad wheel speed sensor, loose wheel bearing, or a broken wire in one of the front harnesses to the speed sensors.

Nov 02, 2013 | 2000 Chevrolet Monte Carlo

1 Answer

2000 le sabre gears shifting hard or slipping


that is your ttc solenoid . it is your torque converter lock up solenoid. it is located in the transmission ,and to get the it you have re move the side pan on the transmission on the drivers side12_12_2012_12_05_46_am.gif

Dec 11, 2012 | 2000 Buick LeSabre

1 Answer

My wife was driving my 95 monte carlo and it ran out of gas added gas but still did not start tried starting fluid still nothing changed the fuel pump and fuel fillters still nothing The battery has been...


turn on the key (not cranking) and push in the pin in the fuel line valve to see if you get a steady stream of fuel (use a rag to stop the spray for getting all over)-this will bleed the line of air. you might have to remove the plugs to check for flooding too, dry the plugs off if they are wet.

May 23, 2011 | 1995 Chevrolet Monte Carlo

1 Answer

Hi, 1997 monte carlo that idles, but cuts out when put in gear, or at times while driving. 3.1 engine. 184,000 mi.


I don't have an answer for you, but I do have a similar or maybe even the same issue with mine. It usually starts up fine, and idles and runs fine when first started, however a few blocks or a few miles down the road it starts to cut out on me, sometimes dying completely... throwing it into neutral and pumping the gas usually will keep it running. This has gone on for a couple of months. When it does die, It normally will restart after sitting for a few minutes. Then a couple of weeks ago it died on me (normally this happens when slowing down and coming to a stop,) and would not restart even after a 1/2 hr, I had to have it towed. I periodically attempted to start it for over a week, it would turn over, but nothing more...then someone suggested that I disconnect the auto start box...It started right up. However, it still continues to cut out when slowing or stopping unless thrown into neutral and pumping the gas. It seems to run better on the open highway, than it does in town with all the slower speed and stop n go. I bought this car used about 6 mos. ago, and considering it's age and the 135K miles on it, I don't want to put any more money into it. I just read there is a recall on this vehicle for the fuel pump and additionally the fuel assembly, I'm not sure if this would be the answer to the whole problem or not.

Dec 30, 2010 | 1997 Chevrolet Monte Carlo

3 Answers

Car is a 2004 Monte Carlo SS Supercharged. My check engine light will come on for about a day and then go out for two or three days, and then back on. It stays on steady and does not blink. All gauges...


Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check and let me know if you have questions.

Be sure to ask for the history when you get a scan. The computer stores all codes, even if the light has gone off. Report the codes back to us for analysis.

Sep 24, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

I would like to find the best place to get some upgrades!!


best advice ,if you want a faster vehicle buy a jaguar or a porsche ,a vehicle thats built to take the speed and will stop and corner

Jun 18, 2010 | 2000 Chevrolet Monte Carlo

1 Answer

2005 monte carlo seems to run rough / misfire when warm.


Remove your ignition module and take it to a parts house to be tested. This is common behavior for a failing module after it gets warm. Have them check it several times to insure it gets hot during testing.

Sep 11, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

2001 Monte Carlo SS Stalls while driving


its your M.A.F thats the air flow sincer i had that problem also but as soon as i got a new 1 it stopped and ran fine. the part cost about 160 bucks at auto zone and is easy to take off and put on yourself cuz the shop charge about 300 bucks to do a 3 min job but im sure that is the problem with your car

Feb 25, 2009 | 2001 Chevrolet Monte Carlo

1 Answer

2003 Monte Carlo losing power


I would try going to one of your local auto parts places first and ask them to hook up a codes scanner and see if there are any codes. If so, which ones and fix the first code first. That will usually fix any other codes as well.

Kenneth Triest

Jul 30, 2008 | 2003 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...