Question about 2011 Ferrari 458 Italia

Open Question

How to take off farrari 458 door mirrors - 2011 Ferrari 458 Italia

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wing mirrors will not adjust


Wing mirrors have a certain range of electrical adjustment. Manual adjustment by pushing with fingers can make electrical adjustment inoperative. The solution is to make finger adjustment to get back to the electrical range.

May 22, 2016 | Cars & Trucks

1 Answer

How d I swith passenger side mirror on a power mirror on a 2004 Jeep Grand Cherokee limited edition


no symptoms posted (broke glass or ???) can we be on same page?
"how do I switch," verb switch , the mirror as switches inside, too.

please say what that word means. switch and the failure.
1: remove and replace with new.
2: move right to left and left to right side.

why would you do that #2
fold away mirrors/ Export only (this is usa forum so..)
these,NASA grade mirrors are very complex... not just glass and plastic. heaters ,motors, memory , etc.

the FSM cover all tests for the mirror, including scan data.

ill quote the FSM now , 8 steps (just 1 fail,not heat, not memory failure or fold failure)
ONE MIRROR INOPERATIVE
(1) If the one inoperative mirror is on the passenger
side, go to Step 2. If the one inoperative mirror is
on the driver side, go to Step 3.
(2) Check if the passenger front door will lock and
unlock using the power lock switch on the driver side
front door. If OK, go to Step 3. If not OK, go to Step 6.
(3) Disconnect and isolate the battery negative
cable. Remove the trim panel from the front door.
Disconnect the 12-way mirror wire harness connector
from the door wire harness connector.
(4) Using two jumper wires, test the mirror as
shown in the Mirror Test chart (Fig. 2). If the mirror
tests OK, go to Step 5. If the mirror does not test
OK, replace the faulty mirror.
(5) Disconnect the 12-way door wire harness connector
from the door module connector receptacle.
Check all of the circuits of the door wire harness
between the connector for the mirror and the connector
for the door module for opens or shorts. If all of
the circuits are OK, replace the faulty door module.
If any of the circuits are not OK, repair the open or
shorted circuit(s) as required.
(6) Use a DRB scan tool and the proper Diagnostic
Procedures manual to test and repair the faulty Programmable
Communications Interface (PCI) data bus
communication between the two door modules.

(bar stool answer) all cars. mostly
pull door skins
unplug motor conn.
unscrew mirror base from door.
extract mirror,

Mar 07, 2015 | 2004 Jeep Grand Cherokee

1 Answer

Replacement for passager mirror for 2005 pontiac grand prix


Hello,

To replace the mirror of your car all you have to do is follow the process below,

  1. Remove the plastic shards of mirror lens from the mirror shell,
  2. If any of the shards are still stuck to the mirror, pull them off the motor and discard them,
  3. Sweep any small shards out of the shell with a vacuum cleaner,
  4. Place the new mirror lens into the mirror shell, the lens has a small metal bracket on the back of it that fits over the motor.
  5. The tight fit of the mirror in the shell forces the bracket to line up with the motor.
  6. Push the mirror bracket onto the motor by pushing on the center of the mirror lens with your hand. You will feel the bracket snap into place.
But if you want to remove the entire mirror, then you will have to follow the steps below for the DIY process:

  1. To replace the outside mirror, the door panel needs be taken off to get to the retaining nuts and the wiring.
  2. You will need a few common tools, Phillips screwdriver, flat head screwdriver, and a 10mm socket and ratchet. No special tools are required.
  3. Remove the Phillips screws located in the arm rest.
  4. Remove the screw in the door handle.
  5. Remove any screws that may be located around the circumference of the door panel.
  6. Use the common screwdriver and insert it in between the door panel and the door and pry out the trim fasteners around the circumference of the door panel.
  7. These trim fasteners are plastic plugs with serrated edges on the shank and pushed into holes on the door. Once these are removed, lift the bottom of the door panel straight up to unlatch the panel from the top horizontal ledge.
  8. If the vehicle happens to be a Ford, it uses downward facing hooks on the door panel that hook into the door. Simply lift straight up to remove the hooks.
  9. Bring the door panel just far enough to remove the door handle rods if necessary.
  10. Disconnect the power window electrical connectors. Remove the lower door panel's marker light connector.
  11. Disconnect the power outside-mirror electrical connector and then using the 10mm socket, remove the three retaining nuts on the backside of the outside mirror.
  12. Withdraw the mirror and studs from the door.
  13. Install the electrical connector for the new mirror through the opening in the door and line up the studs on the mirror with the holes in the door and push it through.
  14. Install the nuts on the backside. Connect the electrical connector.
  15. Hold the door panel close to the door and connect all the electrical connectors.
  16. Tip the bottom of the door panel outward slightly to attach the top curved surface to the horizontal channel.
  17. Lower the bottom of the door panel and line up the trim fasteners with the holes in the door. Once lined up, push them into the holes to hook the door panel.
  18. Replace all the screws in reverse order of removal.
Take care.

