Question about Hyundai Cars & Trucks
Gas gauge not working properly
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 Hyundai Accent Problem
first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
Posted on Sep 28, 2008
SOURCE: Gas Gauge not working properly
First...how do you get 25 mpg...I get 21 or so!!!! Additives will never work on this. The price for the pump is $150-175 for an aftermarket unit.
I just did the tank job for the sender. Get an aftermarket pump/sender. DO NOT ORDER from RockAuto for this part...their listing is wrong. They send the gasket...which comes with the replacement. Replacing the unit is relatively easy:
Posted on Nov 11, 2008
The fuel gauge utilizes a voltage stabilizer located on the back of the instrument cluster. if it's faulty it could cause this problem. The other causes are a wire fault (short) between the gauge and the tank sending unit and the sending unit itself being corroded and stuck in the full position (the float assembly that is). One way to quickly isolate (and maybe eliminate) the problem is to get a used cluster from a wrecking yard and swap it out. If it works normally, there you go... if not you will need to access the tank sending unit (this usually, but not always, involves draining and dropping the tank to get to it. Some cars have an access panel in the body over the fuel tank for this purpose... look under the carpeting in the rear of the vehicle) Once you have access disconnect the power wire (usually red or with a red stripe), and with the key on, the gauge should drop to empty. If it doesn't, the problem is not the sending unit. Hope this helps...;-)
Posted on Apr 14, 2009
The reason the gas station pump shuts off is when the fuel reaches the tip of the gas nozzle, so when you are filling your car and the gas nozzle (gas stations pipe) keeps shutting off it means that the pipe that runs to the gas tank is not open completely, what happens is when you pump the gas in the car the supply pipe from the gas tank opening to the tank fills up quickly and this causes the gas station pipe nozzle to shut off, have some body take down the gas tank and have a look at the gas tank opening and also gas supply pipe that runs from the gas filler opening ( on the car body) to the gas tank. Have a look at it and please don't forget to rate the answer if it was helpful, thanks!
Posted on Mar 25, 2010
Your tank sending unit is bad. Unfortunately, it is part of the fuel pump assembly, and the part costs around $400, give or take. plus installation labor. It is an all too common problem on GM vehicles, as I have had to change it on my last 2 GMs. If you do an internet search you will find plenty of others in the same boat!
Posted on Apr 23, 2010
Tips for a great answer:
Dec 26, 2015 | Cars & Trucks
Mar 02, 2015 | 2002 Hyundai Accent
Jun 05, 2014 | 2002 Hyundai Accent
Dec 22, 2013 | 2007 Hyundai Accent GS Hatchback
Aug 19, 2012 | 2003 Hyundai Accent
May 06, 2012 | 2007 Hyundai Accent GS Hatchback
Jun 03, 2009 | 2002 Hyundai Accent
Apr 14, 2009 | 1996 Hyundai Accent
Apr 02, 2009 | 2001 Chevrolet Blazer
205 people viewed this question
Usually answered in minutes!