Question about 2000 Ford Taurus

1 Answer

2000 ford taurus se starts but within seconds dies

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I was having this problem and it was a bad fuel pump. Later on started having trouble with this again and mechanic discovered the fuel pump wires had been damaged and was grounding out underneath fuel tank.

Posted on Nov 05, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: I need a diagram for a serpentine belt

Starting at the crankshaft pulley, and going clockwise, the belt leaves the crank pulley,
Goes around the tensioner,
Goes around the water pump
Goes around the alternator
Goes around the upper idler
Goes around the Power Steering pump
Goes around the air conditioner pulley
then goes back to the Crank pulley


Posted on Sep 15, 2008

  • 18 Answers

SOURCE: 1999 ford taurus

check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Posted on Oct 26, 2008

chuck943
  • 783 Answers

SOURCE: Heater Control Valve 2000 Taurus SE

Taurus doesn't have what is called a heater control valve,are you reffering to the remote climate control module,the one that the vacuum lines hook to? If so it is behind the glove box. Just open the glove box and press the 2 clips on the sides so it opens all the way up and it will be located right behind this.

Posted on Jan 29, 2009

  • 4 Answers

SOURCE: how to locate thermostat on a 2000 taurus se 3.0l duratec dohc

on ataurs with a duratec the thermostat is on the bottom radhose underneath the car. you will see a little housing near the radiator underneath the vehicle. they are a bit of a pain to get at

Posted on Feb 13, 2009

  • 33 Answers

SOURCE: fuel gauge stuck on full for my 2000 ford taurus SE

it is probbally the fuel pump in the gas tank. It has a float like the one in your toilet and a sensor attached to it to tell you how much gas you have.

Posted on Aug 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford taurus alternator quits working after a few months


Most likely the piktail or also known as the alternator connector no good.

Nov 25, 2013 | 2000 Ford Taurus

1 Answer

I have a 2000 ford Taurus se and I can't seem to


Here's a link to your relay,it says it's in the junction box next to the battery.

Jun 01, 2013 | Cars & Trucks

1 Answer

My 2000 ford taurus se will only start in neutral


You may need a park/neutral safety switchir have yours adjusted. Make sure the shifter lever goes all the way in to park first and see if wiggling and jiggling it makes a difference

May 10, 2012 | 2000 Ford Taurus

1 Answer

I have a 2000 ford Taurus se ffv and my check engine light started blinking. What does that mean?


The system had a fault. Get the code pulled with a OBDII scanner. This will give you an idea on the problem

Apr 01, 2012 | 2000 Ford Taurus

1 Answer

2000 ford taurus a/c was working fine car sat for about 3 hours started car no a/c the clutch cycles on for a second then off for aminute


You may have a leak in the system!! Have it pressure tested!! The compressor is sensing either there isn't enough or too much freon within the system and is in protection mode.

Jun 07, 2011 | 2000 Ford Taurus

1 Answer

Good day: I don't accept that cold starting an engine at 2000 RPM is OK. Those immediate revs on a cold engine are wearing out parts that need oil lube and warm-engine clearances. Is there a simple way of...


I have heard that Fords theory behind that is to supply maximum oil pressure to moving parts sooner. All the Ford products do this and the motors last well into the hundreds of thousand of miles. I wouldn't be to worried about it since there is no issue with it to my knowledge and there is no way to limit the cold start RPM's.

Cold start warm ups are a thing of the past. Better lubricants, engines, fuel injection and other computer controls have made start ups easier on the engine. 30 seconds is barely enough time to warm up anything and after a few seconds oil has already reached all of its intended lubricating points. That first few seconds is the hardest on the engine. Regardless of how any RPM's it is turning.

Oct 20, 2010 | 2000 Ford Taurus

1 Answer

Airbag code 36 2000 ford taurus se wagon


Unless the air bag has been deflated, call your local dealer and ask this question??? perhaps a computer glitch??

Jul 21, 2010 | 2000 Ford Taurus

2 Answers

I need a diagram for a serpentine belt, for a 2000 ford taurus se


Starting at the crankshaft pulley, and going clockwise, the belt leaves the crank pulley,
Goes around the tensioner,
Goes around the water pump
Goes around the alternator
Goes around the upper idler
Goes around the Power Steering pump
Goes around the air conditioner pulley
then goes back to the Crank pulley


Sep 06, 2008 | 2000 Ford Taurus

Not finding what you are looking for?
2000 Ford Taurus Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...