Question about 2004 Chrysler Town & Country

Open Question

Chrysler town and country gear lever stuck in park

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
garyq1970
  • 85 Answers

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Posted on Aug 24, 2008

Ad
chryslertech
  • 115 Answers

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Posted on Mar 08, 2009

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

  • 295 Answers

SOURCE: 2005 chrysler stuck in park

remove the rubber cover on the right side of the shifter. there is a pink tab press it down with a long screw driver if it still down not come out of park replace the shifter the interlock spring is broken. Hope this helps please rate if it does.

Posted on Sep 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 Chrysler Town and Country wont shift out of park


Probably a problem with the shifter interlock system . Won't allow the gear selector to move from park with the engine running unless the driver is pushing on the brake pedal . Locking solenoid in the shifter , brake pedal switch , wiring etc... may even have a body control module in the loop controlling these system . Do the brake light's work ? Some of these system's have a release point in the shifter assembly . Don't know if this is your problem without checking it out .
Shifter won move
Shifter Stuck in Park Wont Move Easy Fix Most Make Model Vehicles

Dec 15, 2017 | Chrysler Cars & Trucks

1 Answer

2002 chrysler town & country. wont change out of low gear.


I'd check fluid as required by Owner's manual no manual? Try MFG website or email their customer service, or try
manualslib.com
Otherwise you may need professional inspection to save the transmission. Also could be bad linkage and or bushings on the linkage to the transmission. Could be a similar problem with the shift lever itself, or an adjustment problem.

Apr 13, 2015 | 2002 Chrysler Town & Country

4 Answers

2005 town country Chrysler when I start it up it will go for just a few mintues then it will just stop like the gears just stop working and it wont move turn it off start back up it go for just a few min...


may be a pulley is stuck. if the serpentine belt is not circulating it will freeze the whole system. my jeep did the same thing . turned out one pulley was frozen and another loose. belt would turn few times then freeze

Jan 27, 2015 | 2005 Chrysler Town & Country

1 Answer

2001 chrysler t n c wont start just clicks


Check the battery terminals for corrosion. Also this could be the neutral switch. Try holding the shift lever firmly into park, Next try starting in neutral.

Aug 30, 2014 | 2001 Chrysler Town & Country

1 Answer

Fan is stuck on panal and wont move to any other setting. Its a 2003 town and country.


The controller that changes the output of the air is run by vacuum. There might be something that fell in the heater from the defrost vents or it could be a vacuum leak, broken lever, loose lever etc. To check this you need to get to the plenum. It is behind the glove box.

Apr 14, 2013 | 2003 Chrysler Town & Country

1 Answer

2010 town & country ignition key will not release


Try rotating the steering wheel; it may be inline with one of the locks.

Jan 20, 2018 | 2000 Chrysler Town & Country

1 Answer

96 town and country wont turn over and shift indicator does not show park


It sounds as if your shift cable is out of adjustment. If you remove the air filter box and the hose at the throttle body you will be able to access the transmission shift lever, on top of the ******.Loosen the cable adjusting screw that is on the lever. Pull the lever all the way to its detent position which is Park. Release the parking brake and rock the vehicle to assure that it is in Park lock. Reset parking brake. In the cab, place the Shift lever in the Park position, return under the hood and tighten the cable adjusting screw. Your van will only start when the transmission is in Park or Neutral. Hope this helps! Dan Williams

Oct 29, 2011 | 1996 Chrysler Town & Country

1 Answer

My 2001 Chrysler Town & Country idles fine in park and nuetral and sounds good while reving. When I put it in gear it runs rough. I have read a few things on line and saw to check the idle control...


Hi. Thanks for your question. For assistance on any sound issuerelated to gear on Chrysler Town you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!

Feb 25, 2018 | 2001 Chrysler Town & Country

1 Answer

Ignitin switch will not move with key How do you you replace.... remove the old one


Before you do anything with the ignition key check the gear shift lever is not stuck in gear or there is no problem with the transmission. I am assuming you have an automatic transmission.

The gear position P sensor might be faulty. There is an interlock between gear shift and the ignition switch.

Mar 14, 2011 | 2000 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...