Question about Toyota Yaris

Open Question

07 yaris--steering is making noise when turning steering wheel

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hotrodtod38
  • 141 Answers

SOURCE: creaking noise from front wheel

BALLJOINTS OR CVC JOINTS ?

Posted on Feb 13, 2009

dennymulford
  • 1055 Answers

SOURCE: the power steering makes a chirping noise at the

its your cv joint

Posted on Feb 21, 2009

  • 3 Answers

SOURCE: Noise when turning the steering wheel

Sounds like a Power Steering Whine to me. Simply check your power steering fluid. If it is low, there is a leak somewhere. If not it's possible the pump may be on it's way out.

Posted on Feb 23, 2009

  • 107 Answers

SOURCE: power steering went out and making a loud noise when turning.

yes power steering is most likely very low , repair leak , as the fluid is flameable

Posted on Feb 27, 2009

  • 6 Answers

SOURCE: steering wheel makes a noise and it is getting hard to turn

DID YOU TRY ADDING POWER STEERING FLUID?

Posted on Apr 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 Malibu when turning the steering wheel left our right it makes a noise like a bad bearing grinding


-Possibly Time to replace new CV shaft or bad bearing.
Check and replace it.

Good Luck


Mai Lor

Aug 16, 2017 | Cars & Trucks

1 Answer

Toyota yaris power steering problem


It usually happens immediately after replacing the battery. Check and delete the power steering codes with scan tool.

Sep 19, 2012 | 2007 Toyota Yaris

1 Answer

07 Yukon making a ratcheting noise when I turn and the rack and pinion is moving about 3/4 inch back and forth when I turn the wheel


there is a intermediate steering shaft that is common to make noise between the steering colum and the rack

Jun 09, 2012 | Cars & Trucks

1 Answer

2008 Toyota Yaris loud clicking noise only when making hard corners with the wheel fully turned right or left. The noise stops immediately as soon as I beginning pulling the car back to a straight...


This is the most common reason for the noise. It can be checked by removing the tire and trying to move the axle shaft. If there is play in the shaft it will be a good chance that the CV joint is bad. If there is no play, you can turn the wheel hub with the car still in the air and try to pin point the area the noise is coming from. Be careful and make sure the car is supported well before you try to move thins around too much. Cars will fall off the jack if they aren't supported.

Sep 23, 2010 | 2008 Toyota Yaris

1 Answer

I have a whistle or humming noise from the front of 05 Montana.


Put wide tape on different areas of the windshield edge as a test to see if the noise changes.Then you may know where the noise originates and can correct the noise.
Just by chance,it is a wind noise? and not a front wheel bearing going bad?which is common on these vehicles and can create a humming at different speeds.Next time when the hum shows up turn the steering wheel slightly left and right at road speed and if you can change the hum,it's 99% a wheel bearing.

Apr 02, 2017 | 2001 Pontiac Montana

1 Answer

Automatic engine immobilizer wo'nt reset


The immobilizer does not "lock" the ignition, it does not energize the fuel injection relay. What you have is a "locked" steering column. Put the key in the ignition, and pull/turn the steering wheel HARD left or right, whilst turning the key to on or start. Do BOTH at the same time.The action of you pulling on the steering wheel will unlock the steering column.

Dec 21, 2008 | 2008 Toyota Yaris Sedan

2 Answers

2004 Toyota Yaris


check all the fuses im sure the fuse burn after disconnect the battery for a minute and hook it up and go try it good luck pierre p.s let me now owe thing turn out

Sep 30, 2008 | 2008 Toyota Yaris Sedan

1 Answer

CLUNKING IN STEERING WHEEL AT FULL STOP AND TAKEOFF.


Design issue with vehicle. redesign of i-shaft by nov or dec 08.
GM knows its the design of there vehicle.

R/R I-Shaft. See bulletin
TSB No.: 060235009
NHTSA No.: 10020815
TSB Date: June 1, 2007
Date Added to File: January 22, 2007
Failing Component:
Steering
Summary:
Power steering clunk, noise or rubbing feel while making turns at slow speeds, column, intermediate shaft, intermittent. Updated 08-15-07.

Jul 31, 2008 | 2008 Buick Lucerne

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...