Question about 2011 Audi Q7

1 Answer

Hatch won't close

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

You dont say which latch it is but check the part that latches on the stud sticking out. if its closed just pull open handle and manually flip the latch open an should work fine.

Posted on Oct 29, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cadillac ctx hatch opens but won't stay open


There are small gas charged shocks that hold open the hatch, you need to replace them as there is no repairing them.

Apr 21, 2013 | Cars & Trucks

1 Answer

The "Door Ajar " message won't turn off on my 2002 explorer.


Check and adjust the sensor at the latch or in the lock

Apr 20, 2013 | 2002 Ford Explorer

1 Answer

All 4 windows won't work and rear door latch won't open! So, I have two problems: Firstly my rear hatch won't open as of yesterday (Keyless entry pushed & it doesn't even make a noise...


Look at your maintenance manual. To find where your fuse box is located(may be under the hood or under the steering wheel). When you find the fuse box look on the back of the panel flap and you'll find a fuse map. Locate the fuse that corresponds with your problem. It could be the same fuse but not likely. If fuse is blown then replace it with a spare. Most manufacturers will put spare fuses in the box or you could pull a fuse from some where else just to try and see if the problem is still there( make sure it's the same size and understand that it could blow this fuse as well then you will need 2 fuses). Most of the time fuses don't just blow. For some reason it pulled to much load. Probably a dead short in the wiring. I hope this helps.

Jan 22, 2013 | 2005 Toyota 4Runner SR5 V8

1 Answer

The rear hatch on my 04 4runner LTD won't latch. Motor cycles closed, then opens.


If the motor requires too much voltage to finish the cycle, it could trigger the computer to think there is a blockage.

Aug 28, 2012 | 2003 Toyota 4Runner

1 Answer

Hatch won't open


Go into the rear hatch cargo area and remove the trim panel over the latch and trip it manually. I know this works have done it myself on my 1996

Jul 17, 2012 | 1985 Chevrolet Corvette

1 Answer

Hatch won't open


while cleaning the car did you trip the valet switch shutting it off?

Apr 04, 2012 | Cars & Trucks

1 Answer

2005 GMC BACK HATCH WON'T OPEN


It sounds like the lock actuator has failed or has a poor connection which won't allow the latch to release. What you will need to do is remove the inside rear hatch panel to access the lock actuator. Once you get to the latch use a flat screwdriver to release the latch being careful not to damage the glass.

-----------
Click this link below for more troubleshooting:-- http://technoanswers.blogspot.com/2011/09/rear-hatch-wont-open-on-2005-gmc-yukon.html -------- This will help.Thanks.Helpmech.

Sep 09, 2011 | 2005 GMC Yukon

1 Answer

I purchased a new support for the lift gate. It pops in easily but the lift gate won't close now. What am I doing wrong? I can't see any other way to put it in.


Did you remove the safety clip that stops it from collapsing during installation? Some of these need to be installed compressed and if they extend too far out they will lock up. I would remove the support, compress it at least halfway and then put it back in place with the hatch halfway closed if possible. Then lift the gate and see if that helps in the operation. This assumes you are talking about the spring tension Hydraulic lift bar on the hatch and that you can reach the connecting points with the hatch partially closed.

Jul 07, 2011 | 2011 Kia Sorento

1 Answer

My rear hatch light indicates that the hatch is open which it is closed tight. Because of this my interior lights stay on and my remote start won't work. How can I fix this? My jeep is the 2009...


The switch on the latch is more then likely stuck. If you can see it spray it with some electrical cleaner and open and shut the hatch a few times.

May 27, 2011 | 2009 Jeep Liberty

Not finding what you are looking for?
2011 Audi Q7 Logo

Related Topics:

343 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...