Question about 1997 Jeep Grand Cherokee
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2002 jeep cherokee laredo
the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.
Posted on Aug 10, 2008
there are many sensors and and each airbag have sensors so you will have to get it scanned to know where to start. just a note air bag parts can be very expensive so check out your local salvage yard. they can save you hundreds. good luck
Posted on Sep 28, 2008
Check this link & scroll down to your engine. Click on picture to expand.
Posted on Feb 03, 2009
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input Print this code data Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Posted on Dec 01, 2009
P0137 - Oxygen O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)
Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.
Symptoms: There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.
Causes: A code P0137 may mean that one or more of the following has happened:
* Faulty o2 sensor Exhaust leak near the rear sensor
* Plugged catalyst
* Short to voltage on O2 signal circuit
* High resistance or open on O2 signal circuit
* Replace faulty sensor
* Repair exhaust leak near the rear sensor
* Check for restriction in catalyst and replace as necessary
* Repair short, open, or high resistance on o2 signal circuit
Hpe hti shelps (remember comment and rated this).
Posted on Jul 26, 2010
Tips for a great answer:
Mar 29, 2015 | 2000 Jeep Grand Cherokee
Sep 18, 2011 | 1997 Jeep Grand Cherokee
Dec 16, 2010 | 1997 Jeep Grand Cherokee
Sep 12, 2010 | 1997 Jeep Grand Cherokee
Jul 10, 2010 | 1997 Jeep Grand Cherokee
Jan 01, 2010 | 1997 Jeep Grand Cherokee
Oct 15, 2009 | 1997 Jeep Grand Cherokee
Dec 29, 2008 | 1997 Jeep Cherokee Country
Oct 24, 2008 | 1997 Jeep Grand Cherokee
170 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: