Question about 2000 Chevrolet Chevrolet Monte Carlo SS

Open Question

2000 Monte Carlo Blower motor intermittently doesn't work

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2000 monte carlo blower motor works 1 thru 4 5 not working

I had similar problem. There is a small electrical card that is behind the blower motor up into the unit. it is the part that the wires plug into. It has traces on the card that, when you select a speed, will allow current to flow to the motor. The trace that was for the #5 setting had opened up. I had to solder a wire across the trace. got my #5 back. This resistor card shoud be availble at GM dealers if you do not have the know how to fix it.

Mike

Posted on Sep 23, 2009

OneRide
  • 379 Answers

SOURCE: 2000 monte carlo blower switch works on only #5

Not the board. It's you blower motor resistor. It melted.

Posted on Dec 30, 2009

  • 1608 Answers

SOURCE: 2002 monte carlo blower motor doesn't work

Go on the passengers side under the dash you will find the blower motor.You may have to remove the insulator panel to see underneath.Usually a couple of screws or plastic push pins.There`s a connector that goes from the blower motor to the blower resister.The problem is usually the resistor.You will need to check the connector out very carefully because they get hot and melt.If this is the case you need to replace both the resistor and the connector.Most dealerships stock these parts. Hope this helps.Good luck.

Posted on Dec 05, 2011

perkins48
  • 14185 Answers

SOURCE: W2000 Monte Carlo Blower motor intermittently doesn't workhat's your problem?

Bad blower motor resister,it's next to blower motor,2 screws hold it on.http://www.autozone.com/autozone/parts/Duralast-A-C-Heater-Blower-Motor-Resistor/2000-Chevrolet-Monte-Carlo/_/N-jdz8lZ91tag?itemIdentifier=413135_0_0_

Posted on Oct 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Blower for heat only works on high. How to get 1-4 to work?


I agree with Dan.... The blower motor resistor is the problem

Jan 19, 2016 | 2000 Chevrolet Monte Carlo

1 Answer

Blower motor won't shut off on a 2005 chevy monte carlo


Your post is not making sense. If the blower motor wasn't shutting off, how would replacing it cause anything to change? Clearly, there is a problem with the power supply TO the motor. If you want the motor to turn off, you need to check WHY the power to the motor is not cut off when the switch is turned to the off position. Probably a bad switch. Or it could be the blower motor resistor even, albeit a lot less likely.

Feb 24, 2013 | 2005 Chevrolet Monte Carlo

2 Answers

A/C blower and selector doesn't work, overhead console doesn't work


Sounds like this may be the actual control head that went bad, unfortunately there is no way to test for this other than to replace the control head, if the blower motor relay is good, and all the fuses are good, then that would probably be the most likely problem... hope this helps

Sep 08, 2012 | Cars & Trucks

1 Answer

2004 Monte Carlo Heat/AC doesn't work properly.


THE SMALL RESISTOR MOUNTED ON THE SIDE OF THE BLOWER MOTOR UNDER THE DASH.IF THAT FAILS THEN YOU HAVE A BAD CONNECTION AT THE BLOWER MOTOR PLUG.

Jun 11, 2012 | 2004 Chevrolet Monte Carlo

1 Answer

2002 monte carlo blower motor doesn't work


Go on the passengers side under the dash you will find the blower motor.You may have to remove the insulator panel to see underneath.Usually a couple of screws or plastic push pins.There`s a connector that goes from the blower motor to the blower resister.The problem is usually the resistor.You will need to check the connector out very carefully because they get hot and melt.If this is the case you need to replace both the resistor and the connector.Most dealerships stock these parts. Hope this helps.Good luck.

Dec 05, 2011 | 2002 Chevrolet Monte Carlo

1 Answer

2000 monte carlo blower switch works on only #5


Not the board. It's you blower motor resistor. It melted.

Dec 29, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

2006 monti carlo blower motor stuck on high, even


what blower you talking about.if ac blower your blower relay stuck close. your monte carlo has a super charger blower also.

Jul 05, 2009 | 2006 Chevrolet Monte Carlo

2 Answers

Blower fan only works at speed 4 and 5


This is what you are looking for. I've got a similar problem and need to get my blower motor resistor out. I've found the resistor, but it has no bolts holding it in. It has what looks like torx or something similar, but nothing will fit. In fact, they look like they are plastic and possibly stripped out. If you have any luck let me know how you got it out.

10_24_2011_12_06_38_am.jpg

May 22, 2009 | 2001 Chevrolet Monte Carlo

Not finding what you are looking for?
2000 Chevrolet Chevrolet Monte Carlo SS Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...