Question about 2010 Ford E-250

Open Question

2010 Ford E250 having trouble shifting out of park into drive. Obviously locked up and you gotta play with it a bit to shift. May take 2 seconds or two minutes. Any ideas?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: Transmission won't shift properly (2 wd ) speedo does not work

Its weird but I had a fuse blow out awhile back that is the same fuse that works the cab lights when you open the doors. When this fuse went out it also made it shift odd and hard when it did shift. Since it is only intermittent in your case, It may just be a weak fuse.

Posted on Aug 28, 2008

Ad
  • 261 Answers

SOURCE: 97 FORD E250 VAN SHIFT LOCKED IN PARK

check the brake lights to see if they work ithey do then the problem is in the locking mechanism, however if the brake lights sont work then first check the fuse, check the wires and the connector that hooks up to the brake switch under the pedal and if it is dammaged repair as needed and if yo get the lights working yo have made the lock to work also!!

Posted on Nov 14, 2008

chrischronic
  • 235 Answers

SOURCE: 1995 crown vic gear problems/gear shift wont lock

if the shifter is loose and sloppy feeling then the shift cable bracket has come loose under the dash at the steering wheel. remove the lower panel under the steering wheel so you can see under the dash then get flash light and look while jiggling the shifter. you should be able to see the cable and bracket. if the bracket is loose then tighten the bolts. note this bracket is at the steering colum.

Posted on Jan 22, 2009

juggernautxt
  • 145 Answers

SOURCE: my 1997 ford taurus transmission slips when it shifts to second

this is caused by a piston in the transmission that has a crack in it once it warms up the crack seals and operates normally.being cold the crack opens up allowing fluid to flow past it. take to trans shop as soon as you can, will be minimum repair if it has not caused further damage in the transmission.

Posted on Apr 28, 2009

jaysonemanme
  • 500 Answers

SOURCE: 1995 crown vic gear problems/gear shift wont lock

most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW TO UNLOCK YOUR FORD TAURUS GEAR SHIFT


Search Results

    Ford Focus Questions - the car starts up but i cant get it out ...

    www.cargurus.com > Questions > Ford > Focus

    CarGurusJan 26, 2013 - the car starts up but i cant get it out of park the button on the shifterwont ... point the shift interlock will allow you to shift to neutral and other gears with ...That should expose your shift lock over ride button. .... Used Ford Taurus".

    97 Ford Taurus gear shift stuck in park - Car Talk

    community.cartalk.com/.../97-ford-taurus-gear-shift-stuck-in-park
    Feb 7, 2009 - Over the past week, it has been difficult to get the gear out of park. ... 97Ford Taurus gear shift stuck in park ... LOCK, then remove the key. 2.

    Why Wont My Car Shift Out of Park - Shifter Interlock ...

    ? 3:49
    https://www.youtube.com/watch?v=ZdDsfNrabsM
    Mar 21, 2014 - Uploaded by BleepinJeep
    Only problem is if it fails, you cant get your car out of park. ...Those interlocks seem like they might be a solenoid that slides alock pin out so that you can move the lever freely. .... Someone told me it was possibly the Passing gear cable ? ... Ford TaurusWon't Shift Out Of Park, Brake Lights Don't Work With ...

    Car stuck in Park, shifter won't move. - DoItYourself.com ...


Jan 18, 2016 | Ford Cars & Trucks

2 Answers

When I turn the ignition switch to start the vehicle I often cannot shift the stick shift out of Park. If I immediately try to switch gears after starting the engine it usually works but if I leave it more...


ok the safety feature on an auto gearbox is that the gear select has a solinoid lock on the shift & you norm have to start engine first before you can select drive now if the engine is running & not allowing you to select a drive then for some reason the solinoid is losing its signal or going faulty or even the shaft needing a little lube IE: wd40 now my volvo won't even allow me to take the key out untill its in park hope this helps

Aug 16, 2014 | 2008 Ford Escape

1 Answer

Shifter interlock


what car, you never said? NOR YEAR?
park lock out feature;. its broken , they do that. (BTSI system)
got A/T? or M/T both auto and stick shift have lockout.

