Question about Kia Cars & Trucks

Open Question

2007 kia sorento blend door actuator

Photo

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75051 Answers

SOURCE: Blend door not working.

The bleed door controls air temp not where it comes out, dash, floor, defroster, this is most likely a mode control switch problem, that switch is on the ac control head.

Posted on Sep 23, 2008

  • 1 Answer

SOURCE: Blend door

ok first put you front seat down and back raise steering wheel . now lay on you back with you head in the drivers floor board. look up see 2 screws remove them and the panel they hold on . look to left main wire harness needs to be moved to the right , up and behind it is th blend actuator 7/32 socket to remove it then manually turn the white peg , total labor 30 min

Posted on Dec 15, 2008

  • 1 Answer

SOURCE: constant high heat

on climate control press off and heat button and let go quickly. Then press automatic. The display will start rotating eventually displaying a code 025,125 , 024 etc. Then press defrost to stop. You may hear blend door operating atb that time. It worked for my climate control.

Posted on May 06, 2009

warlock61
  • 659 Answers

SOURCE: need to locate blend door actuator 98 lincoln

it is located on top of the heater box assy behind the dash just to the left of of the glovebox if you open the glovebox and look to the left you can see it

Posted on Jul 11, 2009

  • 5 Answers

SOURCE: how to replace blend door actuator in a ford

I recently did mine, I hear you can do it without taking the entire dash apart but I had no luck with it myself. I have to get ready for work but, on mine it was located down and to the left of the radio. its a white box...are you hearing a clicking noise or something? I had to roll the entire dash back and it was still a major pain getting it out.

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kia sportage 2008 v6,I've a problem with AC,In hot weather after 30 mins drive loose conditioned air and hot air start blowing although after switching engine off for may be 20 mins; AC start working


Bad blend door actuator is your cause. You need to disconnect the actuator from the blend door and manually check the blend door. One side of the door switches the heat and one draws air from the ac evaporator.

Jun 06, 2016 | Kia Cars & Trucks

1 Answer

How can you swap the manual climate control to automatic Climat Control?


You will not only need the automatic climate controls, you will need everything to make the system work. The main wiring harness, the electronic control actuators for the blend doors, automatic systems usually have a variable speed blower motor and solid state resistor, the temperature sensor. You would be better off trading your vehicle for one that came from the factory with climate control.

Jul 12, 2014 | 2004 Kia Sorento

1 Answer

Clicking noise passenger side door


Yes it is slipping due to a likely warped ait temperature control blend door. The noise is caused by the tiny motor drive gear drive jumping teeth because it can't move the door.

Mar 26, 2014 | 2004 Kia Sorento

1 Answer

2007 Kia Spectra When switch to hot from cold clicking


Odds are its a blend door actuator problem. The blend doors control air flow thru the heat and ac unit.

Jan 29, 2014 | Cars & Trucks

1 Answer

Blend Door Actuator possibly bad


Not to difficult but you may need to get smaller tools to make it easier or possible depending on the tools you have now.

Jul 18, 2012 | 2004 Kia Sedona

1 Answer

Blend door actuator possibly bad how hard is it to fix or replace?


usually it is in the dash and the glove box needs to be removed to get to the actuator.

Jul 18, 2012 | 2004 Kia Sedona

3 Answers

Driver side blowing hot air passenger side blowing cold air


I'm having the same problem except on mine it's the driver's side that's blowing cold. Do you have the pictures in a finer resolution? I can't make them out and when I zoom, they are too grainy. Does the replacement require removing the dashboard? What's the general cost of the acuators? Are they readily available at like NAPA or other parts stores?

Nov 26, 2011 | 2006 Kia Amanti

2 Answers

JUST GOT A KIA SORENTO AND ITS MAKING A WEIRD BUZZING SOUND FROM THE BACK REAR DOOR. WHEN I LOCK THE DOORS


Most likely its the door lock actuator, they use a plastic gear that is turned by a small motor, that gear is probably starting to strip out.

Apr 29, 2010 | 2005 Kia Sorento

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...