Question about Cars & Trucks

1 Answer

There is Squealing sound whenever I turn on the AC or reverse on my 2007 Nissan Tiida despite me changing the belt and crankshaft pulley.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 389 Answers

Sounds like it might need to be tightened up a bit,as they do strech out a little.

Posted on Oct 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
m-sykes
  • 71 Answers

SOURCE: Loud squealing sound in my engine

hey

Its possibly the belt!!! did you change that to?

Damien

Posted on Aug 22, 2008

  • 255 Answers

SOURCE: Crankshaft pulley Nissan Pulsar '91 N14

Hi your alternator pulley is hold by a nut about twenty mm, chech it it may be lose......good luck

Posted on Aug 24, 2008

  • 6982 Answers

SOURCE: Loud squealing sound in my engine

Try removing the belt and turning each pulley by hand. If everything is smooth and free, with the belt still off, drive down the block once and see if the noise is there (this will eliminate all rotating accessories on the front). If you hear the noise, then there is a problem deeper inside. Oil pressure is good? Dont' forget when doing this, you will have no power steering, so be careful.

Posted on Jan 17, 2009

phanta7
  • 1 Answer

SOURCE: 96 Nissan maxima -Loud Belt-like noise

try some belt dressing (spray in a can) you can get at any auto part supply,it worked for me  

Posted on Jun 02, 2009

  • 4088 Answers

SOURCE: 1999 dodge durango 5.9 v8 loud squealing noise

You didn't mention the alternator, power steering pump, or water pump. In fact, any pulley other than the crankshaft one can have a bad bearing or dry seal. Remove the belt and spin each pulley while listening for any rough noise or squeal. If it was the crankshaft, it might be time to check the oil. Start the engine with the belt off to see if it does squeal. Make sure the noise isn't coming from the radiator fan(s).

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P1111 code on Nissan TIIDA 2007 Sedan was Diagnosed loosing power when driving.I was told about changing oil and cleaning the Intake Selonade valve.How do i clean it.


Try changing oil first. Intake Valve Timing Control solenoid is located on passenger side of engine bay, with an electrical connection on one end. It's held in by one 10mm bolt. It is inside the cover that goes over the camshaft pulleys. Don't use any oil additives, they can gum up the solenoid as it uses oil pressure to adjust your valve timing. If you remove solenoid, it can be cleaned with throttle body cleaner.
p1111-code-nissan-tiida-2007-sedan-31tyrtuzydbfleqvu5qtsvw1-2-0.jpg

Apr 22, 2015 | 2007 Nissan Tiida 1.6

3 Answers

Screaming noise from ac no cold air


It sounds to me that your belt or tensioner is worn, if the noise goes away when the ac is off then it is just the belt slipping, it takes a lot of power to run the compressor and if the belt is worn it most likely slipping on the pully when you engage the clutch.

Aug 09, 2014 | 2000 Buick LeSabre

1 Answer

Ac pump squealing


Try spraying the pulley with silicon spray, may help if lubed

Jun 17, 2014 | 2007 Jeep Commander Rocky Mountain

1 Answer

Iam getting a delay of a few seconds whenever i shift between neutral and drive or neutral and reverse on my 2007 nissan tiida cvt transmission.


Have the oil changed and the filter checked . I have a Mitsubishi lancer and it is in good nick but If I apply power before the shift happens it chirps the tyres . have the bands and clutch pack adjusted Run fault codes to check for faulty solenoids and servos.

Jan 21, 2014 | 1994 Nissan Altima

1 Answer

AC Squeal


Odd,possibly the AC is overcharged,or a pulley(either tensioner or
PS ) is out of line. Wish I knew what kind of vehicle. Might help.

Mar 24, 2013 | Cars & Trucks

2 Answers

What would cause my ac belt to break on my 97 dodge caravan the pullies move without the belt being attached ,but we did have a big squealing noise when we used the ac..


The squealing is from the crankshaft p[ulley turn the belt on another pulley that is not turning as faster, Let it sqeal long enough and it will burn the belt in half. The pulley on the A/C maybe turning freely, but when you engage the A/C, the compressor itself is not, causing it to squeal. My guess is that the compressor is locking up or you have added to much freon. Having to much freon causes to much pressure buid up and will stop the compressor.

Jul 20, 2011 | Dodge Caravan Cars & Trucks

1 Answer

How to change 1999 nussan quest ac belt


http://groups.yahoo.com/group/villagerquest/

Belt —A/C Removal
  1. Remove the A/C compressor drive belt.
    1. Loosen the A/C compressor drive belt pulley tensioner bolt.
    1. Loosen the A/C compressor drive belt idler pulley adjustment bolt.
40f6b66.gifInstallation
  1. sxv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Incorrect drive belt installation will cause drive belt failure.
    NOTE: Inspect the pulleys for warping or abnormal wear.
    NOTE: Make sure drive belt is properly installed on each pulley.
    To install, reverse the removal procedure.
    • Adjust the A/C compressor drive belt. For additional information, refer to Belt Adjustment—A/C .

Aug 10, 2009 | 1995 Nissan Quest

1 Answer

96 Nissan maxima -Loud Belt-like noise


try some belt dressing (spray in a can) you can get at any auto part supply,it worked for me  

Jun 02, 2009 | 1996 Nissan Maxima

1 Answer

Loud squealing sound in my engine


Try removing the belt and turning each pulley by hand. If everything is smooth and free, with the belt still off, drive down the block once and see if the noise is there (this will eliminate all rotating accessories on the front). If you hear the noise, then there is a problem deeper inside. Oil pressure is good? Dont' forget when doing this, you will have no power steering, so be careful.

Jan 16, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Loud squealing sound in my engine


hey

Its possibly the belt!!! did you change that to?

Damien

Aug 21, 2008 | 2005 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...