no car/year, you get the generic answer.
there is a park lockout DEFEATER on most cars, (never on new cars,due to federal bs)

on the shift console, see the defeat device.
the operators guide covers this. its for EMERGENCIES.
pick one.
http://justgivemethedamnmanual.com/jeep/

the A/T box,
Brakes + handle button press, unlocks BTSI

on 2005 and up , no bypass
if the key gets locked too, that tells you what is bad , on newer jeeps
on newer jeeps read this
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?p=366251

this feature (pain) has many failure points.
any cable that jams, there are 2 , one to tranny or ignition
switch. and the brake solenoid unlocker in shift handle.
and the button, to unluck shifter, brake switch (no brake lights/)
to diagnosis it is easy , dismantle the console at shifter
then disconnect cables to find if one is stuck, (easy huh?)
and defeat the solenoid, by hand or 12v applied. and check the button
that it does in fact release.
NOT PARK LOCKOUT: (for if not on flat ground?)
reason 2 , driver, parked on a hill with tire to curb and did so
not setting brakes first (or bad ebrake ) and now the tranny parking
pawl is jammed , opps. so wiggle the steering and wiggle shifter,
or have some one push car forward (parked up hill on right) to release
parking pawl. (or gorilla it, ask bubba to muscle it out of park.)
if down hill , well, you get the idea..... pain.. gotta love A/Ts not.
Folks in Sanfranciso, just roll eyes at you, new in town>?

now the grand cherroke,, why not post car model, and year, dang.

quote 2010 oper guide, get one.
Brake/Transmission Interlock Manual Override Your vehicle may be equipped with a shift lock manual override. The manual override may be used in the event that the shift lever should fail to move from PARK with the ignition switch in the ON position and the brake pedal pressed. To operate the shift lock manual override, perform the following steps: 1. Turn the ignition switch to the ON position without starting the engine. 2. Firmly set the parking brake. 3. Using a flat-bladed screwdriver, carefully remove the shift lock manual override cover, which is located on the PRNDL bezel. 4. Press and maintain firm pressure on the brake pedal. 5. Using the screwdriver, reach into the manual override opening. Press and hold the shift lock lever down. Interlock Manual Override end quote.
no all jeeps have this,

Feb 06, 2014 | Jeep Cars & Trucks

1 Answer

Whenever I shift my 1999 Jeep Cherokee Sport into 4 -wheel drive to get out of a snow/ice packed parking spot (mornings), I have trouble getting it to return to 2-wheel drive. What am I doing wrong? ...


Some vehicle have a spacefic routine you have to go threw to go from 4 to 2. Try it in neutral. or after you shift back into 2 drive in reverse for a bit till it pops back into 2.

Feb 11, 2011 | 1999 Jeep Cherokee

1 Answer

2004 ford e250 trans wont shift to drive


Ford vans are popular for this. Please try these steps
1. Press all the way down on the brake before attempting to shift again 2. Ensure your steering wheel is not locked in place 3. If your situated on a steep drive way, hill, ***** etc, move your truck manually to a flat starting location 4. Your brake safety actuator is going bad and needs to be changed out 5. Rest assure this is something you can do yourself as long as you have the tools and parts

Jan 20, 2011 | 2004 Ford E250

1 Answer

04 e250. small 8cyl. Tranny bangs in and out of gear 35-45mph if i push the gas it changes gear. Also when i stop the Tranny down shifts a second later after i stop. Also when i take off some times i bangs...


Sounds like the Trans Solenoid Pack. Park it, until you fix the issues and hope no internal damage was done.
Do not throw parts at it. Forget the VSS unless you know how to test it.
Check for codes
Changing Fluid,has nothing to do with shift stratagy and never solves trans issues.

Apr 16, 2010 | 2004 Ford E250

1 Answer

My shifter is loose putting it into drive and park.


If this is a 04 f150 on the column ,under the dash at the shift cable there is a bracket on the shift tube, that has 2 torx bit bolts that get loose, tighten the bolts and the concern will be fixed

Apr 07, 2010 | 2004 Ford F150

1 Answer

1995 crown vic gear problems/gear shift wont lock


most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.

May 30, 2009 | 1995 Ford Crown Victoria

1 Answer

97 FORD E250 VAN SHIFT LOCKED IN PARK


check the brake lights to see if they work ithey do then the problem is in the locking mechanism, however if the brake lights sont work then first check the fuse, check the wires and the connector that hooks up to the brake switch under the pedal and if it is dammaged repair as needed and if yo get the lights working yo have made the lock to work also!!

Nov 14, 2008 | Ford E-250 Cars & Trucks

Not finding what you are looking for?
2010 Ford E-250 Logo

Related Topics:

359 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...