Question about 2005 Nissan Altima

1 Answer

Why did my nissan altima key stop working?

Both the dealer key and the key I got from Ace Hardware just stopped working, within about 2 weeks of each other. I'd like to know why so if it's something I'm doing I don't repeat the mistake.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 444 Answers

Is there lots of wear on the orignal key, If so that can cause a problem, Do they work to (Unlock) the car? If not you will need to go to a dealer or a lock smith , End get new keys cut for it.A good lock smith can allso (rectifry) What is going on, Why there not (Working)

Posted on Oct 28, 2012

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2003 Nissan Altima

Check your exhaust system, some bolts used to loose or gone on Altima 02-06. Especially check the bolt close to the joint between exhaust manifold and front pipe. Check if your sway bar rubbing your exhaust pipe.

Posted on Oct 17, 2008

  • 651 Answers

SOURCE: Non working brake lights in Nissan Altima

make sure the button is working, it may need to be replaced. with your foot off the brake peddle, it is on upper part of brake peddle arm. when you let off brake peddle it pushes button in to shut lights off. it may just be stuck in, spray a little lubracant on it if it's stuck and push in manually several times to loosen.

Posted on Dec 01, 2008

  • 21 Answers

SOURCE: Nissan altima 94 engine dies out and stops randomly

the distibutor on these models are notorious for going out and then working again more than likely your problem

Posted on Aug 05, 2009

  • 548 Answers

SOURCE: I have a 2005 Nissan Altima. The radio has

i would check the antenna connections

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Owners manual 2002 nissan altima key programming


Hi, there are many videos in youtube regarding key programming especially Nissan Altima. I've found the video for our Nissan Altima company car key a year ago.

Jun 03, 2016 | Nissan Altima Cars & Trucks

1 Answer

My 2006 Nissan Altima started skipping or a slight buck today and has off and off for a few weeks, but today when it did that, the engine light came on. The mechanic checked it and said it was the crank...


My 2006 Altima used to be HORRIBLE. The engine would sometimes be hard to start. Bucked like crazy. It would stall randomly if I was stopped or driving slowly (stopping or going for a light, while slowing down during turns). After a couple calls, over a period of months, checking for recalls they finally said there was a recall on the entire engine. Thank goodness my car was still under its 100K miles. Nissan fixed it, as they should. They also claimed the crank sensors needed to be replaced & that my engine mount was cracked. We just paid for all that b/c we were finally glad to have the engine problem resolved free of charge. Loooong story short, have your local dealer check for recalls.

Apr 17, 2013 | 2006 Nissan Altima

1 Answer

My. Nissan. Altima. 1998. Factory. Alarm. Is. Stop. The. Car. From. Start. How. Can. I. Get. My. Car. To. Work.


The factory immobilizers cannot be bypassed, you will need to take it to a Nissan dealer to get it fixed.

Mar 08, 2012 | 1998 Nissan Altima

2 Answers

2002 nissan altima revs up while idle


I had the same problem, you can replace both the acc band and the band tensor, the vibration comes from a loose band.

Aug 08, 2009 | 2002 Nissan Altima

2 Answers

Is there a way that I can reprogram a key fob from a 2003 Nissan Altima so that it works on another 2003 Nissan Altima?


yes u can and here is the procedure.
1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard
Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder
each time. If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press
the button more than one time in the above step. If the button is pressed more than one time, the programming
procedure will not be successful.


5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side
power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should
flash. Repeat this step for each transmitter (including any existing transmitters).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Jun 12, 2009 | 2003 Nissan Altima

1 Answer

2005 Nissan Altima cuts off while driving.


Dear Tajack73: Nissan had a voluntary recall campaign on the 2002,2005,2006 Altima's with the 2.5 litre engines It envolves reprogramming the ECM.
The campaign ID # RD0712 NHTSA #: 07V-527
2005 Altima Vin's 1N4AL11**5C 100003-957025
1N4AL11**5N 400000-934180

The symptom you have described fits the one they have describe in the bulletin. Check with Nissan and see if your car falls within the campaign. Let men know how you do.

Mar 29, 2009 | 2005 Nissan Altima

1 Answer

Outside temperature display on rear view mirror


Here are the instructions to reset flashing airbag light, the instructions are for an Armada but I believe it will work on all Nissan models of this period. It wont hurt to give it a try. If that doesn't work you may have a problem that should be looked at by your local Dealer.

>>>
1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

www.nissanhelpforums.com

Feb 28, 2009 | 2006 Nissan Altima

Not finding what you are looking for?
2005 Nissan Altima Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...