Question about Nissan Maxima

1 Answer

Where is the sensor for the tack on a 96 nissan maxima

Is it on the trans?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 76,164 Answers

The tachometer gets its signal from the ignition system coil signal so if the car runs then the tachometer is defective and must be replaced or repaired.

Posted on Oct 29, 2012

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: 1996 Nissan Maxima oxygen sensor

hye there ,,there are 3   o2 sensors on your car,,one for each bank,,,and the 3rd sensor is located after the cat this one usually goes first,,,,just make sure you no if your cars an import or not as they can be different,,,then you should be safe when ordering ,,hope that helps,,,

Posted on Apr 24, 2009

  • 548 Answers

SOURCE: how to change thermostat in 96 nissan maxima

if you follow the top large hose from the radiator to the engine you will see that it ends ina kind of bubble shaped housing with several bolts that attach to the engine, your thermostat is inside this housing and all you have to do is remove the bolts slip off the housing and pull out the old thermostat and replace , make sure you use a gasket and some gasket silicone when you replace and be sure to tighten proerly but to not overtighten

Posted on Sep 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a PO 443 code on my 1996 Nissan Maxima eve app problems changed all sensors around canister and rear and the gas cap still not fixed what next


You should have a smoke test ran on it to see if its leaking anywhere. You could have a bad canister also. Here is a link to someone who could help you more in depth... P0443 on 96 Maxima 1996 Nissan Maxima

Feb 16, 2017 | Nissan Cars & Trucks

1 Answer

96 Nissan maxima trouble code P0733


P0733 Transmission Ratio in gear 3
If trans is not slipping, check/replace the tps sensor

Feb 14, 2016 | Nissan Cars & Trucks

1 Answer

I have a 96 nissan maxima it won't go into park


Most likley problem is your brake light switch. go underneath the dash to the brake pedal and depending on wether you have cruise control or not ther will be one or two sensors there. the black sensor should be the brake light switch. disconnect and jump the connector with a paper clip and see if the brake lights comeon and the shifter will move.

Jul 02, 2011 | 1996 Nissan Maxima

1 Answer

How do i connect a 4 wire oxygen sensor to a 3 wire for a 96 nissan maxima


you will need the wiring diagram for the car the oxygen sensor has 4 wires two white which are the heater one positive one negative it doesn't matter which is which the black is ground the gray is the signal wire some have a blue wire black is always ground the blue would be sensor hope this helps

Jul 25, 2010 | 1996 Nissan Maxima

1 Answer

Lcation speed sensor 2000 Nissan Maxima


There are 2 kinds of speed sensors:
wheel speed sensors which are mounted behind each wheel and tied in with the abs brake system,
Vehicle speed sensors which are screwed into the side of the transmission/trans axle, which operates the speedometer.

May 15, 2010 | 2000 Nissan Maxima

1 Answer

95' Nissan Max trans is losing gears!! is it a sensor or maint.


Most likely maintenance. If the fluid is low or very used it will cause shift t issues. Tech note if you are already losing gears just changing the fluid may not solve the problem. I recomend you tyake it to a trans shop for proper check out.

Jun 18, 2009 | 1995 Nissan Maxima

3 Answers

96 maxima is hard to start and dies often


when my 96 nissan maxima gets hot it will cut out and almost like buck like it dose not get enough gas. i have chaged all filters and plugs and coil pack

Apr 27, 2009 | 1996 Nissan Maxima

1 Answer

1996 Nissan Maxima no 2nd gear on auto transmission?


do not flush the trans, that will make it worse.
My friend you have no second gear, you need trans rebuilt.
If you flush it now you can cause more damage.

Feb 25, 2009 | 1996 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...