Question about 2004 Ford F150
LIGHT FLASHES 1 AND THEN 9 TIMES
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Since my last post, I found a bright yellow connector under the drivers seat. I took the connector off of the end, bent it a little, and put it back on. My air bag light has stayed off. I am going to put some electrical grease on it and see what happens.
Posted on Aug 09, 2008
SOURCE: air bag
CLEARING CODES (works for code 52)
1. Only intermittent codes and codes that diagnostic monitor recognizes as being repaired may be cleared from memory. To clear codes, cycle ignition OFF to ON. Observe AIR BAG warning light. AIR BAG warning light will illuminate for 4-8 seconds, and flash fault code.
(Comment) Loosely translated - If you dont have the problem fixed, this wont work. Code 52 should clear with this!
2. Locate air bag diagnostic 2-pin connector.
(Comment) This was a fun one. According to the air bag wiring diagram that I also got from Mitchell, the Airbag Diagnostic Connector is located "Right side of Instrument Panel". The only thing I found immediately to the right of the I/P (between the stereo and Instrument panel) was a black computer with 4 connectors which is NOT what I was looking for. I finally found a blog that mentioned the computer for the air bag computer was behind the right side kick panel. Sure enough....there it was. Attached to the side of the diagnostic computer was a two prong diagnostic connector.
3. Connect a jumper wire between diagnostic connector terminals. Leave jumper wire connected until diagnostic monitor tone sounds (about 5 seconds). Disconnect jumper wire. Fault code is cleared.
Posted on Oct 13, 2008
Seems to be a very common problem with Ford. The wiring harness beneath the drivers seat contains the sensors for the airbag system. Go under the drivers seat and secure all the wires and clips. This makes most error lights for the airbags go away. Hope this helps and good luck!
Posted on May 02, 2009
Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
Just push it together properly and it should clear the AirBag fault
Posted on Sep 06, 2009
This is common with a lot of Fords. There will be a connector underneath your passenger seat. Push the ends tightly together as this connector is known to come loose
Posted on Oct 08, 2009
Tips for a great answer:
Sep 26, 2013 | 2004 Mercury Sable
Aug 15, 2012 | 2006 Saturn ION
Feb 11, 2012 | 2002 Ford Expedition
May 08, 2010 | 2003 Pontiac Grand Am
Jan 18, 2010 | 2002 Ford Explorer
Nov 22, 2009 | 1997 Nissan Maxima
Oct 26, 2009 | 1997 Ford Escort
Mar 11, 2009 | 2005 Ford Expedition
63 people viewed this question
Usually answered in minutes!