Dec 18, 2010 | 2005 Pontiac Grand Prix

2 Answers

Deeppockets2000@hotmail.com how to remove the driver door mirror on a 2005 pontiac vive.


HAVE TO TAKE DOOR PANEL OFF THE MIRROR IS BOLTED ON AFTER PANEL'S OFF YOU GET TO THEM.

Dec 18, 2010 | Pontiac Vibe Cars & Trucks

1 Answer

How to replace a broken wing mirror on a Volvo S40 1980 model



Power Dr Mirrors Diagnosis & Testing


Removal & Installation
Motor
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Disconnect the negative battery cable. The mirror inside cover trim The door panel The electrical connector to mirror motor The nut attaching mirror assembly to door frame The outside rear view mirror

    0900c152801c11d4.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Removing cover trim and nut
    Removing cover trim and nut

    0900c152801c11d5.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Removing mirrored glass from assembly
    Removing mirrored glass from assembly

  3. Remove the mirror glass:
    1. Fold the mirror glass forwards and inwards as illustrated.
    2. Grasp and pull the mirror glass lengthways until it releases.
    3. Work the glass out.

  4. Remove electric motor:
    1. Remove the 3 screws from behind the mirrored glass.
    2. Separate the connectors
      NOTE Remember the positions of the connectors.
    3. Remove the mirror motor.

      0900c152801c11d6.jpg enlarge_icon.gifenlarge_tooltip.gif

      Fig. Removing connectors and screws holding mirror motor
      Removing connectors and screws holding mirror motor



To install:
  1. Install or connect the following:

    The electric motor The electrical connections The 3 screws that go behind the mirror Install the terminal pins Fold out the mirror mounting on the motor Hook the mirror glass into the inner mounting Press the mirror glass into place. Place mirror in position in door

    0900c152801c11d7.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Reattaching mirror and electric motor connectors
    Reattaching mirror and electric motor connectors

  2. Install or connect the following:

    The nut attaching mirror assembly to door frame The connector The door panel The mirror inside cover trim The negative battery cable

Oct 23, 2010 | 2000 Volvo S40

1 Answer

Wing mirrors damaged


1) Disconnect and isolate the battery negative cable.
(2) Remove the trim panel from the front door.
(3) Disconnect the power mirror wire harness connector from the door wire harness connector.
(4) Remove the mirror flag seal from the inner door panel.
(5) Remove the three nuts that secure the power mirror mounting studs to the door flag.
(6) Remove the power mirror from the outside of the door.

Jan 04, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Ford expedition side mirror (instalation giude)


SECTION 501-09: Rear View Mirrors 2003 Expedition/Navigator Workshop Manual REMOVAL AND INSTALLATION Exterior Mirror Removal and Installation
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
Front Door Trim Panel —Expedition Removal and Installation
NOTE: Left front door shown, right front similar.
  1. Remove the door handle bezel.
    • Use service notch.
  1. Remove the window control switch plate.
    • Use service notch and disconnect the electrical connectors.
  1. s3j~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
    Remove the two bolts and three screws, and remove the door trim panel.
  1. Remove the weather shield.
  1. Disconnect the exterior mirror electrical connector.
  1. Remove the exterior mirror.
    • Remove the nuts.
cf86471.gif
  1. To install, reverse the removal procedure.
    • Install top nut first.
---
Exterior Mirror Motor Removal and Installation
  1. Position the mirror glass to obtain a gap at the top edge of the mirror and carefully pull the top edge of the glass away from the mirror housing.
  1. Disconnect the heated mirror electrical connectors.
  1. Remove the exterior mirror motor screws and exterior mirror motor.
    • Disconnect the electrical connectors.
  1. To install, reverse the removal procedure.

Oct 26, 2009 | 2003 Ford Expedition

2 Answers

I have a 2007 dodge grand caravan. I am replacing


the plug is inside of the mirror housing once you take the old mirror out if you need to plug it after the housing and you replaced the whole mirror the plug is inside the door panel

Aug 28, 2009 | 2007 Dodge Grand Caravan SXT Minivan

1 Answer

1999 Econoline E150 Van mirror replacement


Remove the door handle bezel.Remove the power window/door lock switch bezel.Remove the rearview mirror fastener trim cover.Remove the 4 door trim panel retaining screws.One that was behind the mirror trim cover,behind the switch panel,behind the door handle bezel,and one at the bottom corner.Lift the door trim panel up from the door to disengage the trim panel clips.Remove the front radio speaker. Disconnect the power mirror wiring connector.Remove the 3 bolts to the mirror.

Feb 08, 2009 | Ford E-150 Cars & Trucks

Not finding what you are looking for?
2011 Ferrari 458 Italia Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ferrari Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Ferrari Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...