Passenger side mirror, power, 2003 mazda Protege needs replaced

Replace Your Car Passenger Side Mirror - How To - DIY ...

? 3:46
https://www.youtube.com/watch?v=77lBQ_CRqdo
Apr 10, 2012 - Uploaded by GregHint
See how even a novice can repair a passenger mirror on a FordEscape. ... Replace Your Car Passenger Side Mirror - How To - DIY .... Replace 2003-2008 Toyota Corolla Side Mirror, How to Change Install 2004 2005 2006
About 22,000 results (0.61 seconds) Search ResultsHow-To: Replace Ford Fusion side mirror (HD) - YouTube? 7:27https://www.youtube.com/watch?v=iGHeXUbvvJsMay 7, 2014 - Uploaded by Derrick HardingFord Fusion SEL 3.0 Liter V6 How to fix broken side mirrorIncludes: ... Published on May 7, 2014 ..... Great instructions - just replaced the driver's side mirror on my 2007 Fusion following your instructions. ... Front brake pad replacement 2006 - 2012 Ford Fusion Lincoln Mazda Pads Rotor Install Remove ...

Power window repair - Mazdas247

www.mazdas247.com > ... > Mazda Protege Forum > Protege How-To

Aug 8, 2005 - 10 posts - ‎10 authors

I have a 2002 and last week the driver's side power window died a horrible death. ... Check out my mods -> 2001 Mazda Protege LX aka Rum Runner ... My front pass sidewindow won't go up or down anymore. haven't taken ...


Passenger Window on 2007 CX-7 will not come up ...

2 posts

Nov 28, 2012


Driver's side window auto-up/down issues - Mazdas247

15 posts

Jun 10, 2011


Power Window Problem - Mazdas247

7 posts

Aug 9, 2009


Driver Side window controller won't work

14 posts

Nov 11, 2006


More results from www.mazdas247.com

2003 Mazda Protege 5 Replacing The Power Window Motor ...

? 7:02


https://www.youtube.com/watch?v=N3GP2UwTtAQ

Feb 3, 2015 - Uploaded by Steve K.

2003 Mazda Protege 5 Replacing The Power Window Motor and Regulator. Steve K. ... Looks like you just ...

Amazon.com: Dorman 741-741 Mazda Protege Fr

the blower motor is located under the dashboard on the passenger side. you will need to remove the glove compartment to have easy access to it

Usually you have to remove all the handles etc. from the inside. (The screws are covered with plastic plugs or similar.) Then the trimming is held by plastic or metal clips around the edges. Carefully pry the interior off and gain access behind.

I just fixed 2 of these on my son's car. We got 2 used operators from the pull-a-part auto wreck yard. We actually had the ones from the opposite side, so we uscrewed them (6 scres) and changed the nylon gear that usually has a broken shaft from operating in cold weather. Both work now. It takes more time to take off door panels and linkages, than to change the gear.

Hi:

The water pump is driven by the timing belt, which is on the passenger side of your engine. You would need to remvoe all belts, and then the timing belt cover, and the timing belt to change your water pump.

You will have to remove the inner door panel. There is a screw in the door handle and one on the bottom of the door panel and the you will have to pull up and out with the door panel. After you get the panel off you should be able to see the mounting bolts and wires for the mirror assembly. Careful with the door panel i am not sure on the number of screws in it. It will pull out hard but should go up easy.

If you go to the following site you will be able to select the type of mirror you need and request the part number for it but purchase it from the site itself. http://www.mazda-parts.com/partscat.html

Hope this helps.

yes you do the ones in question/ Please rate my response thank you very much

There are two bolts on the side of the fuse itself. Under the fuse box on each side. Unbolt those and it will come out.