Question about Nissan Cars & Trucks

1 Answer

Front indicators dont flash

The lights are on but wont flash, hazards dont flash, rear indicators work, and the indicator arrows in cab blink double speed

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 5,368 Answers

Quick flashing is usually a burnt out bulb.

Posted on Oct 28, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: vw golf 1994 indicators

Hi,

Most Golf and Jetta have their relays bunched together with the fuse block. Often, it would be inside the fuse box/compartment located under the facia panel, on the right-hand side, behind a removable cover. On most models, the flasher relay would be labeled 21.

Incidentally, sometime ago, there was a recall on some Golf where Volkswagen dealers will install a new hazard flasher switch/relay kit to remedy a common issue. You may want to try first Volkswagen at 1-800-822-8987.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 07, 2008

j_del
  • 1586 Answers

SOURCE: Flashing Unit for Indicators Replacement

Most likely it's the hazard switch - the relay for the hazards and the turn signals is built into it. When they start to die, you will see erratic behavior with the turn signals and/or hazards, and eventually they'll both fail completely. Replace your hazard switch on the dash and you'll be good to go.

Posted on Aug 31, 2008

  • 1 Answer

SOURCE: HAZARD LIGHTS ON BUT NOT

HI,
I have the same problem - it is the relay switch attached to and behind the hazard warning triangle on the dashboard. Pull it all out (gently and replace (£60 ish). The indicators and hazard lights are on the same relay circuit. This is a well known problem for this car (amongst others - how about the wipers sticking)

Posted on Nov 25, 2008

bunnydawg
  • 5158 Answers

SOURCE: Indicators not flashing on Audi TT

i believe the audi uses two relays for the turn signals and hazzard lights so it would appear the turn relay has failed. it should be located under the dash near the steer column.... seems to me me they have some shielding under the dash so it may be hard to get to.

Posted on May 23, 2009

  • 1986 Answers

SOURCE: Indicator Problem

when you noticed the indicator being on solid, but flashing with the hazards, are you inside your car? I mean have you gotten out of your car to check if the bulbs are working when the indicator thrown and when the hazards are on. A hard on indicator usually means that you have a bulb burnt out. The hazards will still flash as normal when inside the car even if a bulb is burnt out because the hazards do not run via the Electronic Flasher Module. The EFM is what detects a burnt out bulb

Posted on Aug 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alpha Romeo 156 My Left hand indicator light stays on continually, does not flash. and when I turn the hazard light switch on both indicators continually glow.


Generally speaking, symptoms of a bad or failing turn signal bulb are usually the culprit...in your case, either it's the front left or rear bulb. Varies for different vehicle makes...common signs include:
  1. turn signal light staying on solid
  2. or blinking very fast
  3. or either sides of the bulbs stop blinking altogether.
To test this, make sure you reconnect everything you disconnected.
Turn the left signal light on; go to the front of the vehicle, is the turn signal bulb illuminated? If it lights up, even though it is not blinking obviously the bulb is okay. If it doesn't, replace it- problem solved. You'll do the same procedure for the rear turn signal Is that lit up? If not replace the bulb and the problem is solved.
Another common failure is when the turn signal blinks really fast, same procedure as mentioned above.
If both bulbs for the left side and right side illuminate but don't blink, the problem is in the steering column turn signal switch.
If the left or right side blinkers don't work properly at all...then check the integrated hazard warning/turn signal flasher relay- that may be defective; again, that's usually the case if both sides of the signal light don't work.
If you are blowing any fuses related to the flasher system, you have an electrical overload in the turn signal circuitry.

Feb 12, 2017 | Cars & Trucks

1 Answer

Left rear turn signal, rear hazard lights not working


You will be needing a good electric meter.
With the key on and the turn signal activated, test the leads inside the light socket and see if electricity is getting to the bulb.
When you mentioned it flashes really fast, that says one of the bulbs is not working.
Although it could be burned out, it could also not be making contact, or the ground wire could be bad.
Since the early '80's, cars and trucks have had separate ground wires to each and every bulb and electrical component, and a bad ground will cause this problem also.
Remember, a bulb can look good and still be no good.
God bless your efforts.

Apr 19, 2016 | 2007 Ford Freestyle Limited

1 Answer

The indicator lights are all stuck on. AU Ford station wagon. Removed relay, and all fuses, but still on. Disconnected battery and they turned off. Reconnected battery and they all came back on with no...


The AU ford has two indicator relays , turning lights and hazard lights ,both use the indicator lights ,the hazards flash both front and rear lights , the turning indicator flashes one front and one rear light. I think the fault may be in the hazard circuit.

Feb 25, 2015 | Ford Cars & Trucks

1 Answer

Left indicator lights not work


blinking fast indicates a bad bulb on that side. try front and back bulbs

Sep 07, 2013 | Volkswagen Passat Cars & Trucks

1 Answer

I have an 02 kia sportage. my signal lights come on but dont blink outside. no lights for the signal lights come on on the dash at all. also, no hazard lights.


If the 15A HAZARD fuse in the passenger compartment fuse box is OK, power is getting to the hazard function of the flasher unit. Pressing the hzard switch should cause the hazard lights to flash. HOWEVER, there is an electronic time and warning indication system module connected to to the hazard switch lead and that may be affecting things. If the 10A TURN fuse is OK, power is applied to the turn switch (with the engine in START or RUN) and you state you can select a right or left turn. HOWEVER, the RED/WHT and RED/BLU outputs from the flasher unit connect directly to the front and rear turn lamps and the instrument cluster turn indicators so you are not getting any flasher output. Again, that electronic time & warning indication system module could be affecting things

Oct 26, 2012 | Cars & Trucks

1 Answer

The blinker indicators inside blink super fast. the front ones work fine, nothing with the rear ones. same thing wiht the hazards-the fronts flash but not the rear.


They blink fast because there is not enough load on the system a bulb or two are out replace the two rear bulbs if they are not flashing

Sep 18, 2011 | 2005 Chrysler Pacifica

3 Answers

I have a 98 chev cavalier z24. Both indicator


Sounds like the signal multi-function switch has a short it it. Get a new one.

Feb 02, 2010 | 1998 Chevrolet Cavalier

1 Answer

Turn signals and foglight problem


hiya from uk the rear fogs and front fogs will only work when head lights are on also this is the correct operation re if weather conditions warrant use of fog s then you should req head lights ? if you understand ? as for indicators/hazards this problem is more than likely the relay switch is at fault ? this relay on most modern cars is the hazard lights switch which is a combined indicators and hazard lights relay unit try a replacement or price a new unit hope this helps ?

Jan 18, 2009 | 2002 Volkswagen Eurovan

1 Answer

Indicator issue


It could possibly be that one of the indicator bulbs has broken , when this happens there is a higher voltage drop going through the remaning bulbs which makes them blink faster.
Try switching on your hazards and walking around to see if all the indicator bulbs are working.

Jan 15, 2009 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...