Question about 1991 Buick LeSabre

1 Answer

My heater fan does not come at all on any speed

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers

If your blower motor is not working on any speed then the blower motor itself is faulty. If it was working on hi speed only then it would be the resistor. Hope this helps..

Posted on Oct 28, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater fan how to change it? for a kia sportage


the problem might the fan resistor which is what regulates and selects the different fan speeds for heater and aircon

Mar 15, 2016 | Kia Sportage Cars & Trucks

1 Answer

My 1991 isuzu trooper heater blower fan is not working, nor when i turn it to the airconditioner the compressor does not engage. i checked all the fuses except the ac relay fuse block, what could the...


if the lower fan speeds dont work but the fastest speed does the heater fan resistor block needs replacing. If the highest fan speed doesnt work leave it on there and check for power at heater blower fan, if power is on one wire and the other is an earth the blower motor fan needs replacing. Use a normal globe test light to check this. If no power on any wires to fan go back and check all fuses in car and under bonnet with same test light. If fuses are ok possible open circuit wire to fan.

Jan 13, 2011 | 2004 Isuzu Rodeo

1 Answer

Low speed on heater fan does not work. All other


You will need to inspect and test the speed control resister and the speed control knob first. What have you done so far?

Apr 22, 2010 | 2002 Chevrolet Silverado

1 Answer

Heater fan blower only functions on high speed?


the resistor for the blower motor is faulty, its either integrated into the switch (speed selector) or its on the firewall somewhere, where ever it is, it has to be replaced.

Mar 12, 2010 | 1997 Volkswagen Jetta

1 Answer

BWM heater problems--display and switches working but no fan


your fan speed regulator located on your heater core box is bad if its just one or some of the speeds. if the fan does not work at all its either a bad connection to your fan speed regulator or the fan motor has quit. out

Jan 26, 2010 | 2000 BMW 3 Series

1 Answer

Heater fan


Your fan technically only has one speed. The voltage is decreased by the use of a resistor pack to produce the slower fan speeds. If this resistor pack burns out, it will leave you with only the high setting. You can find the resistor pack located under the hood, on the passenger side on top of the fan housing.

Dec 15, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

MY heater fan quit working the fan motor is good and the fuses or good


Not sure on this vehicle, but you may have a bad resister block on heater housing that control fan speeds. If not, perhaps the fan speed switch went out in dash.

Dec 12, 2009 | 1998 Dodge Ram 2500 2WD

3 Answers

HEATER NOT WORKING IN 2001 LEXUS RX 300


you most likely have a bad airmix servo. this happens alot on these. they are expensive to replace too.

Sep 10, 2009 | 2001 Lexus RX 300

1 Answer

Heater/AC fan does not blow on two lowest speeds.


Your fan uses resistors to reduce the speed of the fan. Hi speed doesnt use the resistors and that is why it runs on hi. Standing in front of the car, all of your heater housing is on the left side of the firewall You will see a connection with about 4 wires That look like they go nowhere. Take the couple screws out and pull it out. You will be able to see the burnt one.Jump out the burnt on and that will give you another speed or two.

Oct 25, 2008 | 2003 Buick Century

Not finding what you are looking for?
1991 Buick LeSabre Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...