Question about 2004 Pontiac Grand Prix

2 Answers

Makes a grading noise when i trun right

Sum one help me out and tell me what it could be plz i turn right and makes a matel grinding noise and i dont know what it is

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It could very well be your cv axle if its a metal clinging sound when you turn right

Posted on Jan 29, 2013

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I would look and see if your tire on the front right is rubbing any where mine did that before and my tire was rubbing a plastic cover

Posted on Nov 05, 2012

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wencal1963
  • 153 Answers

SOURCE: my altenator makes a noise

YOU ARE MOST LIKELY GOING TO HAVE REPLACE THE ALTERNATOR OR TAKE IT OFF AND HAVE IT TESTED MAY CAUSE A FIRE.

Posted on Jan 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Power steering is hard to turn at times, fluid is full, is there a belt other then the serpintine??? i dont see one on the power steering pump


does it make noise when turning ? when installing new power steering pump with both front tires in air on jack stands or jacks start and fully steer right fully steer left repeat a couple times and shut off now pump is bled place on ground and test....by turning take a drive....

Mar 19, 2011 | 2002 Dodge Stratus

1 Answer

Grinding noise when making right turns.


CV joint. Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.

Sep 30, 2009 | 2004 Hyundai Elantra

2 Answers

Replaced power steering pump it still makes grinding noise when you make a turn.


Hi

If you have replaced the powersteering pump and this is not a used pump - the problem is suspect within the steering rack itself.

It is important also to check that you have bled all air out of the system when the fluid was replaced. To do this take the lid off the powersteering reservoir tank and turn the steering all the way left and right for 8 turns. Check and top up fluid as necessary.

Also ensure you are using the correct grade of fluid for your vehicle.

If the noise persists after these checks - suspect steering rack at fault.

Hope this helps. Please remember to rate my answer. Thanks.

Jul 24, 2009 | 1988 Mazda B2200

1 Answer

Right headlight not working properly left headlight not working


You have a short in your electrical system or bad ECM.

Jul 05, 2009 | 2000 Pontiac Firebird

4 Answers

04 cavalier makes grinding noise in front end turn the wheel to the right grinding gets worse turn the wheel to the left grinding stops. it sounds worse at 40mph and above. what would cause this?


3 things to check:
Worn disc brake pads, grinding against the rotor.
Wheel bearing
cv joint.
You posted grinding gets worse turning to the right, the problem is the driver side wheel, but it would be best to have both wheeles checked.

Jun 19, 2009 | 2004 Chevrolet Cavalier

1 Answer

I have 91 ford f350 making nosies need help plz help me out


it sounds like the filter might not be the right one....
or the pump isnt priming.....

like "diesel mudder" said previously : was yr tranny in bad shape b4 you changed the fluid and screen?

Feb 25, 2009 | 1991 Ford F350

2 Answers

99 ford windstar hear grinding when wheel turns


Mechanic replaced the rack and pinon that was leaking-that was the noise, air getting into the hose. The engine was a seperate problem and the IMP?? was replaced. The part was cheeper than the labor cost for this one!!

Jul 06, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
2004 Pontiac Grand Prix Logo

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...