Question about 2000 Dodge Intrepid
NO POWER, ALOT OF NOISE. CODES: p1781 :p0760;p0755
Did you also find out that P0755 & 760 were shift solenoids B & C respectively? probably looking at replacing those. Chiltons are no help when it comes to trans work. Had a '99 LH car with a 3.2L also. Maybe look for a Service manual online, you know the ones for dealers.
Posted on Oct 29, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Dave, The P0700 code is a generic fault code indicating the the TCM (transmission control module) has recognized a problem and the P0755 is the indicated problem. I'd recommend you check your transmission external electrical connector for water intrusion and corrosion at the terminals by disconnecting the connector. If nothing appears wrong, I'd then recommend you drop the lower transmission pan and take a look at the residue deposit that is laying on the bottom of the pan. You should only see a relativily minor amount of grayish, black clutch material residing there. Pay particular attention for a gross amount of this or any large particular material, including any metal, either filings or chunks, or any brass or aluminum. If this checks out to be fairly clean, then I'd recommend you replace that "B" solenoid (2-3 shift solenoid) and have the trans. pan and filter replaced.; I'd also highly recommend you have the trans flushed for anyother particular matter that may reside internally inside the transmission. You'll have to have the codes cleared and the transmission relearned for shift feel, at that point.
Posted on Jan 08, 2009
P0304 Cylinder 4 Misfire Detected P0354 Ignition Coil 4 Control Circuit P0204 Injector 4 Control Circuit You need to check injetror wires an coil wires .If good, The new coil my not be good.The Injector my be bad. If good it the ECM Check all fuses.
Posted on Jan 15, 2009
SOURCE: transmission codes:
I WOULD TRY REPLACING THE INPUT SPEED SENSOR..A DEFECTIVE SPEED SENSOR CAN CAUSE ALL OF THESE FAULTS..IT IS LOCATED IN FRONT OF TRANS ABOVE SOLENOID PACK..IT IS THE ONE CLOSEST TO THE ENGINE..IT SCREWS INTO TO TRANSMISSION..A 1 INCH SOCKET FITS IT..ALSO CHECK WIRING TO BOTH SPEED SENSORS..A SENSOR IS ABOUT 35 BUCKS,AVAILABLE AT YOUR LOCAL DODGE DEALER..GET A NEW ONE AND YOU'LL SEE WHAT IT LOOKS LIKE..FAIRLY COMMON PROBLEM..HAVE REPLACED LOTS OF THEM
Posted on Jul 07, 2009
Tips for a great answer:
Nov 07, 2015 | Cars & Trucks
May 13, 2015 | 2001 Dodge Intrepid
Jul 26, 2012 | Plymouth Breeze Cars & Trucks
Jun 21, 2011 | 2004 Kia Spectra
Apr 27, 2011 | 2001 Dodge Grand Caravan
Automatic transmission, 42LE Initial Fill..........4.6 quarts 
automatic transmission, Total Fill
4 speed 42LE..........9.3 quarts
Differential, Front..........1.5 pints 
1. With ENG at operating temperature, shift through all gears. Check fluid level in PARK and add fluid as needed.
2. 42LE transaxles built after 7-26-99 fill to 3/8" (9mm) below fill hole.
Hope This Helps.
********Make sure that you use the recommended type flluid ATF+4, as there are several types available. Using the wrong type of fluid will damage your transmission********
Feb 26, 2011 | 2002 Dodge Intrepid
Jan 31, 2011 | Hyundai Santa Fe Cars & Trucks
Oct 14, 2009 | 2003 Dodge Caravan
Jul 17, 2009 | 2000 Nissan Maxima
410 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: