Torque settings for injectors
SOURCE: audi a4 tdi 51 plate
Rear wheel bearing needs to be adjusted, not simply torque tighten !!!
SETTING WHEEL BEARING CLEARANCE :
1. Wheel bearing play is correct when the thrust washer can just be moved using a screwdriver simply by applying pressure, without having to apply force.
2. Secure with slotted ring and new cotter pin.
Success!
SOURCE: What is the torque setting for the rear wheel
New bolts ;
1. tighten 190 Nm with wheel off the ground.
2. lower car to ground, tighten further 180 degrees
3. tighten further 90 degrees.
SOURCE: Hi, I`m looking for the torque settings for the
Cylinder head instructions for Audi A4 1.6 (1998)
Tightening sequence:
Renew cylinder head bolts: Yes
Stage 1 - Tighten: 40 Nm
Stage 2 - Tighten: 90 degrees
Stage 3 - Tighten: 90 degrees
SOURCE: Hi, I`m looking for the
Cylinder head instructions for Audi A4 1.8 (1997)
Tightening sequence:
Renew cylinder head bolts: Yes
Stage 1 - Tighten: 40 Nm
Stage 2 - Tighten: 60 Nm
Stage 3 - Tighten: 90 degrees
Stage 4 - Tighten: 90 degrees
SOURCE: audi a6 2 ltr petrol timing marks and torque
ally head 75lbs ,timing marks i honestly cannot remember ,do it old fashioned way time it to no1 with valves closed on no1 then you can see where or what the pmarks should be ,do not use starter motor ,always crank engine by hand 360? to ensure valves clear
508 views
Usually answered in minutes!
×