Question about 1988 Jeep Cherokee

1 Answer

Need parts diagram for steering column on 88 Jeep Cherokee Limited

I need a parts breakdown diagram for the steering column, turn signal, wipers, tilt, etc.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 2,474 Answers

You can get great diagrams from AA1CAR.COM all are free i my self have had great results

Posted on Oct 29, 2012


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 277 Answers

SOURCE: Steering column diagram needed for 1989 Jeep Cherokee

If you intend to keep the vehicle long term, I would suggest you invest in a Haynes Manual, That is worth its weight in gold, for this and any other project..

Posted on Aug 29, 2009

  • 126 Answers

SOURCE: 1994 jeep cherokee steering column housing removal

there is a small round spring clip on the 3/4'' steel shaft almost hiden by metal plate push down on plate with plate pushed down have a trusted friend carefully remove steel spring clip with a small scriber or similar careful not to poke friend with tool good luck with this project

Posted on Jun 30, 2008

michigan man
  • 3533 Answers

SOURCE: 1991 jeep cherokee sport tilt steering wheel is wobbly

if it was me I would go to a salvage yard and get another steering column drop it off at a lock with your key from the old one so they can match that key to the other ignition switch

Posted on May 02, 2009

  • 1144 Answers

SOURCE: I need to change the turn signal assembly on a 1989 jeep wrangler

This is a big job you better be prepaired for a long time doing it if u are not familiar with doing is hard to do.but if u are mecanical u can do it

Posted on Jun 10, 2009

  • 17970 Answers


ZJ Jeep Grand Cherokeeat 1993 to 1995, so this documents can be help: ZJ-Secc-8W-Wiring-Diagrams

Good luck!!!

Posted on Aug 05, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 91 jeep cherokee limited. when i first bought it the bolts in the steering colomb to the tilt were loose. so i had a buddie tighten em up for me. well he pinched a wire in there and my tail...

Not very likely the whole vehicle would need to be rewired. But you'd pretty much have to strip down the steering column to find everything and to check the tilt apparatus for worn parts. I would check the price of a steering column for your Jeep from a salvage yard and then decide how to go- at full steam ahead. Good luck, Chris.

Jun 25, 2012 | 1991 Jeep Cherokee Limited

2 Answers

Need to replace signal light flasher can not find old one

The turn signal flasher and hazard units are usually located located under the dash either to the left or right of the steering column on most models:
  1. Remove the turn signal flasher unit or hazard unit by pulling them up from the electrical connection.
  2. To install, push the unit(s) into the electrical connector.
Also, I suggest check your repair manual in this link: Jeep ZJ-Secc-8W-Wiring-Diagrams

Hope helps (remember rated this).

Jul 02, 2010 | 1994 Jeep Grand Cherokee

2 Answers

Need to remove ignition switch on a 1990 jeep cheeroke

Remove lower instrument panel trim. remove 2 steering column to dash/brake support nuts and lower steering column. remove screws holding ignition switch to column and lift switch off of lock rod. first remove black harness connector, then remove white connector from switch.

Apr 10, 2010 | 1990 Jeep Cherokee Limited

1 Answer

How do you remove/replace wiper switch on 1995 jeep grand charokee

Disconnect and Isolate Negative Barrety cable. Remove screw in bottom of steering column shroud cover. ( bottom side of steering column between wiper switch and turn signal switch) Unsnap shroud halves and remove from column. Disconnect wireing harness connector from multi function switch. Remove 2 screws securing switch to mounting housing. Install in reverse order.

Oct 25, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Windshield wipers

i had the same problem and it was the turn signal/wiper switch on the steering column had burnt out the wires that control low,

May 23, 2009 | 1996 Jeep Grand Cherokee

1 Answer

1991 jeep cherokee sport tilt steering wheel is wobbly

if it was me I would go to a salvage yard and get another steering column drop it off at a lock with your key from the old one so they can match that key to the other ignition switch

May 02, 2009 | 1991 Jeep Cherokee Limited

1 Answer

2001 jeep grand cherokee laredo

The lights are designed to come on when you activate the wipers, this is because most often, state law dictates that you turn your lights on while driving in the rain, no matter the time of day.  This way you don't have to remember to turn them on. The turn signal switch is a multifunction switch which is comprised of the headlights, wipers, turn signals and all the other stuff that is controlled via the stalks and switches that are mounted on the steering column, you can check with your local auto parts store to see if they can get the assembly from an aftermarket source, this will be cheaper than the dealer.  Also you can check eBay for new and used ones.  Get a part number by calling the dealer about the part and see whats available online.  Also is an online site that sells direct from the dealer but at a deep discount, the parts are mailed to you.  Best of luck!

Dec 17, 2008 | 2001 Jeep Grand Cherokee

1 Answer

Steering column diagram

Go to a ford dealership parts department and ask them to print out a parts breakdown off their computer.

Jul 14, 2008 | 1996 Ford F250 Crew Cab

1 Answer

Wiring for Wiper system

most likley the whole switch assembly needs to be replaced.You cant repair just the wiper.

May 24, 2008 | 1988 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides