Question about 1991 Peugeot 405

1 Answer

Hello I have a car that sometimes ago I change oil gearbox. but the gear back light is lightening in all position of gear. please explain about this problem. thank you.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Peugeot Master
  • 6,982 Answers

Your post is really difficult to understand, but I think you are likely looking for the neutral safety switch (which generally also is part of the backup light system)
So, if I read it right, find that switch and you have found your problem.

Posted on Jan 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Gearbox not not changing up the gears while driving , it is a three speed with overdrive automatic can anyone shed some light on possible causes .

run the fault codes and check for problem servos/ solenoids or TCM
if the transmission is too old for that then change the transmission oil using a motor running change process ( changes the oil in the torque converter as well as the box) and then remove the pan , clean the filter and have he bands and clutch pack adjusted
older units rely on differentiating oil pressures and springs to move the valve spool in the body and any gum on the spool or weak springs make movement difficult

Oct 12, 2015 | Cars & Trucks

1 Answer

Gear shifting problems in Honda Prelude with Automatic transmission only when gearbox is cold

While just change ATF oil or CVT oil in transmission & old filter too. your car problem will be solve....

Nov 21, 2013 | 1998 Honda Prelude

2 Answers

Gear selection problem (Automatic)

sounds like you may have a problem with the TPS(throttle position sensor). the tps sends voltage to the ECM and TCM to control shift points. I would check the voltage on that sensor first to find out if the voltage is dropping out.

May 26, 2012 | 2000 Honda CR-V

1 Answer

Dsseay@yahoo.com2005 silverado 4wd 2500 truck wil not go into gear and the service 4 wheel drive light is on. The truck is stuck in neutral

Seems to be a faulty solenoid in the gearbox system by the sound of what you have explained. That could trigger a check engine light sometimes, please confirm if this is the case. I assume it is a electronic gear box system here and hence this is a common problem from what you have explained. If you have any question please do not hesitate to ask, I may take some time to answer but I will get back to you. Hope this helps.

Sep 21, 2011 | 2005 Chevrolet Silverado 1500HD

1 Answer

My ford focus is leaking oil think it might be gearbox oil,

Is the oil you see reasonably clean or is it black. The gearbox oil would be cleaner than the engine oil. Gearbox leaks would most likely come from one of the following:-
  1. Drive shafts
  2. Gear change lever inputs,
  3. Speedo cable
  4. Reverse light switch
  5. Drain plug
  6. Input shaft seal (inside the bell housing).
Pig a piece of paper under the car when you park it at night to give you an idea where the drip is located and inspect the area above that position

Jan 24, 2011 | Ford Focus Cars & Trucks

1 Answer

Epica 2006 automatic transmission problem

I'd check your motor mounts, sounds like the shifter is just misaligned, they're adjustale

Aug 11, 2009 | 2004 Chevrolet Aveo

2 Answers

When driving my bmw m3 when in automatic it jumps out of gear and the gear box light comes on,took it for diagnostic check it came back saying shifting operation signal too small please help. thanks

hello there

first step is changing the gearbox oil. Ignore the dealer if he spurts out the words 'life time oil'

Hope this helps, please don't forget to rate me.

Apr 15, 2009 | 2002 BMW M3

2 Answers

Type of oil to use on an xtype manual gear box

hi, you should only use the correct oil for this type of gearbox, available from the jaguar dealer, for the price of posibly damaging the gearbox with the wrong oil you may as well pay a little more from the dealer. regards mark.

Feb 11, 2009 | 2003 Jaguar X-Type

1 Answer

Gearbox sometimes take a while to go into drive

if it is hard to shift when the vehicle is cold chances are that the oil in the gear box is too thick take it to a shop and try using a thinner oil than what is in the gear box and this will eradicae your problem

Dec 02, 2008 | 2002 Jaguar X-Type

Not finding what you are looking for?
1991 Peugeot 405 Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides