Question about 2002 Jaguar X-Type

Open Question

02 jaguar x type code p1316 - 2002 Jaguar X-Type

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
firesnake09
  • 2923 Answers

SOURCE: i need a code to activate my radio on my 02 jaguar

Hello,

I wanted to help you with it, but no one could provide you the exact code for the radio because it is an anti-theft code. Anti-theft is a feature of the radio so that once the radio is removed from the car or if you remove or change the battery of your car, you could never use it unless you have the exact code.

Now, check the glove box of your car and there should be a card that has that code. If you couldn't find it, take the radio out, get the serial number of the radio and contact the dealer or the manufacturer of the car. Give them the serial number and they would provide you the activation code.

Best regards,

Firesnake09

Posted on Jul 28, 2009

Ad
  • 277 Answers

SOURCE: 02 Jaguar S Type - Heater blowing cold air

Has the vehicle overheated recently, if not there is a failure of the Coolant from engine valve controller, that measures flow through the Heater Matrix. Come back with more, as necessary.
Regards,DT

Posted on Aug 29, 2009

  • 202 Answers

SOURCE: obd 2 codes P0302-P0304-P0305-P1313-P1316 and

THE P0302 is misfire cyclinder 2,4,and 5
The P1313 P1316 is Cyclinder compressor low, Worn camshaft/ broken valve springs. Fuel injector contamination, Spark plug failure/ incorrect gap. Iginition coil failure.
P0778 is 2/4 Brake prssure solenoid failure

HOPE THIS CAN HELP.

Posted on Apr 09, 2010

creg_912
  • 196 Answers

SOURCE: 2003 x-type codes help. P0037,

DTC P0037; RIGHT-HAND CATALYST MONITOR SENSOR HEATER CONTROL CIRCUIT LOW/HIGH RESISTANCE
DTC P0300; RANDOM MISFIRE DETECTED, MISFIRE DETECTED, PRIMARY CIRCUIT MALFUNCTION
DTC P0305; RANDOM MISFIRE DETECTED, MISFIRE DETECTED,
P1316 IS A MISFIRED OF A CATALYST FOR EX.SPARK PLUG,INJECTOR PRESSURE ,IN GENERAL ITS THE MISFIRED DRIVE CYCLE ...SOMETHING IS FIRING PROPERLY..LET ME ASK HOW MANY MILES DO YOU HAVE.?AND CODE P1111 IS NOTHING TO BE WORRIED ABOUT ITS THE SYSTEM READINESS TEST THAT THE CARS ECM PERFORMS WHEN YOU CUT IT OFF EACH TIME...MAKES SURE THAT ALL IS FUNCTING WELL.

Posted on Aug 12, 2011

  • 279 Answers

SOURCE: 2003 x-type codes help. P0037,

Go to http://www.bluejag.co.uk/diagnosticcodes.php to get a good description of the problems. Looks like a fault on cylinder 5 to me Ignoring P1111 which dosn't matter at the moment, could be ignition coil, plug, injector etc unless there is anything else obvious in that area. (when were your plugs last changed?)

Posted on Aug 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code 1251 jaguar x type 02


that code is a code used by jaguar for test purposes and should not put a warning light on its allways present in the obd11 system, have you got a warning showing?

May 24, 2017 | Jaguar Cars & Trucks

1 Answer

Jaguar 2002 xtype runs perfectly. Engin light is on showing codes p1111 p1316 and mis fire cylinder 1 3 5


remove the air filter housing check the wiring has not rubbed through on the metal filter holder mounting common problem.or water ingress in the engine control module/connector the plugs/on plug coils are also troublesome but 3 on the same bank is unlikely to go bad at the same time good luck

Feb 02, 2017 | 2002 Jaguar X-Type

1 Answer

How can i fix code p1316 ?


You must perform the diagnostics for the code and then select which comp[onent is defective, the part itself, the wiring to it or the control module.

May 06, 2014 | 2005 Jaguar X-Type

1 Answer

Ford code p1316


ford code p1316 is IDM problem ( injector driver module)
the IDM operates as 2 banks of injector drivers ( right and left and can cause one bank to shut down as if driving a 4 cyl
there are forum statements which say that there is a problem with wiring and clips inside of the rocker covers or broken wires
check that the harness and wires to the unit are tight
suspect that the module may be in an area that is near the transmission and the wires may have been disturbed
I went google and typed in--- ford fault code p1316 and there are videos and forum sites that will help you
code p 0562 refers to system voltage --low===causes ---wiring---poor connection--battery---alternator
also refers to ECM power relay control--circuit open wiring ---ECM relay
check that all harness connections were put back properly after the transmission job
code p 0231 refers to fuel pump relay---circuit low ===causes --wiring short to ground --fuel pump relay---ECM

Apr 13, 2017 | Cars & Trucks

1 Answer

P1316 jaguar x type 2.5


If it is a Jag, the misfire rate exceeds Emissions, if it is an ACURA, then it is a spark monitoring problem in the front on bank 2.

