Question about 2001 Isuzu Rodeo

Open Question

Where is blower resistor on a 2001 rodeo - 2001 Isuzu Rodeo

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 13 Answers

SOURCE: Blower Motor Resistor for front AC/Heater

remove glove box....its in the casing near motor.....2 screws and 1 connector

Posted on Feb 15, 2009

Ad
  • 150 Answers

SOURCE: 1997 isuzu rodeo problems with the blower motor

You can test the blower motor by connecting a positive and negetive wire directly to the 2 terminals on the motor.
As far as the resistor goes. If the blower motor only works on high fan speed then the resistor is bad. If it works on all speeds except high, then the relay is bad. Good luck. Hope this helps.

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Locate the blower motor resistor on a 1999 dodge durango


most resistor blocks bolt to the fan housing, be causes its air cooled
and must be near fan actual so it always is cooled. see?
i just looked,its there. dead center blower case.(fsm book)
alldata.com
log in and read the HVAC pages.
if fan fails on high too, its not the resistor, because on high
it bypassed.
ah but not if the thermofuse in the resistor block is blown



604cabb9-976f-4de8-a869-e5716c072135.jpg

Jul 04, 2014 | 2004 Isuzu Rodeo

1 Answer

My lever that controls the speed of the ac/heat blower quit working. Sometimes the fan won't come on at all, then if I leave it on it will come on on its on. The lever doesn't work it anymore. I have a...


The blower motor has a resistor attached to it that probably has gone bad. When you use the fan select switch, power is sent through one of the resistor channels to control the speed of the blower motor.

You can test to see if the resistor is completing the ground circuit by connecting a wire from ground and touching it on one of the resistor terminals. If the blower motor comes on, then the speed control switch may be bad ( or the wiring harness is not making the connection). If the blower doesn't kick on, then try touching the ground wire on the negative side of the motor. The motor should rotate. If not the motor is bad. If it does rotate, the resistor is bad.

Apr 15, 2011 | 2002 Isuzu Rodeo

1 Answer

How do you remove the heater/blower on a 2002 isuzu rodeo?


See http://www.myisuzuparts.com Always replace the blower motor resistor with a new blower motor.

Jan 15, 2011 | 2002 Isuzu Rodeo

1 Answer

1997 isuzu rodeo blower will not come on relay is good


replace blower motor and resistor at the same time to fix it. The motor may work and may have to much resistance and an old motor will burn up a new resistor.

Apr 22, 2010 | 2000 Isuzu Rodeo

3 Answers

Subject: 2004 isuzu rodeo...my ac/heater blower is not working


The resistors are in circuit only on the lower fan speed settings.
On the highest speed setting, power is switched directly to the fan motor.
Check fan power supply fuses,
Check power is available to the fan when high speed selected.
If all above OK, apply power directly to the motor to verify fan motor runs- if it doesn't the motor may need replacement/repair.

Jul 29, 2009 | 2004 Isuzu Rodeo

1 Answer

Ac/heater blower motor issues


Replace the motor and resistor at the same time. A motor that has too much resistance will blow the resistor out every time. Been there done that. I've sold a lot of resistors and they had no warranty unless you replaced the motor too.

Jul 09, 2009 | 2001 Isuzu Rodeo

1 Answer

1997 isuzu rodeo problems with the blower motor and resistor how do you test them both


You can test the blower motor by connecting a positive and negetive wire directly to the 2 terminals on the motor.
As far as the resistor goes. If the blower motor only works on high fan speed then the resistor is bad. If it works on all speeds except high, then the relay is bad. Good luck. Hope this helps.

Jun 21, 2009 | 2000 Isuzu Rodeo

1 Answer

Blower Motor Resistor for front AC/Heater


remove glove box....its in the casing near motor.....2 screws and 1 connector

Jan 19, 2009 | 2004 Isuzu Rodeo

1 Answer

Isuzu rodeo 97, A/C no work if on number 3 only


try checking out your blower speed control resistors. follow your power wire from blower to the resistors, to locat, should be in duct in front of blower for cooling. I hope this helps, if the resistors pack is good only think else is a bad switch

Dec 19, 2008 | 1992 Isuzu Rodeo

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14381 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...