Question about Toyota 4Runner

1 Answer

How to reset the check trans. on 1999 4Runner

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 14,333 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trans mode on my 1995 bmw 540i


take it to the dealer or check your trans fluid or have it se3rviced

Mar 13, 2014 | Cars & Trucks

1 Answer

1994 trooper trans light blinking took it in shop did a trans flush filter,gaskit and tran oil change. but this is the thing trooper misses and tran hold back but when shop checks computer reads nothing...


check out the neutral saftey switch on trans, if its reporting unknown gear on scanner while moving t bar it wont know what gear to be in and give you similar problems, also has oil been leaking into switch before?

Feb 17, 2011 | 1994 Isuzu Trooper

1 Answer

I have replaced the engine in the truck, it runs outstanding, however the trans mission wont engage now, I don't believe I have missed any connections, and it was operating fine before the swap, what have...


Check the Shift linkage at the trans to see if it moves when you move the shifter in the cab. if its moving then check the electrical connections for the switch on the side of trans and the other large round one going to the trans. also recheck your torque converter to see if it is spinning when the engine is running.

Feb 05, 2011 | 1995 GMC Suburban

1 Answer

2003 Audi A4 1.8T FWD. First gear engaging with a **** after changing fluid


Insufficient fluid ?
Did you use a scanner to monitor the fluid temperature while re filling trans?

Try 'Adaption'.

Turn on Ignition key without starting engine...press throttle all the way to the floor...hold for 10 seconds and turn off key.

This MIGHT reset trans to factory default.

You may have disturbed the wire loom at the trans which is known to corrode and resistance changes,. Without a scanner you cannot check solenoid operation.

Jan 16, 2011 | 2004 Audi A4

1 Answer

99 dodge caravan doesn't shift out of second gear


trans has gone into limp mode. Factory setting to get you home or to the dealer. First check fluid level. Try resetting the trans by removing the neg batt cable for a hour. If problem still there see repair shop

Sep 19, 2009 | 1999 Dodge Caravan

1 Answer

2007 Jeep liberty auto trans will not shift from 2nd gear. Check engine light is on. How do I reset the light, check the codes? I know this is "limp mode".


YOU NEED TO HAVE TRANSMISSION CONTROL SYSTEM SCANNED..IT HAS DETECTED A PROBLEM IN THE ELECTRICAL SYSTEM,INTERNAL OF TRANS OR A SENSOR FOR TRANSMISSION..A TRANSMISSION IS AN EXPENSIVE COMPONENT..YOU SHOULD GET IT CHECKED ASAP..ESPECIALLY IF YOU HAVE NO WARRANTY LEFT

Jul 04, 2009 | Jeep Liberty Cars & Trucks

1 Answer

94 SL1 , wont accelerate with used tranny put in recently


Check Fluid level first.If that's O.k check to see if it's the correct trans.Physically the SOHC & DOHC Trans Look The Same But they are geared different.If you put a twin cam trans into a single cam car or visversa it will not shift into 2nd 3rd or 4th.MP6 For SOHC MP7 For Twin Cam.Also 93,94 trans for 93,94 olny 95-02 swap.Good Luck Hope This helps

May 02, 2009 | 1993 Saturn SL1

1 Answer

Dash lights on and clock resets. 2003 Jetta


To fix the clock and the odometer I just had to make sure there was a fuse in both places 11 and 15. I have a standard trans and one place I thought was for auto trans instrument panel lights. But both must be there. The engine check light also went off but the airbag light is still on. I was wanting to avoid going to the dealer, but I might have to so they can reset that.

Apr 10, 2009 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...