Question about 1993 Dodge Dakota

Open Question

Need trouble codes for a 1993 dodge dakota

Motor runs rough and sometimes will not start

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
hotratchet
  • 952 Answers

SOURCE: Trouble Code 3255

Hi,

Thanks for using Fixya!

1. Cycle the ignition key ON-OFF-ON-OFF-ON within 5 seconds. To cycle the ignition key ON means to turn it only as far as it takes to get the radio to come on. It does not mean to turn the engine on.

2. Count the number of times the "check engine" lamp on the instrument panel flashes on and off. The number of flashes represents the code. There is a slight pause between the flashes representing the first and second digits of the code. Longer pauses separate individual codes. For example, flash-flash-flash [pause] flash-flash represents the code 32.

A code of "55" represents end of error codes. If this is all you get then no error codes are stored in the computer. This is the normal condition for a neon.
CODE Description of Trouble Code
11 Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking
12 Direct battery input to PCM was disconnected within the last 50 key-on cycles
13 No change in MAP from start to run
14 MAP sensor voltage too low
15 No vehicle speed sensor signal
17 Closed loop temp not reached or engine cold too long
21 02s sensor problem (oxygen sensor), upstream or down stream
22 Engine coolant temp sensor out of range
23 Intake air temp sensor out of range
24 Throttle Position sensor out of range
25 Idle air control motor circuits, target idle not reached (+/- 200),vacuum leak found
27 Injector control circuit
31 Evap purge flow monitor failure or evap solenoid circuit
32 EGR system failure
33 A/C clutch relay circuit
34 Speed control Solenoid circuits
35 Rad Fan control relay circuit
37 Torque converter clutch solenoid CKT or park/neutral switch failure
41 Generator field not switching properly
42 Fuel pump relay control ckt, Auto shutdown relay control ckt, No ASD relay output voltage at PCM, Fuel level sending unit volts out of range, Fuel level unit No change over miles
43 Multiple/ single cylinder misfire
44 Battery temp sensor volts out of range
46 Charging system voltage too low
51 Fuel system lean
52 Fuel system rich
53 Internal control failure
54 No Cam signal at PCM
55 End of error messages (If you get this only, no errors were found)
62 PCM failure SRI mile not stored
63 PCM Failure EEPROM write denied
64 Catalytic Converter Efficiency Failure
65 Power steering switch failure

So in your case, you are getting error 3255 right? so you are getting error 32 EGR system failure and 55 which is no other error found.

I hope you get this sorted out.
Have a great day sir.
- HotRatchet

Posted on Jul 27, 2009

Ad
roniecon
  • 6927 Answers

SOURCE: symptoms of bad egr on 95 dodge dakota 318 5.2

when this occurs you need to check fuel pump presure ,see if it is below 20psi or so if it is the fuel pump is trying to go out

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: replaced fuel pump on 1993 dodge dakota but truck

My 93 dakota had some corroded wires for the fuel pump. Broke in half under the cab. Follow the wires from the fuel pump in to the plastic wire wrap. lightly tug on the wires and see if any are loose. That's what fixed mine. Good luck!

Posted on Jul 23, 2009

  • 75 Answers

SOURCE: Headlights sometimes cut out on a 1993 Dodge Dakota pickup

you may have a bad ground wire up by the head lights the ground spot should be with in a foot of one or the head ligghts

Posted on Aug 27, 2009

  • 2 Answers

SOURCE: Windshield wipers don't work but the motor runs . 93 Dodge Dakota

remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed water pump thermostat now I have a check engine light on and the 1993 dodge Dakota stalls and is running rough


You must read the fault code that was stored when the CEL came on. To do this using the blink out method you follow the instructions at the link below. Electrical OBD1 Codes Retrieval Chrysler 1983 1995 vehicles Turbo Dodge...

Mar 02, 2017 | Dodge Cars & Trucks

1 Answer

I have a 1993 dodge dakota with a 3.9L V-6. My question is what do i need to do when the trouble shoot code 41 shows up which means the generator field isn't switching properly?


Chrysler Fault Code 41: Alternator field control circuit open ...

www.allpar.com/fix/codes/faults/code-41.html
Possible reasons for Chrysler fault code 41: Alternator field control circuit open or shorted. ... allpar, the Chrysler - Dodge - Plymouth - Jeep site. Note: Allpar ... FauxPar: Return of the Barracuda, 1987-1996 Dodge Dakota pickup trucks, Pinner: ...

Aug 11, 2015 | 1993 Dodge Dakota

1 Answer

Sometimes it starts sometimes it does not changed the coil no change


You will have to figure out if it is lack of fuel to the injectors or lack of spark when it won't start to know where to look.
Is the check engine light on when it is running ?

Jul 26, 2012 | 1998 Dodge Dakota

1 Answer

92 dodge dakota stalling,running rough,loss of power


Did you replace the fuel filter when you replaced the pump ?
Was it running rough before the pump was replaced.
Did you replace the cap and rotor too ?
"Sucking a ton of air" could be a vac leak, or the sound of the throttle open when the engine is bogging down.
Is the check engine light on when it is running ?

Jul 05, 2012 | Dodge Cars & Trucks

1 Answer

1993 dodge dakota 5.2 v-8, under light throttle it as a surge. Engine rpm's will go up and down a little.


start by cleaning the throttle bore and plate with spray carb cleaner. use a toothbrush and rags to clean it out well. Then clean the IAC valve and its bore. lastly replace the PCV valve. use the rest of the carb cleaner to find any vacuum leaks at hoses and fittings. If problem is still there test or replace TPS.

Check your computer for trouble codes.

Nov 09, 2010 | 1993 Dodge Dakota

1 Answer

Would a motor from a 1997 dodge dakota 3.9 fit in a 1993 dodge dakota that had a 3.9


motor may be same but you need to check if trans were built in same locale ie U.S. or ?use vin numbers and call salvage

Apr 28, 2010 | 1993 Dodge Dakota

1 Answer

How to test a crankshaft on a 1993 Dodge Dakota


check your catalytic converter for clogged up.
disconnect the exhaust pipe before the cat and run the engine to see if it still cut off.
if it run better, then that's the problem

Mar 05, 2010 | 1993 Dodge Dakota

Not finding what you are looking for?

Open Questions:

See all 1993 Dodge Dakota Questions

1993 Dodge Dakota Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...