Question about 2002 Jeep Liberty

Open Question

How do you repair 2008 jeep liberty rear window hinge on the outside of the vechile

The hinge has broken way from the bolt in the window

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: how to replace rear brake pads on 2005 jeep liberty

put the back of car on jack stands and secure the front tires so it does not roll and then remove the bolts off the back of the caliper there is normally two one at top and one at bottom and spray it with some kind of oil for rust and make sure you have the right size socket before you try to loosen them and once caliper is off and the old pads removed take one of the old pads and squeeze the piston on the caliper back in by using a "C" clamp and also remove some of the brake fluid from the master cylinder before you do this put the new ones back on and check the brake fluid and make sure it is full and then pump the brakes to make sure you have a good pedal also put some "No Squeak" brake stop on the back of the pads so they don't squeak they will have that where you buy the pads from

Posted on Mar 01, 2009

  • 1 Answer

SOURCE: How to replace reak brake rotors on Jeep Liberty

Replace rear rotors on 04 liberty.
Remove tire & wheel
Remove brake caliper, tie up out of way.
Back off e-brake shoe adjustment.
Remove factory spring clip from lugs (2places)
This is the crude part....
After attempting to pull off disc/drum with puller....I got pretty sick of it. Understand this is in the Northeast with lots of salt on the roads in winter. Needless to say there is a ridge of rust around the inside edge of the e-brake surface. Any more pressure and I was afraid of damage to the e-brake shoe asembly. I then took a small grinder with a cut off wheel and cut the disc thru (used space where caliper usually sits). Also cut nearly through the face between 2 lugs. You can't quite get thru the back corner at the disc. Since the material is cast iron it will crack when you drive a wedge in the slot cut in the disc. This opens the housing around the shoes and it slides off easily. The cutting operation took less than10 mins, alot less than the puller with hammer assist!
I know this is a bit "unorthodox" to say the least, however the object is to remove the old junk disc safely and as quickly as possible, without harming the e-brake parts inside.
Install new parts in reverse order, new pads go in easy after squeezing the caliper piston back with a c clamp as is the normal procedure.

Posted on Mar 22, 2009

  • 2 Answers

SOURCE: 2003 Jeep Liberty rear wiper does not work

how is it not working, entirely not running, or just doesn't come in contact with the glass?

Posted on Mar 31, 2009

ZJLimited
  • 17970 Answers

SOURCE: need to replace a broken window on rear passenger 1999 jeep chero

This information can help you to fix it:
- Section-08s-Power-Window-Systems-Ewj8s
- Section-23-Body-ewj23S (Rear Door, page 41 and next).

Good luck (remember rated this help).

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 jeep liberty, window drive broken, fell down, now rear door is locked and cannot open inside or out


If your careful you can get the door panel out of the window trim at top with out breaking it. Hooter day is best to do it as the plastic panel is more pliable. Once out wedge it back some and pull the trim out. This will give you a good inch plus gap to work threw. Most like the cable has wrapped around it. Flash light to see it and bent coat hanger, long screw driver or bar. You should be able to get it open.

May 27, 2015 | 2004 Jeep Liberty

1 Answer

2008 Jeep Liberty


Possible solution - This happened to me and my battery was dead in my key fob and also I needed an ignition switch because a piece on it was broken which therefore wouldn't turn to start the engine.

Apr 26, 2013 | 2008 Jeep Liberty

1 Answer

How to change the left rear turn signal bulb? on a 2005 Jeep Liberty not shown in the owner's manual.


open the rear cargo door, and look inside thru the hinge at the light lens area... you will see the screws to remove

Jun 21, 2011 | 2005 Jeep Liberty

1 Answer

How do you repair 2005 jeep liberty rear window hinge on the outside of the vechile


go to dealer buy a new hinge if screwsare broke or stripped see if dealer has a repair plate or make one your self a small plate drilled and tapped or a nut welded to a plate besure to buy new screws at dealer tackweld a peace of wire to your new plate and fish in threw the top rear brake lite you will need someone to help start screws while you hold plate and lifgate.

Feb 24, 2010 | 2002 Jeep Liberty

1 Answer

I need a photo of the parts inside left rear door jeep liberty 2006 the cable that puts window up and down is broken i nee to replace


CHeck the KJ Service & Repair Manual Secc-23-Body (page 128 and next, for Rear Door).

I really hope helps with this (remember rated this help) Good luck.

Jan 07, 2010 | 2006 Jeep Liberty

1 Answer

RR window on my 02 Lib fell and now that door won't open!


As a last resort, I might try something like that, but remember that the door is heavy and that hanging it from the latch assembly will not do good things to the latch. If you try that, I'd first open the window and tie the door off to the roof rack to keep the door weight off the latch. Likely the latch will not release by removing the hinge bolts, but it may give you more room to get the inside panel removed.

Jul 19, 2009 | 2006 Jeep Liberty

1 Answer

2003 Jeep Liberty Power Window Off Track


its the window regulator. not to bad to change. just a couple of screws to remove the door panel. peel the liner back & remove the 6 10mm bolts and uunhook the electrical connector and the window from the regulator. installation is reverse

Jan 21, 2009 | 2007 Jeep Liberty Sport

1 Answer

2005 jeep liberty 4 weel drive will not engage


I just bought a jeep liberty, 2005. It's automatic with 4wheel drive option. I do not have an owners manual. Do not know how to engage the 4wheel drive. I have never had a 4wheel drive vechile before.

Jan 15, 2009 | 2003 Jeep Liberty

2 Answers

Broken screw thermostat


If you can remove the thermostat housing and the bottom bolt is visible, you can use a vise grip to remove it.
If the bolt is broken even with the block, then you have to drill it out.

Oct 05, 2008 | 2003 Jeep Liberty

Not finding what you are looking for?
2002 Jeep Liberty Logo

Related Topics:

639 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...