Question about Ford Taurus

Open Question

Location of oxygen sensor on a 2007 ford taurus

Car is running very slugish rpm's are down when driving.I'm hoping it's just the oxygen sensor which was 1 of my many codes.I also have a bad lifter or rocker arm,I let the car get too low on oil.loud ticking noise.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2920 Answers

SOURCE: oil light came now lifters are ticking.

im afraid you are going to be stuck wih the ticking,,,i had a ford taurus that did the same thing and it never did stop even after we changed out the oil pump

Posted on Dec 06, 2008

Ad
czaa
  • 4525 Answers

SOURCE: 2007 Ford expedition won't start

ur oil pump may be failin-there r sensors everywhere on new cars-keepin u from starting as safety measure-computer systems r complex n things dont always show on 1 scan-they kinda hav the mindset of a pc

Posted on Sep 15, 2009

Testimonial: "Thank you. I have spoken with 2 other mechanics who said the same thing regarding the oil pump. It's being looked at. So I'll post more once I know"

  • 407 Answers

SOURCE: loud ticking noise from right side of motor. not a

is it the 4.7L engine

Posted on Oct 13, 2009

  • 67 Answers

SOURCE: 2001 saturn sc2 rocker arm suspected

Rocker arm shaft to head torque is 19Ft-lbs

Posted on Feb 12, 2010

  • 92 Answers

SOURCE: how to solve engine lifter tick noise

Get the heads worked on or replaced it might need a valve lashment.

Posted on Jul 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 04 ford torus rpm keep moving up and down


Check for vacuum leaks,everywhere on the car

The throttle is moving for a reason,the O2 Sensor
is telling the computer about changing oxygen content
it sees,so the PCM is moving the idle to adjust fuel trim

Find out why

Look at data with scanner

Feb 20, 2013 | 2004 Ford Taurus

1 Answer

See a visual diagram of heat oxygen sensor bank 1 sensor 2 for ford taurus 2001


bank 1 exhaust is the rear manifold towards the windshield side. Follow the exhaust down. There should be one oxygen sensor before the catalytic converter and a monitor after the catalytic converter. Be Careful.. they look the same.

Nov 26, 2012 | 2001 Ford Taurus

1 Answer

2006 Ford Taurus code P0152


Common Problems That Trigger the P0152 Code
  • Defective Oxygen Sensor
  • Faulty Oxygen Sensor wiring or connections
  • Shorted Oxygen Sensor Heater element(s)
Common Misdiagnoses
  • Oxygen Sensor is replaced when the problem is faulty Oxygen Sensor wiring or connections
  • Oxygen Sensor is replaced when the problem is an over-reporting Mass Air Flow Sensor, clean mass air flow sensor first, to see if thats the problem. good-day ! just type this in search on pc. 02 sensor symtoms, and it will give you the details of a bad sensor.

Apr 27, 2012 | 2006 Ford Taurus

1 Answer

RPM gage 2005 Ford Taurus fluctuates or just dies


the rpm gage dont go the the trans its hooks up the the motor so your trans dont have anything to do with the rpms

Mar 30, 2017 | 2005 Ford Taurus

1 Answer

Car runs intermittenly


Try unplugging the mass air flow sensor. It's located on the air intake. If it runs fine without it, it's bad sensor. It basically boils down to is it getting spark, or is it getting fuel. Typically one is lacking. Also when is the last time you changed the fuel filter? They typically need replaced annually or two years depending on how much or little you drive the vehicle.

Dec 26, 2011 | 1999 Ford Taurus

1 Answer

Speedometer stops displaying then the car runs very erratic... pull over and stop... the problem goes away, continue driving for a while then problem comes back


Your car is equipped with a speed sensor. When this sensor goes out it will cause the vehicle to run erratically and shift up and own at all the incorrect speeds and RPM's. Have your speed sensor checked. I'm sure that is the problem.

Sep 02, 2011 | 1998 Ford Taurus

2 Answers

I have a 2000 ford Taurus that putts at idle, but not at acceleration. Car stalls when not warmed up. I have to keep my foot on gas pedal to keep car from stalling when warming up. I've had oxygen...


There is an idle control valve in the air intake circuit that gets dirty. Ford says not to clean this valve but to replace it. However cleaning seems to work for me.

Aug 04, 2011 | 2000 Ford Taurus

1 Answer

Where is the oxygen sensor on 1997 ford taurus wagon 3.0


Single or double overhead cam type engine? In any case, these are the locations listed below.
  • Up-stream sensor (located before catalytic converter)
  • Left up-stream sensor (located before catalytic converter)
  • Left down-stream sensor (located after catalytic converter)
  • Right up-stream sensor (located before catalytic converter)
  • Right down-stream sensor (located after catalytic converter)

May 04, 2010 | 1997 Ford Taurus

1 Answer

2000 ford taurus keeps blowing fuse#28 in the engine compartment


The heading says2000 taurus and 1999 taurus. I looked up the wiring for a 1999 taurus. Fuse #28 goes to the heated oxygen sensors and the canister vent solenoid. You have 2 oxygen sensors (green connectors)and 2 catalist monitors(blue connectors) that use this fuse for the heaters that are in the sensors. I would check these sensors to see if any of their wiring is shorted. I have seen in the past where oxygen sensor wiring would rub on a front drive axel and wear thru the wire insulation causing a short. You really need to look at all 4 sensors and their wiring closely for shorts. If they look ok then disconnect all of them and reconnect 1 by 1 until fuse blows again. Fuse #28 also powers the canister vent solenoid which is located under the trunk (under the car) in a black plastic housing (approx 1ft by 1ft). It is the only item with wires going to it. If you disconnect this and the fuse stops blowing then it is shorted. Also check the wiring to see if it rubs or is shorted anywhere.
Hope this helps

Apr 07, 2010 | 1999 Ford Taurus

2 Answers

Location of the oxygen sensor


there are two O2 sensors on this engine. Both are mounted in the exhaust just past the exhaust manifolds. You will be able to replace them without a lift. You will probably need an O2 socket to remove them. They usually are in pretty tight.

Jan 04, 2009 | 1995 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...