You question for the Jag was listed under Acura. I gave you both answers.

Nov 01, 2012 | Acura Cars & Trucks

1 Answer

2003 x-type codes help. P0037, P0300, P0305, P1111 (pend), P1316. Any help with explaining these codes will be much appreciated. Thanks


Go to http://www.bluejag.co.uk/diagnosticcodes.php to get a good description of the problems. Looks like a fault on cylinder 5 to me Ignoring P1111 which dosn't matter at the moment, could be ignition coil, plug, injector etc unless there is anything else obvious in that area. (when were your plugs last changed?)

Aug 11, 2011 | 2003 Jaguar X-Type

1 Answer

2003 x-type codes help. P0037, P0300, P0305, P1111 (pend), P1316. Any help with explaining these codes will be much appreciated. Thanks.


DTC P0037; RIGHT-HAND CATALYST MONITOR SENSOR HEATER CONTROL CIRCUIT LOW/HIGH RESISTANCE
DTC P0300; RANDOM MISFIRE DETECTED, MISFIRE DETECTED, PRIMARY CIRCUIT MALFUNCTION
DTC P0305; RANDOM MISFIRE DETECTED, MISFIRE DETECTED,
P1316 IS A MISFIRED OF A CATALYST FOR EX.SPARK PLUG,INJECTOR PRESSURE ,IN GENERAL ITS THE MISFIRED DRIVE CYCLE ...SOMETHING IS FIRING PROPERLY..LET ME ASK HOW MANY MILES DO YOU HAVE.?AND CODE P1111 IS NOTHING TO BE WORRIED ABOUT ITS THE SYSTEM READINESS TEST THAT THE CARS ECM PERFORMS WHEN YOU CUT IT OFF EACH TIME...MAKES SURE THAT ALL IS FUNCTING WELL.

Aug 11, 2011 | 2002 Jaguar X-Type

1 Answer

Code p1313 p1316 p1111 p0301 means what?


Odd one this to have P1111 as well.

According to my data P1111 is all dtc checks compleated, http://www.bluejag.co.uk however some websites show it as a Intake Air Temperature (IAT) Sensor Circuit Intermittent High Voltage, I'm fairly sure that the latter is incorrect.

check the basics first plugs, leads, corroded ground connections etc then its a bit of a guessing game


As for the other codes

P0301 = Misfire detected - cylinder 1
P1313 = Misfire rate catalyst damage - bank 1
P1316 = Misfire excess emission


Possible causes (as per JTIS):

Cylinder compression low
Worn camshaft / broken valve spring(s)
Fuel delivery pressure (low / high)
Fuel injector(s) restricted / leaking
Fuel injector(s) continuously open
Fuel contamination
Fuel injector circuit fault(s)
(Injector DTCs also flagged)
Spark plug failure / fouled / incorrect gap
ECM to ignition coil primary circuit fault
(Cylinder misfire detected DTC also
flagged)
Ignition coil failure

hope this helps

Mar 13, 2011 | 2002 Jaguar X-Type

1 Answer

Obd 2 codes P0302-P0304-P0305-P1313-P1316 and P0778 2002 Jaguar X type 3.0


THE P0302 is misfire cyclinder 2,4,and 5
The P1313 P1316 is Cyclinder compressor low, Worn camshaft/ broken valve springs. Fuel injector contamination, Spark plug failure/ incorrect gap. Iginition coil failure.
P0778 is 2/4 Brake prssure solenoid failure

HOPE THIS CAN HELP.

Apr 09, 2010 | 2002 Jaguar X-Type

2 Answers

Misfire


Well, the P in the code means powertrain.  As far as the code specifics, 
P1313 Misfire Rate Catalyst Damage Fault - Bank 1
P1316 Misfire Rate Exceeds Emissions

I would say check your spark plugs and wires.  

Mar 18, 2009 | 2004 Jaguar X-Type

Not finding what you are looking for?
2002 Jaguar X-Type Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...