Question about 1994 Mitsubishi 3000GT

Open Question



Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 373 Answers

SOURCE: its a 1997 montero sport

After you have checked all the fuses.
Please check the FUSE # 9 15amp. Is the fuse for the front wiper.
Behind left side of dash.
I'm watching the DIAGRAM for your wipers.
And I found. the relay, But is part of the Wiper Switch. on steering column.

With a Test light. check the BLUE wire for POWER 12V.
ON the wiper motor connector.

If yes try to hit softly with a metal piece.
With the wiper switch on. and ignition on.
If work you need to replace the wiper motor.
And letme know if work. or not.

OK> I hope this help on your problem.

Posted on Jul 25, 2008

  • 243 Answers

SOURCE: windscreen wipers wont turn off and interiour clock no display ??

I think from memory they have a rain sensor...could be it's damaged. See your local MMC dealer with your full chassis number and they might be able to check if your model has a rain sensor and where it's located.

Posted on Jan 26, 2009

  • 13 Answers

SOURCE: 1990 Mitsubishi Montero: Rear windshield wiper not working

You need to remove the door panel of the taildoor to access the wiper motor itself. Then, with either a meter or a test light, you can verify that the motor is getting the correct power and ground to allow it to run. Most older Monteros are pretty easy to work on with regards to door panel trim removal. You need to have a panel removal tool to gently lift the trim panel away from the door itself. These tools are generally pretty generic ,and available at many better equipped auto parts stores. They're almost always a flat metal tool that's pretty thin, you use them like a putty knife or a gentle pry bar, slipping them behind the trim panel and gently prying a small section of the panel away from the metal door to release the hold of the plastic trim clips that attach the door trim panel to the door itself. These panel clips are usually arranged in a perimeter fashion around the back of the trim panel. You may need to also remove some screws or bolts that hold trim pieces to the door or a pull handle. Once you get all of the 'extra' parts removed from the door, then try removing the door panel with that removal tool, noting if any of the plastic clips break in the process.
Get the door panel off and we'll help you test the wiper motor next.

Posted on Jun 11, 2009

  • 12 Answers

SOURCE: Windshield Wiper Motor Replacement

Nope, but you have to position the linkage in just the right position so that it will clear the windshield glass and the brackets that are located below the windshield.

Posted on Sep 26, 2009

  • 120 Answers

SOURCE: my windshield wipers don't work

Check fuses, front and back wiper motors run on different fuses. Test for power and ground at front wiper motor wires. If you have power and ground there your wiper motor may be toast. Good luck

Posted on Sep 12, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Windshield wipers wont turn off, changed switch, motor, and even got a different steering column still runs as soon as you turn the key.

the fault must be in the wiring, you hav'nt said vehicle etc , have you replaced the relay as well , usully under bonnet fuse box but as dont know vehicle can't be specific

Nov 07, 2014 | Cars & Trucks

1 Answer

Wiper wont work

You have a relay that may be bad. The next thing I would check is the ground. Just get a wire and short to the wiper motor and run to a grounded section of the frame. Check those grounding straps that run from the firewall to the engine.

May 10, 2014 | 2001 Toyota Celica

2 Answers


Turn signal switch sounds defective or it may simply be the wiper relay is stuck. Locate and pull the relay.

Nov 22, 2013 | Ford Escort Cars & Trucks

1 Answer

Front windshiled wipers not working.

blown fuse, faulty wiper motor or faulty wiper switch. Possible you got a bad new wiper motor if you replaced everything in the order you wrote it in.

Mar 12, 2012 | 2003 Ford Windstar

1 Answer

Wipers will not turn off

Your wiper relay contacts are stuck. The wiper relay is located INSIDE the wiper motor assembly. You must replace the entire wiper motor assembly to replace the relay.

You might try rapping on the wiper motor with a small hammer or a screwdriver handle a couple times to see if you can jar it loose.

Nov 17, 2011 | 2004 Ford F150

1 Answer

2002 dodge dakota. Wiper timer problem. More info... started when I hit the wash button. Usually the wipers will go for a few seconds... then turn off. They stay on. I changed the wiper motor, switch in...

The problem here is the wiper motor itself, theres a cuircut board on the back of the motor, this is what goes bad and controls the wipers, you will need to replace the motor to replace this board, i think they should be replaced in a pair,this will solve your problem, , hope this helps.

Aug 31, 2010 | 2002 Dodge Dakota Club Cab

1 Answer

Dakota 2002. Wiper timer keeps wipers going after I shut off wipers with switch. I changed the switch on steering column and wiper motor. Did not fix problem. Has to be another part I need to change.

There is a relay usually under the hood. You can listen with the engine off and turn the wipers to delay and you should be able to hear the relay make a clicking sound. The relay is sticking. Just replace the relay and should solve your problem.

Please Vote! Thanks!

Aug 31, 2010 | 2002 Dodge Dakota Club Cab

2 Answers

Windshield wipers will not turn off, I've replace the turn signal/wiper switch and still not turning off

Sounds like the PARK SWITCH within the WIPER MOTOR is at fault, Only way to beat it is relay the motor. Hope this helps

May 08, 2009 | Cadillac DeVille Cars & Trucks

1 Answer

Wipers won't stop wiping.

Sounds like your intermittent wiper circuit is defective. Normally the intermittent feature is engaged by one of the functions on the multi-function switch (usually on the steering column). The circuit of the intermittent wiper periodically activates a relay that closes across the "Wiper On" switch. Your intermittent wiper circuit is likely defective and holding its relay closed (or the relay is stuck closed), thereby keeping the wipers on. Note: The wiper motor has an internal switch that opens when the wipers are in the park position and that is designerd to stop the wipers in the park position. When you turn on the wipers (or the intermittent relay is closed), the motor's internal switch is shunted such that the wiper does not stop at the park point of the cycle.

Apr 27, 2009 | Ford Explorer Cars & Trucks

1 Answer

What do i check when there is no power to the wiper motor

I have an S10 1998, but the problem is the same...sometimes the wiper motor stop in any position, and I have to move the wiper arm, and the motor work's againg, what happen is : the wiper motor have some contacts than I thing are broken and eventually I most replace the whole wiper motor. The problem is no the column switch belive me.

Mar 05, 2009 | 1984 Chevrolet S-10

Not finding what you are looking for?
1994 Mitsubishi 3000GT Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides