I have changed out the starter and battery and also put on new cables. Still wont start, turns over when bypassing right to starter. I am not sure what else it can be, turning key gets a click from starter.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the starter won't engage, you can't crank the engine. You would only hear the starter operating freely. The replacement starter may have to be shimmed to fully engage the ring gear. Also, did you verify that the ring gear is OK?
I had this issue with my car. its really common in GM cars.. I found this site that sells a way to bypass it. It will save u a ton of money and the site has great customer service if u have any problems .. check it out I hope it helps ya Do It Yourself GM Security bypass
they had a problem with the ground for the starter relay. its located under the drivers kick panel. you have to locate the relay and follow the ground back. i had the same issue. also you need to do a voltage drop test on the positive cable and check the resistance on the engine ground located on the bell housing
Hi Anonymous, lift up rubber boot on positive cable to starter, unplug starter relay wire usually green, with a jumper wire connected to positive battery cable starter stud, touch blade connecter on starter where starter relay wire was removed. If starter engages and turns over engine then your starter relay is bad. If starter activates but does not engage then your starter drive/clutch is bad. Good luck
No it doesn't mean that you have a problem.When you cross the lugs with a screw driver no matter whether you have the key on or not it will still engage the starter.The reason being that you have the hot wire from the battery going to one terminal and your ignition switch on one terminal.What your basically doing is bypassing the switch and directly energizing the starter.A good way to test a starter is to remove it from your truck hook up your battery cables to your battery.Be very careful when you do this.Hook the ground to the starter casing and just touch the hot cable to the battery lug on the starter.This should engage your starter.You might want to take a look at the fuel delivery system for proper operation.
Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me firstname.lastname@example.org<<<<<<<<<<<<<<<