Question about 1999 Dodge Intrepid

1 Answer

Recently my 2001(chrysler)Dodge Intrepid has began to stall out while driving or idle at a stoplight. I took to a mechanic they mentioned something about No crank signal at PCM... co p0320. they said because the issue was abig area and hard to determine that we should keep driving till it gets worse. Just wanted to see if there is a solution as it seems to be dangerous to drive the car.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

The good news is the code you have is very fixable! There is a "Cylinder 2 Misfire Detected."(Cylinder 2 is the one first one on the right if you are in front of the car and are facing the engine). There are a few ways to try and fix it; 1st. Replace the spark plug with OEM Platinum Champion plug only (the car was designed around these plugs). Remove the two screws on the coil and the connector and pull out the coil. Swap plugs. Start the car and drive it a little, see if the problem persists. If it does then you will need to replace the coil which a new one will cost you apx. $120.00 or if you go to the junk yard it may be something you put in your pocket and leave.

After both attempts you should clear the code by going to your local part store and borrowing their OBD machine. If not unplug the battery for five min. The spark plug should work; the coils go out very rarely. If you have any questions you may email me at

Posted on Jan 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I recently changed the engine of my Chrysler Intrepid 2001 2.7 V6 with a Chrysler Intrepid 2003 2.7 V6 engine. The engine runs fine except that the 2001 engine had an EGR sensor but the 2003 does not ....

you can talk to someone a the dealer(service manager/tech)to see if they can reprogram the pcm so it recognizes there is no egr on this motor

Sep 08, 2011 | 2001 Dodge Intrepid

1 Answer

2003 dodge intrepid kicks out codes p0132,p0152 I have replaced all 4 O2 sensors,TPS, oil switch,crank sensor,computer and its causing my car to stall and turn off, backfire,and idle rough while parked ...


Apr 14, 2011 | 2004 Dodge Intrepid

1 Answer

2001 Chrysler 300M repeatedly stalling; mechanics can't replicate

well, the power steering will freeze when the motor is not running. the mechanic may not find what seems to be the problem specially when no warning lights are coming. you can try replacing the fuel cervo and this will surely help. not everyone knows about this.

Feb 02, 2010 | 2001 Chrysler 300M

1 Answer

2003 Caravan Idle/Stall

Sounds like to me your throttle positioning sensor is not set right. Try adjusting it or maybe a friend or take to a local mechanic.

Sep 23, 2009 | 2002 Dodge Caravan

1 Answer

Dodge Intrepid codes

could be a vac leak. what are the definitions for the codes??

Sep 21, 2009 | 2004 Dodge Intrepid

1 Answer

1999 3.2 Dodge Intrepid. Has had motor changed and can't read computer. Car dies at exit ramps and stoplights/signs.

It sounds like there is a fusible link blown under the hood. The link vary in location on chrysler vehicles but they should be near the computer.

Jul 02, 2009 | 1999 Dodge Intrepid

1 Answer

2000 dodge intrepid engine light on, power loss, rough idle

P0304 Cylinder 4 Misfire Detected P0354 Ignition Coil 4 Control Circuit P0204 Injector 4 Control Circuit You need to check injetror wires an coil wires .If good, The new coil my not be good.The Injector my be bad. If good it the ECM Check all fuses.

Jan 15, 2009 | 2000 Dodge Intrepid

1 Answer

Stalls right after start

This sounds like the starter solenoid needs to be replaced. I should say 'Is' the problem! Frankster016

Oct 18, 2008 | 1997 Dodge Intrepid

1 Answer

Wont shift out of lower gear

First thing I need to ask is when the filter & Fluid was last changed. If recently, Did they replace old fluid with ATF4 from Mopar/chrysler? Chrysler transmissions are very temperamental, especially with any other transmission fluid running in them, even though many mechanics, transmission places etc, may argue with me, it is a known fact. First, disconnect your + battery connection for a couple of minutes, then reconnect, and try that to see if it helps. If not, and fluid & filter haven't been changed in a while, I'd spend the money & have it done, but using only Mopar ATF4 from a Chrysler dealer.

Jul 06, 2008 | 2001 Dodge Intrepid

Not finding what you are looking for?
1999 Dodge Intrepid Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides