Question about 1992 BMW 3 Series

1 Answer

Brake fluid light states low.

Where do you put or check the brake fluid?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 24 Answers

Open your hood and look for a small container (5-6 oz) with fluid inside usually close to the front window of the car. On the top it will say Dot 3 fluid only, or something to that effect. This is where your brake fluid goes in. Fill it within 3/4 inch of the top of the "container". You should also check your brakes. It could be your fluid is low, due to your brakes being worn out. Check both front and rear.

Posted on Jan 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The brake light on my dash stays on, on my 2006 dodge charger


replace the brake light sensor manual will state where it is located

Jan 02, 2017 | Dodge Cars & Trucks

1 Answer

Had my tired rotated, since then my Service ESC light comes on along with the brake "brake fluid" light comes on. I'm not sure if it something serious or i just need to unhook my battery and reset it.


check brake fluid level and make sure no leaks if low fill to proper level and check brakes it low change them as to esc when tires were changed workers may have hit sensor or damaged wiring by front end or a bad sensor sometimes rarely some hhr owners state a hiccup and reset the computer and it was fine but before you do that check and make sure brake system is correct and safe usually brake resets itself when repair or fluid is corrected

Aug 17, 2015 | 2008 Chevrolet Chevrolet HHR LT

1 Answer

Brake light and battery light both on?


If these lights are on even when the vehicle is running, then I would check your battery state of charge. Most parts stores can do this for free, and also check to make sure your brake fluid isn't low. Low brake fluid in the master cylinder reservoir will cause the brake light to come on because there is a fluid level sensor in the reservoir. If the fluid is low, it could mean that you either need brakes, and/or you could have a brake fluid leak. I hope this info helps!

Sep 06, 2014 | 2004 Subaru Forester

1 Answer

Parking brake light is on


The light can come on when the brake fluid is low in the reservoir. Check the brake fluid level and add as necessary using only brake fluid from a sealed container.

If the fluid was low check the brakes. Low fluid can indicate a possible leak in the brake system or worn out brake parts.

Sep 20, 2012 | Toyota Camry Cars & Trucks

2 Answers

I have a 2002 pontiac grand prix. my e-brake light will stay on when the e-brake is not on.


Check your brake fluid level. Low fluid levels will cause the brake light to come on. If the fluid is not low, there could be a problem with the emergency brake light switch or the brake fluid level sensor.

Sep 03, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

My brake light is on


I assum you mean the brake light on the dash. That light will come on if the park brake is set even if its partly set. It will also come on if the brake fluid is low. If the brake fluid is low check for leaks or low brake pads but you have to find out why the brake fluid is low.

Dec 03, 2010 | 1998 Chrysler Cirrus

3 Answers

Where do you put the brake fluid in the engine


You never put brake fluid in the engine, brake fluid only goes in the brake master cylinder, which is on the drivers side under the hood, close to the fire wall, will have a small resivor.

Jul 21, 2010 | 2000 Plymouth Voyager

1 Answer

95 nissan altima brake light on ?


hello, check make sure, emergency brake handle is all the way down, check brake fluid, usually when light comes on you are low on brake fluid, also have front brakes,rear brakes checked out, you may need new brakes on front or rear, make sure there is know brake fluid leaking from your master cyclinder under the hood where you put fluid in brake resivor

Apr 08, 2010 | 1995 Nissan Altima

2 Answers

Brake light on dash


You could either be low on the brake fluid or the pads have worn out..you've got to check em both.

May 12, 2009 | 1995 Nissan Altima

2 Answers

Brake lights stuck on every now and then and front lights


The brake light on the dash or the brake lights on the rear of the car?

If dash then check the brake fluid. Could be when you move forward it moves the fluid enough to make the light come on. So check and top off the fluid. If really low check your front pads.

if rear lights look at the brake peddle to make sure it is firm and not rudding on teh brake light switch.

Mar 30, 2009 | 2000 Ford Focus

Not finding what you are looking for?
1992 BMW 3 Series Logo

Related Topics:

423 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...