Question about Toyota Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: trailblazer lt 05 overheating
overheating has a few possibilities.
low volume from water pump.
air lock caused by a small leak
cooling fan not coming on. from radiator fan switch or relays.
have the system pressure tested,
check the fan operation,electric or clutch fan.
Posted on May 13, 2009
SOURCE: 1991 camaro overheating
There are two freeze out plugs at the rear of the block (V8) and many v6 engines. If coolant is coming from where you say, likely they have failed. Unfortunately, the only way to reach them is to remove engine or transmission, It's rare that they fail because they are "protected " by the bellhousing, but can still rot from the inside out. There is no sealer known to man that will fix this. It's a shame that you need to do all that work for a pair of $2.00 plugs, but that's what needs to happen.
Posted on May 23, 2009
SOURCE: Overheating Toyota Camry 2004
Check the Tension on your Belt and the Waterpump. I have never Heard of someone Needing to Replace the Entire Motor just for an Overheating Issue unless it has been Driven too far while Hot or Someone Puts Cold Water in a Hot Motor. Check these things first and get a Second Mechanic to check it out Before you Proceed with an Unneccessary Replacement. Please Rate my Response, I need all the Help That I can Get! Thanks!
Posted on Jan 27, 2009
hi jasso, I would recommend checking the water pump if you see no flow in the radiator. Make sure when you fill up the cooling system, that you fill it cold, and that the vent screw in the radiator is loose. fill system until fluid comes out the vent screw. tighten the screw, start the car and have someone run at 1500rpm and check for flow.also, make sure that you have your temp setting full hot and blower on middle speed so that you don't trap air in the heater core.
Posted on Apr 05, 2009
if it is just a hose or tube that is easy to change, do it yourself to save you from spending a lot of money on install. you can pick the part up from auto zone, pepboys, napa etc.... if it looks to hard for you to do yourself, get the haynes manual for that year car, they sell that in those to, they have step by step instructions on how to repalce almost everything on the car, and where the locations are of other things that may need replacing also... that should help you out a lot... if you have any problem repost or email me and i will help you out... take care..
Posted on Jun 11, 2009
Tips for a great answer:
Mar 24, 2016 | Toyota Cars & Trucks
Dec 04, 2014 | Toyota Cars & Trucks
Mar 02, 2013 | 1996 Audi A6
Mar 30, 2012 | Cars & Trucks
Apr 29, 2017 | 1996 Isuzu Trooper
334 people viewed this question
Usually answered in minutes!