Question about Daewoo Cars & Trucks
How to install replacement car antenna on daewoo lanos
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: fuel pump on Daewoo Lanos 1.3
If my memory serves me right the Lanos has an immersed pump, and therefor you need to be looking either under the rear seats or in the luggage compartment for a round metal or plastic cover which when removed will uncover the top of the pump and fuel sender unit.
It is probably held in place by a large plastic or metal ring which either has to be unscrewed or just turned slightly to disengage the securing lugs.
PLEASE DISCONNECT THE BATTERY NEGATIVE TERMINAL BEFORE MESSING WITH THE PUMP OR YOU MAY HAVE AN EARLY FIREWORKS DISPLAY!!!
Just as a matter of interest, I assume when you say FLUIDS you actually mean FLOODS, in which case, the problem isn't the pump.
If the car doesn't start, or struggles to do so, and there is a smell of fuel or the plugs are getting wet, then the problem is more likely to be a lack of spark than anything else.
There are other scenarios, such as a faulty coolant sensor (cold engine), a faulty O2 sensor (hot engine), a faulty throttle position sensor (hot or cold engine), and a few others I could mention.
If you require any further help, just click ASK ME under my strange white round faced picture (which my MRS reckons looks just like me!!) and I shall be more than happy to assist you further.
Posted on Jun 25, 2008
SOURCE: car wont idle
idle stepper motor(IAC) controls idle speed it is located on throttle body
IDLE LEARN PROCEDURE
Whenever the battery cables, the electronic control
module (ECM), or the ECM fuse is disconnected or replaced,
the following idle learn procedure must be performed:
1. Turn the ignition ON for 5 seconds.
2. Turn the ignition OFF for 5 seconds.
3. Turn the ignition ON for 5 seconds.
4. Start the engine in P/N (park/neutral).
5. Allow the engine run until the engine coolant is
above 85_C (185_F).
6. Turn the air conditioning (A/C) ON for 10 seconds, if
7. Turn the A/C OFF for 10 seconds, if equipped.
8. If the vehicle is equipped with an automatic transaxle,
apply the parking brake. While pressing the
brake pedal, place the transaxle in drive (D).
9. Turn the A/C ON for 10 seconds, if equipped.
10. Turn the A/C OFF for 10 seconds, if equipped.
11. Turn the ignition OFF. The idle learn procedure is
Posted on Jul 04, 2009
hi there the problem describe is a common problem you need to take the car into your dawoo/chevrolet dealer as there was a reprogramme that need s to be downloaded to your ecu to fix the problem should only take about 30 mins so should not cost you to much i used to have around 10 to 15 a week to do
Posted on Dec 20, 2009
Tips for a great answer:
Nov 27, 2015 | 2002 Daewoo Lanos
Jun 05, 2009 | 1999 Daewoo Lanos
Feb 15, 2009 | 2000 Daewoo Lanos
115 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: